虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

High-<b>frequency</b>

  • flash 键盘音效取自win2000系统ding.wav

    flash 键盘音效取自win2000系统ding.wav,经过CoolEdit处理成音阶,在Flash中导入在相应按钮上。 没有难度,就是耐心一点,成绩不错哦! 对应表: 低音G-a #G-w A-s #A-e B-d 中音C-f #C-t D-g #D-y E-h F-j #F-i G-k #G-o A-l #A-p B- 高音C-1 D-2 E-3 F-4 G-5 A-6 B-7 C(high)-8 #C-c #D-v #F-b #G-n #A-m

    标签: flash 2000 ding win

    上传时间: 2014-02-06

    上传用户:ljmwh2000

  • High volume USB 2.0 devices will be designed using ASIC technology with embedded USB 2.0 support. F

    High volume USB 2.0 devices will be designed using ASIC technology with embedded USB 2.0 support. For full-speed USB devices the operating frequency was low enough to allow data recovery to be handled in a vendors VHDL code, with the ASIC vendor providing only a simple level translator to meet the USB signaling requirements. Today s gate arrays operate comfortably between 30 and 60 MHz. With USB 2.0 signaling running at hundreds of MHz, the existing design methodology must change.

    标签: technology 2.0 USB designed

    上传时间: 2014-01-02

    上传用户:二驱蚊器

  • High volume USB 2.0 devices will be designed using ASIC technology with embedded USB 2.0 support. F

    High volume USB 2.0 devices will be designed using ASIC technology with embedded USB 2.0 support. For full-speed USB devices the operating frequency was low enough to allow data recovery to be handled in a vendors VHDL code, with the ASIC vendor providing only a simple level translator to meet the USB signaling requirements. Today s gate arrays operate comfortably between 30 and 60 MHz. With USB 2.0 signaling running at hundreds of MHz, the existing design methodology must change.

    标签: technology 2.0 USB designed

    上传时间: 2017-07-05

    上传用户:zhoujunzhen

  • P3.20. Consider an analog signal xa (t) = sin (2πt), 0 ≤t≤ 1. It is sampled at Ts = 0.01, 0.05, and

    P3.20. Consider an analog signal xa (t) = sin (2πt), 0 ≤t≤ 1. It is sampled at Ts = 0.01, 0.05, and 0.1 sec intervals to obtain x(n). b) Reconstruct the analog signal ya (t) from the samples x(n) using the sinc interpolation (use ∆ t = 0.001) and determine the frequency in ya (t) from your plot. (Ignore the end effects.) C) Reconstruct the analog signal ya (t) from the samples x (n) using the cubic spline interpolation and determine the frequency in ya (t) from your plot. (Ignore the end effects.)

    标签: Consider sampled analog signal

    上传时间: 2017-07-12

    上传用户:咔乐坞

  • Image enhancement in frequency domain using Fourier center frequency, Gaussian lowpass filter, Low p

    Image enhancement in frequency domain using Fourier center frequency, Gaussian lowpass filter, Low pass filter, high pass filter. Image restoration using medean filter, weiner filter with noise generator such as Gaussian noise, Salt and Pepper noise

    标签: frequency enhancement Gaussian Fourier

    上传时间: 2017-08-24

    上传用户:xinzhch

  • Fundamentals+of+Telecommunications+1st+ed

    This book is an entry-level text on the technology of telecommunications. It has been crafted with the newcomer in mind. The eighteen chapters of text have been prepared for high-school graduates who understand algebra, logarithms, and basic electrical prin- ciples such as Ohm’s law. However, many users require support in these areas so Appen- dices A and B review the essentials of electricity and mathematics through logarithms.

