To this day, Power over Ethernet (PoE) continues to gainpopularity in today’s networking world. The 12.95Wdelivered to the Powered Device (PD) input supplied bythe Power Sourcing Equipment (PSE) is a universal supply.Each PD provides its own DC/DC conversion from anominal 48V supply, thus eliminating the need for a correctvoltage wall adapter. However, higher power devicescan not take advantage of standard PoE because of itspower limitations, and must rely on a large wall adapteras their primary supply. The new LTC4268-1 breaks thispower barrier by allowing for power of up to 35W for suchpower-hungry 2-pair PoE applications. The LTC4268-1provides a complete solution by integrating a high powerPD interface control with an isolated fl yback controller.
上传时间： 2014-12-24
上传用户：jasson5678
Handheld designers often grapple with ways to de-bounceand control the on/off pushbutton of portable devices.Traditional de-bounce designs use discrete logic, fl ipflops, resistors and capacitors. Other designs includean onboard microprocessor and discrete comparatorswhich continuously consume battery power. For highvoltage multicell battery applications, a high voltageLDO is needed to drive the low voltage devices. All thisextra circuitry not only increases required board spaceand design complexity, but also drains the battery whenthe handheld device is turned off. Linear Technology addressesthis pushbutton interface challenge with a pairof tiny pushbutton controllers.
上传时间： 2013-11-18
上传用户：ZJX5201314
The LTC®4151 is a high side power monitor that includesa 12-bit ADC for measuring current and voltage, as wellas the voltage on an auxiliary input. Data is read throughthe widely used I2C interface. An unusual feature in thisdevice is its 7V to 80V operating range, allowing it to coverapplications from 12V automotive to 48V telecom.
上传时间： 2013-10-29
上传用户：集美慧
锁定放大是微弱信号检测的重要手段。基于相关检测理论，利用开关电容的开关实现锁定放大器中乘法器的功能，提出开关电容和积分器相结合以实现相关检测的方法，并设计出一种锁定放大器。该锁定放大器将微弱信号转化为与之相关的方波，通过后续电路得到正比于被测信号的直流电平，为后续采集处理提供方便。测量数据表明锁定放大器前级可将10-6 A的电流转换为10-1 V的电压，后级通过带通滤波器级联可将信号放大1×105倍。该方法在降低噪声的同时，可对微弱信号进行放大，线性度较高、稳定性较好。 Abstract: Lock-in Amplifying（LIA）is one of important means for weak signal detection. Based on cross-correlation detection theory， switch in the swithched capacitor was used as multiplier of LIA， and a new method of correlation detection was proposed combining swithched capacitor with integrator. A kind of LIA was designed which can convert the weak signal to square-wave， then DC proportional to measured signal was obtained through follow-up conditioning circuit， providing convenience for signal acquisition and processing. The measured data shows that the electric current（10-6 A） can be changed into voltage（10-1 V） by LIA， and the signal is magnified 1×105 times by cascade band-pass filter. The noise is suppressed and the weak signal is amplified. It has the advantages of good linearity and stability.
上传时间： 2013-11-29
上传用户：黑漆漆
差动保护整定范例一： 三圈变压器参数如下表： 变压器容量Se 31500KVA 变压器接线方式 Yn，y，d11 变压器变比Ue 110kV/35kV/10kV 110kV侧TA变比nTA 300/5 35KV侧TA变比nTA 1000/5 10KV侧TA变比nTA 2000/5 TA接线 外部变换方式 一次接线 10kV侧双分支 调压ΔU ±8×1.25% 电流互感器接线系数Kjx 当为Y接线时为1，当为Δ接线时为 区外三相最大短路电流 假设为1000A(此值需根据现场情况计算确定) 计算： 高压侧二次额定电流 中压侧二次额定电流 低压侧二次额定电流
上传时间： 2013-11-01
上传用户：edisonfather
When a system designer specifies a nonisolated dc/dc powermodule, considering the needed input voltage range isequally as important as considering the required performanceattributes and features. Generally, nonisolated moduleshave either a narrow or a wide input voltage range. Narrowinputmodules typically have a nominal input voltage of3.3, 5, or 12 V. For systems that operate from a tightlyregulated input bus—such as those that do not use batterybackup—a narrow-input module is often adequate sincethe input remains fairly stable.Offering greater flexibility, wide-input modules operatewithin a range of 7 to 36 V, which includes the popular12- or 24-V industrial bus. This enables a single module tobe used for generating multiple voltages. These modulesare ideal for industrial controls, HVAC systems, vehicles,medical instrumentation, and other applications that usea loosely regulated distribution bus. In addition, systemspowered by a rectifier/battery charger with lead-acidbattery backup almost always require wide-input modules.System designers who choose power supplies may wantto take a close look at the latest generation of wide-inputdc/dc modules.
标签： Wide-input modules offer dc
上传时间： 2014-12-24
上传用户：dragonhaixm
RSM232P隔离全功能RS-232收发器是一款具备电源隔离、电气隔离的全功能RS-232收发器，使用RSM232P可以提高系统稳定性、简化电路设计。电路完全符合EIA/TIA-232E和ITU-T V.28规格，采用3.3V或5V电源供电，具有2500VDC的隔离电压，波特率可高达115200bps。
上传时间： 2013-10-27
上传用户：qwe1234
符合全球标准的小巧电源•35～150 W容量支持5 V, 12 V和24 V输出电压(100 W, 150 W: 仅24 V型)• 支持DIN导轨安装• 安全标准 ： UL 508/60950-1, EN 60950-1CSA C22.2 No. 60950-1
上传时间： 2014-04-17
上传用户：fklinran
v开关电源拓扑结构综述 v开关电源分类 v非隔离式拓扑举例 BUCK BOOST BUCK-BOOST v隔离式拓扑举例 正激式 反激式
上传时间： 2013-10-12
上传用户：manlian
主要特点：本系列产品采用开关电源，输入AC（85~265）V，输出DC24V正负10%，最大电流1000MA，适用于需要直流24V供电的变送器仪表场合。采用通用卡入式结构。
上传时间： 2013-10-19
上传用户：flg0001
