实验目的： 1、掌握EIGRP 的基本配置 2、掌握EIGRP 的通配符掩配置方法 3、掌握EIGRP 的自动汇总特性，理解EIGRP 的自动汇总的缺陷以及如何关闭自动汇总 4、掌握EIGRP 的手工汇总 5、掌握通过ip default-NetWork 命令配置EIGRP 默认网络 6、掌握EIGRP 的手工自动总结的配置方
上传时间： 2013-10-13
上传用户：llwap
RMON（Remote NetWork Monitoring，远程网络监视）主要实现了统计和告警功能，用于网络中管理设备对被管理设备的远程监控和管理。统计功能指的是被管理设备可以按周期或者持续跟踪统计其端口所连接的网段上的各种流量信息，比如某段时间内某网段上收到的报文总数，或收到的超长报文的总数等。告警功能指的是被管理设备能监控指定MIB 变量的值，当该值达到告警阈值时（比如端口速率达到指定值，或者广播报文的比例达到指定值），能自动记录日志、向管理设备发送Trap消息。
标签： RMON
上传时间： 2013-10-11
上传用户：zxh122
This application note provides step-by-step instructions on how to recreate a Tri-Mode Ethernet(TEMAC) performance testing system using the ML405 board and MontaVista Linux 4.0. Thisapplication note shows how to set up a simple EDK Base System Builder system on the ML405Evaluation Platform and run performance tests. The NetWork architecture for the test isdescribed. A system is built and downloaded into the FPGA. A MontaVista Linux kernel isconfigured, built, and downloaded into the ML405 Evaluation Platform. The instructions forobtaining and setting up the software used to perform the measurements, netperf, are given.
上传时间： 2013-11-11
上传用户：saharawalker
The NCV7356 is a physical layer device for a single wire data linkcapable of operating with various Carrier Sense Multiple Accesswith Collision Resolution (CSMA/CR) protocols such as the BoschController Area NetWork (CAN) version 2.0. This serial data linkNetWork is intended for use in applications where high data rate is notrequired and a lower data rate can achieve cost reductions in both thephysical media components and in the microprocessor and/ordedicated logic devices which use the NetWork.The NetWork shall be able to operate in either the normal data ratemode or a high-speed data download mode for assembly line andservice data transfer operations. The high-speed mode is onlyintended to be operational when the bus is attached to an off-boardservice node. This node shall provide temporary bus electrical loadswhich facilitate higher speed operation. Such temporary loads shouldbe removed when not performing download operations.The bit rate for normal communications is typically 33 kbit/s, forhigh-speed transmissions like described above a typical bit rate of83 kbit/s is recommended. The NCV7356 features undervoltagelockout, timeout for faulty blocked input signals, output blankingtime in case of bus ringing and a very low sleep mode current.
上传时间： 2013-10-24
上传用户：s蓝莓汁
EPON主要由三个部分构成，包括光线路终端(OLlj Optical Line Terminal)、光分配网络(ODN，Optical Distribution NetWork)和光网络单元(ONU，Optical NetWork Unit .
上传时间： 2013-11-11
上传用户：JGR2013
在研究传统家用燃气报警器的基础上，以ZigBee协议为平台，构建mesh网状网络实现网络化的智能语音报警系统。由于传感器本身的温度和实际环境温度的影响，传感器标定后采用软件补偿方法。为了减少系统费用，前端节点采用半功能节点设备，路由器和协调器采用全功能节点设备，构建mesh网络所形成的家庭内部报警系统，通过通用的电话接口连接到外部的公用电话网络，启动语音模块进行报警。实验结果表明，在2.4 GHz频率下传输，有墙等障碍物的情况下，节点的传输距离大约为35 m，能够满足家庭需要，且系统工作稳定，但在功耗方面仍需进一步改善。 Abstract: On the basis of studying traditional household gas alarm system, this paper proposed the platform for the ZigBee protocol，and constructed mesh NetWork to achieve NetWork-based intelligent voice alarm system. Because of the sensor temperature and the actual environment temperature, this system design used software compensation after calibrating sensor. In order to reduce system cost, semi-functional node devices were used as front-end node, however, full-function devices were used as routers and coordinator，constructed alarm system within the family by building mesh NetWork，connected to the external public telephone NetWork through the common telephone interface, started the voice alarm module. The results indicate that nodes transmit about 35m in the distance in case of walls and other obstacles by 2.4GHz frequency transmission, this is able to meet family needs and work steadily, but still needs further improvement in power consumption.
上传时间： 2013-10-30
上传用户：swaylong
为满足无线网络技术具有低功耗、节点体积小、网络容量大、网络传输可靠等技术要求，设计了一种以MSP430单片机和CC2420射频收发器组成的无线传感节点。通过分析其节点组成，提出了ZigBee技术中的几种网络拓扑形式，并研究了ZigBee路由算法。针对不同的传输要求形式选用不同的网络拓扑形式可以尽大可能地减少系统成本。同时针对不同网络选用正确的ZigBee路由算法有效地减少了网络能量消耗，提高了系统的可靠性。应用试验表明，采用ZigBee方式通信可以提高传输速率且覆盖范围大，与传统的有线通信方式相比可以节约40%左右的成本。 Abstract: To improve the proposed technical requirements such as low-ower， small nodes， large capacity and reliable NetWork transmission， wireless sensor nodes based on MSP430 MCU and CC2420 RF transceiver were designed. This paper provided NetWork topology of ZigBee technology by analysing the component of the nodes and researched ZigBee routing algorithm. Aiming at different requirements of transmission mode to choose the different NetWork topologies form can most likely reduce the system cost. And aiming at different NetWork to choose the correct ZigBee routing algorithm can effectively reduced the NetWork energy consumption and improved the reliability of the system. Results show that the communication which used ZigBee mode can improve the transmission rate， cover more area and reduce 40% cost compared with traditional wired communications mode.