    标签: Telecommunications Fundamentals 1st of ed

    上传时间: 2020-05-27

    上传用户:shancjb

  • Fundamentals+of+Telecommunications+2nd+ed

    This book is an entry-level text on the technology of telecommunications. It has been crafted with the newcomer in mind. The twenty-one chapters of text have been prepared for high-school graduates who understand algebra, logarithms, and the basic principles of electricity such as Ohm’s law. However, it is appreciated that many readers require support in these areas. Appendices A and B review the essentials of electricity and mathematics up through logarithms. This material was placed in the appendices so as not to distract from the main theme, the technology of telecommunication systems. Another topic that many in the industry find difficult is the use of decibels and derived units. Appendix C provides the reader a basic understanding of decibels and their applications. The only mathematics necessary is an understanding of the powers of ten

    标签: Telecommunications Fundamentals 2nd of ed

    上传时间: 2020-05-27

    上传用户:shancjb

  • AC220V转DC(12V15W )电源板AD设计硬件原理图+PCB文件 2层板设计 大小为100

    AC220V转DC(12V15W )电源板AD设计硬件原理图+PCB文件,2层板设计,大小为100*55mm,   ALTIUM设计的原理图+PCB文件,可以做为你的学习设计参考。主要器件型号如下:Library Component Count : 24Name                Description----------------------------------------------------------------------------------------------------2N3904              NPN General Purpose Amplifier2N3906              PNP General Purpose AmplifierBRIDGE1             Diode BridgeCON2                ConnectorCap                 CapacitorCap Pol1            Polarized Capacitor (Radial)D Zener             Zener DiodeDIODE               Diode 1N914         High Conductance Fast DiodeECELECTRO2            Electrolytic CapacitorFP103               FUSE-HHeader 2            Header, 2-PinINDUCTOR2           NMOS-2              N-Channel Power MOSFETPC837               OptoisolatorRES2-B              Res Varistor        Varistor (Voltage-Sensitive Resistor)T                   TR-2B               TRANS1UCC28051            Volt Reg            Voltage Regulator

    标签: 电源 pcb

    上传时间: 2021-11-21

    上传用户:kent

  • 音响功放测试方法

    說明:1,测试交流电源(Test AC Power Supply):A.中国(China):AC 220V+/-2%50Hz+/-2%B.美国(United States of America):AC 120V+/-2%60Hz+/-2%。C.英国(Britain):AC 240V+/-2%50Hz+/-2%D.欧洲(Europe):AC 230V+/-2%50Hz+/-2%E.日本(Japan):AC 100V+/-2%60Hz+/-2%F.墨西哥(Mexico):AC 127V+/-2%60Hz+/-2%2,测试温度条件(Test Temperature Conditions):25℃+/-2℃。3,测试以右声道为准(Standard Test Use Right Channell)4,信号由AUX插座输入(Signal From AUX Jack Input)。5,测试以音量最大,音调和平衡在中央位置(电子音调在正常状态)。(Test Volume Setup Max,Equalizer And Balance Setup Center)。6,标准輸出(Standard Output):A.输入1 KHz频率信号(Input 1 KHz Frequency Signal)B.左右声道输入信号测试右声道(L&R Input Signal Test Use R Channel)C.额定输出功率満(Rating Output Power Full)10 W,标准输出定为1w.(Rating Output Power Full 10 w,Standard Output Setup 1 W)D.额定输出功率1W到10w,标准输出定为500 mW(Rating Output Power 1 W To 10 W,Standard Output Setup 500 mW)E.额定输出功率小于1w,标准输出定为50 mW(Rating Output Power Not Full 1 W,Standard Output Setup 50 mW)F.标准輸出电压以V-VPR为准(Standard Output Voltage Use V-V/PR)。G.V-V/PR中P为额定输出功率,R为喇叭标称阻抗。

    标签: 音响功放

    上传时间: 2022-06-18

    上传用户:

  • sony CMOS传感器 IMX385LQR-C DataSheet

    DescriptionThe IMX385LQR-C is a diagonal 8.35 mm (Type 1/2) CMOS active pixel type solid-state image sensor with a squarepixel array and 2.13 M effective pixels. This chip operates with analog 3.3 V, digital 1.2 V, and interface 1.8 V triplepower supply, and has low power consumption. High sensitivity, low dark current and no smear are achieved throughthe adoption of R, G and B primary color mosaic filters. This chip features an electronic shutter with variablecharge-integration time.(Applications: Surveillance cameras)

    标签: CMOS传感器 IMX385LQR-C

    上传时间: 2022-06-18

    上传用户: