With the advent of multimedia, digital signal processing (DSP) of sound has emerged from the shadow of bandwidth-limited speech processing. Today, the main appli- cations of audio DSP are high quality audio coding and the digital generation and manipulation of music signals. They share common research topics including percep- tual measurement techniques and analysis/synthesis methods. Smaller but nonetheless very important topics are hearing aids using signal processing technology and hardware architectures for digital signal processing of audio. In all these areas the last decade has seen a significant amount of application oriented research.
标签： multimedia processing the digital
上传时间： 2014-01-23
上传用户：xwd2010
A few short years ago, the applications for video were somewhat confined—analog was used for broadcast and cable television, VCRs, set-top boxes, televisions and camcorders. Since then, there has been a tremendous and rapid conversion to digital video, mostly based on the MPEG-2 video compression standard. Today, in addition to the legacy DV, MPEG-1 and MPEG-2 audio and video com- pression standards, there are three new high- performance video compression standards. These new video codecs offer much higher video compression for a given level of video quality.
标签： applications for confined somewhat
上传时间： 2016-10-29
上传用户：bjgaofei
Top module name : SHIFTER (File name : SHIFTER.v) 2. Input pins: SHIFT [3:0], IN [15:0], SIGN, RIGHT. 3. Output pins: OUT [15:0]. 4. Input signals generated from test pattern are latched in one cycle and are synchronized at clock rising edge. 5. The SHIFT signal describes the shift number. The shift range is 0 to 15. 6. When the signal RIGHT is high, it shifts input data to right. On the other hand, it shifts input data to left. 7. When the signal SIGN is high, the input data is a signed number and it shifts with sign extension. However, the input data is an unsigned number if the signal SIGN is low. 8. You can only use following gates in Table I and need to include the delay information (Tplh, Tphl) in your design.
上传时间： 2013-12-13
上传用户：himbly
Top module name : SHIFTER (File name : SHIFTER.v) 2. Input pins: SHIFT [3:0], IN [15:0], SIGN, RIGHT. 3. Output pins: OUT [15:0]. 4. Input signals generated from test pattern are latched in one cycle and are synchronized at clock rising edge. 5. The SHIFT signal describes the shift number. The shift range is 0 to 15. 6. When the signal RIGHT is high, it shifts input data to right. On the other hand, it shifts input data to left. 7. When the signal SIGN is high, the input data is a signed number and it shifts with sign extension. However, the input data is an unsigned number if the signal SIGN is low. 8. You can only use following gates in Table I and need to include the delay information (Tplh, Tphl) in your design.
上传时间： 2014-01-20
上传用户：三人用菜
The MIPS32® 4KEm™ core from MIPS® Technologies is a member of the MIPS32 4KE™ processor core family. It is a high-performance, low-power, 32-bit MIPS RISC core designed for custom system-on-silicon applications. The core is designed for semiconductor manufacturing companies, ASIC developers, and system OEMs who want to rapidly integrate their own custom logic and peripherals with a high-performance RISC processor. It is highly portable across processes, and can be easily integrated into full system-on-silicon designs, allowing developers to focus their attention on end-user products. The 4KEm core is ideally positioned to support new products for emerging segments of the digital consumer, network, systems, and information management markets, enabling new tailored solutions for embedded applications.
标签： MIPS 8482 Technologies 174
上传时间： 2014-12-22
上传用户：semi1981
The TMS320C54x, TMS320LC54x, and TMS320VC54x fixed-point, digital signal processor (DSP) families (hereafter referred to as the ’54x unless otherwise specified) are based on an advanced modified Harvard architecture that has one program memory bus and three data memory buses. These processors also provide an arithmetic logic unit (ALU) that has a high degree of parallelism, application-specific hardware logic, on-chip memory, and additional on-chip peripherals. These DSP families also provide a highly specialized instruction set, which is the basis of the operational flexibility and speed of these DSPs.
标签： TMS 320 fixed-point processor
上传时间： 2013-12-27
上传用户：宋桃子
MATLAB Code for Optimal Quincunx Filter Bank Design Yi Chen July 17, 2006 This file introduces the MATLAB code that implements the two algorithms (i.e., Algorithms 1 and 2 in [1], or Algorithms 4.1 and 4.2 in [2]) used for the construction of quincunx filter banks with perfect reconstruction, linear phase, high coding gain, certain vanishing moments properties, and good frequency selectivity. The code can be used to design quincunx filter banks with two, three, or four lifting steps. The SeDuMi Matlab toolbox [3] is used to solve the second-order cone programming subproblems in the two algorithms, and must be installed in order for this code to work.
标签： introduces Quincunx Optimal MATLAB
上传时间： 2014-01-15
上传用户：cc1
The TMS320LF240xA and TMS320LC240xA devices, new members of the TMS320C24x generation of digital signal processor (DSP) controllers, are part of the TMS320C2000 platform of fixed-point DSPs. The 240xA devices offer the enhanced TMS320 DSP architectural design of the C2xx core CPU for low-cost, low-power, and high-performance processing capabilities. Several advanced peripherals, optimized for digital motor and motion control applications, have been integrated to provide a true single-chip DSP controller. While code-compatible with the existing C24x DSP controller devices, the 240xA offers increased processing performance (40 MIPS) and a higher level of peripheral integration. See the TMS320x240xA Device Summary section for device-specific features.
标签： TMS 320 generation 240
上传时间： 2013-12-16
上传用户：GavinNeko
Open Flash Chart is a program for creating charts in Flash to display in Web pages. You can create bar, line, area, and pie charts. It also includes server side classes to help generate the data file used as input. At the moment, there are classes for PHP, Perl, .NET, Java, Ruby (and Rails), and Python
标签： Flash creating display program
上传时间： 2014-01-15
上传用户：fandeshun
The SL74HC573 is identical in pinout to the LS/ALS573. The device inputs are compatible with standard CMOS outputs with pullup resistors, they are compatible with LS/ALSTTL outputs. These latches appear transparent to data (i.e., the outputs change asynchronously) when Latch Enable is high. When Latch Enable goes low, data meeting the setup and hold time becomes latched.
标签： compatible The 573 identical
上传时间： 2016-12-29
上传用户：变形金刚
