The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using SW routines implemented in C. The code is focused onthe SAB C513, but will fit to all C500 derivatives.Beyond the low level software drivers a test shell is delivered. This shell allows a quicktest of the software drivers by an emulator or a starter kit demo board.
上传时间： 2013-11-24
上传用户：363186
基于P87 C591的CAN总线系统智能节点设计Design of CAN System Intelligent Node Based on P87C591 给出了基于带CAN控制器的单片8位微控制器P87C591的智能节点的硬件电路及软件结构，详细介绍了设计中的难点及实现过程中应注意的问题。关键词:CAN总线;智能节点 Abstract:A h ardc ircuita nds oftw arec onfigurationo fth ei ntelligentnode based on a microcontroller with CAN controller P87C591 arepresented.E speciallyt hec ruxi nd esigninga ndt hep roblemst hatshould be paid attention in realizing are discussed in details.Keyw ords:C AN;in telligentn ode CA N 总线 是德国Bosch从20世纪80年代初为解决现代汽车中众多的控制与测试仪器之间的数据交换而开发的一种串行数据通信协议，它是一种多主总线，通信介质可以是双绞线、同轴电缆或光导纤维。由于CAN总线具有较强的纠错能力，支持差分收发，因而适合高噪声环境。并具有较远的传输距离，适用于许多领域的分布式测控系统。目前已在工业自动化、建筑物环境控制、医疗设备等许多领域得到广泛的应用。CAN已成为国际标准化组织IS011898标准。
上传时间： 2013-10-30
上传用户：xymbian
针对使用硬件描述语言进行设计存在的问题，提出一种基于FPGA并采用DSP Builder作为设计工具的数字信号处理器设计方法。并按照Matlab/Simulink/DSP Builder/QuartusⅡ设计流程，设计了一个12阶FIR 低通数字滤波器，通过Quartus 时序仿真及嵌入式逻辑分析仪SignalTapⅡ硬件测试对设计进行了验证。结果表明，所设计的FIR 滤波器功能正确，性能良好。 Abstract: Aiming at the problems in designing DSP using HDL，a method of designing DSP based on FPGA which using DSP Builder as designed tool is pointed out.A 12-order low-pass FIR digital filter was designed according to the process of Matlab/Simulink/DSP Builder/QuartusⅡ, and the design was verified by the timing simulation based on QuartusⅡand practical test based on SignalTapⅡ. The result shows the designed filter is correct in function and good in performance.
上传时间： 2013-11-17
上传用户：lo25643
Accurate measurement of the third order intercept pointfor low distortion IC products such as the LT5514 requirescertain precautions to be observed in the test setup andtesting procedure. The LT5514 linearity performance ishigh enough to push the test equipment and test set-up totheir limits. A method for accurate measurement of thirdorder intermodulation products, IM3, with standard testequipment is outlined below.It is also important to correctly interpret the LT5514specification with respect to ROUT, and the impact ofdemo-board transmission-line termination loss whenevaluating the linearity performance, as explained in theLT5514 Datasheet and in Note 1 of this document.
上传时间： 2013-11-14
上传用户：l254587896
关于NETFLOW信息分析的软件。 is a netflow analyzer. It uses MySQL database to store accounting information. Filters, used in the JFlowAnalyzer, allows very flexible classificate any kind of traffic and store it in the differend fields in database
标签： information accounting analyzer database
上传时间： 2014-01-27
上传用户：kr770906
This book is about the management of business processes. This is certainly not a new topic. Since the beginning of the Industrial Revolution, it has been written about from every possible point of view—economic, sociological, psychological, accountancy, mechanical engineering and business administration. In this book, we examine the management of business processes from the perspective of computing, or—to put it more broadly—of information technology. The reason is that information technology has made huge leaps forward in recent years, resulting in the creation of completely new ways of organizing business processes. The development of generic software packages for managing business processes—so-called workflow management systems (WFMS)—is particularly important in this respect.
标签： This management certainly processes
上传时间： 2013-11-29
上传用户：shus521
zemax源码： This DLL models a standard ZEMAX surface type, either plane, sphere, or conic The surface also demonstrates a user-defined apodization filter The filter is defined as part of the real ray trace, case 5 The filter can be used at the stop to produce x-y Gaussian apodization similar to the Gaussian pupil apodization in ZEMAX but separate in x and y. The amplitude apodization is of the form EXP[-(Gx(x/R)^2 + Gy(y/R)^2)] The transmission is of the form EXP[-2(Gx(x/R)^2 + Gy(y/R)^2)] where x^2 + y^2 = r^2 R = semi-diameter The tranmitted intensity is maximum in the center. T is set to 0 if semi-diameter < 1e-10 to avoid division by zero.
标签： standard surface models either
上传时间： 2013-12-05
上传用户：003030
％CHECKBOUNDS Move the initial point within the (valid) bounds. ％ [X,LB,UB,X,FLAG] = CHECKBOUNDS(X0,LB,UB,nvars) ％ checks that the upper and lower ％ bounds are valid (LB <= UB) and the same length as X (pad with -inf/inf ％ if necessary) warn if too long. Also make LB and UB vectors if not ％ already. ％ Finally, inf in LB or -inf in UB throws an error.
标签： CHECKBOUNDS the initial bounds
上传时间： 2015-10-26
上传用户：caiiicc
The ability to write efficient, high-speed arithmetic routines ultimately depends upon your knowledge of the elements of arithmetic as they exist on a computer. That conclusion and this book are the result of a long and frustrating search for information on writing arithmetic routines for real-time embedded systems. With instruction cycle times coming down and clock rates going up, it would seem that speed is not a problem in writing fast routines. In addition, math coprocessors are becoming more popular and less expensive than ever before and are readily available. These factors make arithmetic easier and faster to use and implement. However, for many of you the systems that you are working on do not include the latest chips or the faster processors. Some of the most widely used microcontrollers used today are not Digital Signal Processors (DSP), but simple eight-bit controllers such as the Intel 8051 or 8048 microprocessors.
标签： arithmetic high-speed ultimately efficient
上传时间： 2014-11-30
上传用户：lizhen9880
Abstract The Lucene Server project is an attempt to extend the Jakarta Lucene tool with server capabilities. Lucene is a robust Java API that enables you creating indexes from text sources and perform powerful searches on these indexes. With Lucene, creating an index must be done programmatically and there are almost no possibilities of integrating index management in a distributed environment. In other words, out of the box, Lucene is suitable for integrating indexing and searching possibilities in a single application but not for providing index/search services for multiple applications. The Lucene Server project comes with a Java API that propose the following make it easy to create indexes in a declarative way by simply providing an XML configuration document. make it easy to personalize the way Lucene must handle different kind of data sources. provide services for index management and searching that can be accessed from several applications. enable batch tasks scheduling.
标签： Lucene Abstract Jakarta project
上传时间： 2016-01-10
上传用户：songrui
