schduler for AVR mcu
上传时间： 2015-07-17
上传用户：zhyiroy
This the code using PIC MCU to control
上传时间： 2015-07-18
上传用户：caixiaoxu26
RS232通信演示程序 目标MCU:MEGA8 晶振:内部(EXT) 8MHZ 作者:dengchongguang 电子牛
标签： dengchongguang MEGA8 8MHZ 232
上传时间： 2013-11-30
上传用户：maizezhen
我使用的是MYSON的MTV412 MCU+MTV048
上传时间： 2013-12-26
上传用户：JIUSHICHEN
h.264白皮书，是从事264研究的原本和必备书。很不错的
上传时间： 2014-11-07
上传用户：jhksyghr
基于VHDL语言开发的mcu与外部器件的接口程序，解决了高速mcu与低速外部器件的接口问题。
上传时间： 2015-07-22
上传用户：xlcky
sd卡 MMC卡 MCU读取方案最完整的资料
上传时间： 2013-12-25
上传用户：lhw888
sd卡 MMC卡 MCU读取源代码（全）
上传时间： 2014-01-07
上传用户：thesk123
PC通过串口控制LCD1602显示!MCU为AVR单片机!
上传时间： 2013-12-12
上传用户：thinode
his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (<=32kHz/4) to be able to program it while it is running on that!
标签： the 20060125 project WinAVR
上传时间： 2014-10-10
上传用户：yan2267246