上传时间： 2013-10-09
上传用户：robter
ZigBee技术是一种应用于短距离范围内，低传输数据速率下的各种电子设备之间的无线通信技术。ZigBee名字来源于蜂群使用的赖以生存和发展的通信方式，蜜蜂通过跳ZigZag形状的舞蹈来通知发现的新食物源的位置、距离和方向等信息，以此作为新一代无线通讯技术的名称。ZigBee过去又称为“HomeRF Lite”、“RF-EasyLink”或“FireFly”无线电技术，目前统一称为ZigBee技术。 2、ZigBee技术的特点 自从马可尼发明无线电以来，无线通信技术一直向着不断提高数据速率和传输距离的方向发展。例如：广域网范围内的第三代移动通信网络（3G）目的在于提供多媒体无线服务，局域网范围内的标准从IEEE802.11的1Mbit/s到IEEE802.11g的54Mbit/s的数据速率。而当前得到广泛研究的ZigBee技术则致力于提供一种廉价的固定、便携或者移动设备使用的极低复杂度、成本和功耗的低速率无线通信技术。这种无线通信技术具有如下特点： 功耗低：工作模式情况下，ZigBee技术传输速率低，传输数据量很小，因此信号的收发时间很短，其次在非工作模式时，ZigBee节点处于休眠模式。设备搜索时延一般为30ms，休眠激活时延为15ms，活动设备信道接入时延为15ms。由于工作时间较短、收发信息功耗较低且采用了休眠模式，使得ZigBee节点非常省电，ZigBee节点的电池工作时间可以长达6个月到2年左右。同时，由于电池时间取决于很多因素，例如：电池种类、容量和应用场合，ZigBee技术在协议上对电池使用也作了优化。对于典型应用，碱性电池可以使用数年，对于某些工作时间和总时间（工作时间+休眠时间）之比小于1%的情况，电池的寿命甚至可以超过10年。 数据传输可靠：ZigBee的媒体接入控制层（MAC层）采用talk-when-ready的碰撞避免机制。在这种完全确认的数据传输机制下，当有数据传送需求时则立刻传送，发送的每个数据包都必须等待接收方的确认信息，并进行确认信息回复，若没有得到确认信息的回复就表示发生了碰撞，将再传一次，采用这种方法可以提高系统信息传输的可靠性。同时为需要固定带宽的通信业务预留了专用时隙，避免了发送数据时的竞争和冲突。同时ZigBee针对时延敏感的应用做了优化，通信时延和休眠状态激活的时延都非常短。 网络容量大：ZigBee低速率、低功耗和短距离传输的特点使它非常适宜支持简单器件。ZigBee定义了两种器件：全功能器件（FFD）和简化功能器件（RFD）。对全功能器件，要求它支持所有的49个基本参数。而对简化功能器件，在最小配置时只要求它支持38个基本参数。一个全功能器件可以与简化功能器件和其他全功能器件通话，可以按3种方式工作，分别为：个域网协调器、协调器或器件。而简化功能器件只能与全功能器件通话，仅用于非常简单的应用。一个ZigBee的网络最多包括有255个ZigBee网路节点，其中一个是主控（Master）设备，其余则是从属（Slave）设备。若是通过网络协调器（NetWork Coordinator），整个网络最多可以支持超过64000个ZigBee网路节点，再加上各个NetWork Coordinator可互相连接，整个ZigBee网络节点的数目将十分可观。 兼容性：ZigBee技术与现有的控制网络标准无缝集成。通过网络协调器（Coordinator）自动建立网络，采用载波侦听/冲突检测（CSMA-CA）方式进行信道接入。为了可靠传递，还提供全握手协议。
标签： zigbee
上传时间： 2013-11-24
上传用户：siguazgb
Agilent AN 154 S-Parameter Design Application Note S参数的设计与应用 The need for new high-frequency, solid-state circuitdesign techniques has been recognized both by microwaveengineers and circuit designers. These engineersare being asked to design solid state circuitsthat will operate at higher and higher frequencies.The development of microwave transistors andAgilent Technologies’ NetWork analysis instrumentationsystems that permit complete NetWork characterizationin the microwave frequency rangehave greatly assisted these engineers in their work.The Agilent Microwave Division’s lab staff hasdeveloped a high frequency circuit design seminarto assist their counterparts in R&D labs throughoutthe world. This seminar has been presentedin a number of locations in the United States andEurope.From the experience gained in presenting this originalseminar, we have developed a four-part videotape, S-Parameter Design Seminar. While the technologyof high frequency circuit design is everchanging, the concepts upon which this technologyhas been built are relatively invariant.The content of the S-Parameter Design Seminar isas follows:
标签： S参数
上传时间： 2013-12-19
上传用户：aa54
Today in many applications such as NetWork switches, routers, multi-computers,and processor-memory interfaces, the ability to integrate hundreds of multi-gigabit I/Os is desired to make better use of the rapidly advancing IC technology.
上传时间： 2013-10-30
上传用户：ysjing
