AN FPGA-BASED IMPLEMENTATION FOR MEDIAN FILTER MEETING THE REAL-TIME REQUIREMENTS OF AUTOMATED VISUAL INSPECTION SYSTEMS
标签： IMPLEMENTATION REQUIREMENTS FPGA-BASED AUTOMATED
上传时间： 2013-12-13
上传用户：litianchu
这是msp430 time b的例程，请查收，接下来还有
上传时间： 2015-12-04
上传用户：bcjtao
μC/OS-II Goals Probably the most important goal of μC/OS-II was to make it backward compatible with μC/OS (at least from an application’s standpoint). A μC/OS port might need to be modified to work with μC/OS-II but at least, the application code should require only minor changes (if any). Also, because μC/OS-II is based on the same core as μC/OS, it is just as reliable. I added conditional compilation to allow you to further reduce the amount of RAM (i.e. data space) needed by μC/OS-II. This is especially useful when you have resource limited products. I also added the feature described in the previous section and cleaned up the code. Where the book is concerned, I wanted to clarify some of the concepts described in the first edition and provide additional explanations about how μC/OS-II works. I had numerous requests about doing a chapter on how to port μC/OS and thus, such a chapter has been included in this book for μC/OS-II.
标签： OS-II compatible important Probably
上传时间： 2013-12-02
上传用户：jkhjkh1982
I wrote this code early this year using ColdFire MCF5213 in codewarrior IDE. The LCD is STN B/W 320x240 dot matrix LCD. The code include 3 different fonts, and basic LCD driver. All original!
标签： this codewarrior ColdFire wrote
上传时间： 2013-12-20
上传用户：皇族传媒
The OpenGPSRec receiver software runs on the real time operating system RTAI-Linux. It compiles with gcc using a RTAI-patched linux kernel. linux下的GPS 开放源码～！
标签： OpenGPSRec RTAI-Linux operating receiver
上传时间： 2016-04-10
上传用户：xc216
μC/OS-II and the Xilinx MicroBlaze
标签： MicroBlaze Xilinx OS-II and
上传时间： 2014-07-31
上传用户：天诚24
完成在S3C2410处理器上移植μC/OS-II内核，然后实现以下多任务： a) 控制实验箱核心板上4盏LED灯轮流亮灭； b) 将LED1连接到ARM9-2410EP增强型实验箱扩展口的DA OUT端口，通过实验箱上的键盘（比如“↑”、“↓”键）控制LED1亮暗变化，同时在超级终端显示该控制值； c) 将LED2连接到扩展口的I/O输出口，通过超级终端按键控制LED2亮灭，即按一下PC的超级终端某个键（比如回车键）LED2灭，再按LED2亮，反复循环。
上传时间： 2016-09-17
上传用户：开怀常笑
μC/OS-II for the LuminaryMicro LM3S8
标签： LuminaryMicro OS-II LM3S8 for
上传时间： 2013-12-22
上传用户：asdfasdfd
uc/os-ii随书源代码,first time, thanks
上传时间： 2017-01-11
上传用户：gengxiaochao
pid control which was used to control the real time system
上传时间： 2014-08-19
上传用户：yan2267246
