The LPC2292/2294 microcontrollers are based on a 16/32-bit ARM7TDMI-S CPU with real-time emulation and embedded trace support, together with 256 kB of embedded high-speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at the maximum clock rate. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 pct with minimal performance penalty. With their 144-pin package, low power consumption, various 32-bit timers, 8-channel 10-bit ADC, 2/4 (LPC2294) advanced CAN channels, PWM channels and up to nine external interrupt pins these microcontrollers are particularly suitable for automotive and industrial control applications as well as medical systems and fault-tolerant maintenance buses. The number of available fast GPIOs ranges from 76 (with external memory) through 112 (single-chip). With a wide range of additional serial communications interfaces, they are also suited for communication gateways and protocol converters as well as many other general-purpose applications. Remark: Throughout the data sheet, the term LPC2292/2294 will apply to devices with and without the /00 or /01 suffix. The suffixes /00 and /01 will be used to differentiate from other devices only when necessary.
上传时间： 2014-12-30
上传用户：aysyzxzm
433MHZ无线射频模块方案。另外有315MHZ 470MHZ 2.4GHZ方案资料 更多资料联系董工18610108650 电话联系的免费送
上传时间： 2013-10-31
上传用户：穿着衣服的大卫
电力设备热点温度与电流在线监测预警系统工作在大型变压器旁，极易受电磁辐射干扰，针对该预警系统的子系统：无线传输部分进行了抗电磁干扰设计，采用Ansoft Designer软件仿真分析了PCB（Printed Circuit Board）中电磁波对PCB电磁兼容性产生的影响，根据其得出的PCB的电流图及近场分布图，分析PCB的电磁兼容性，针对结果中的电磁辐射过高区域进行了重新设计，经Ansoft Designer验证，重新设计后的PCB各项指数有所下降，电磁兼容性得到提高。
上传时间： 2013-11-11
上传用户：ggwz258
Radio frequency (RF) can be a complex subject to navigate, but it does not have to be. If you are just getting started with radios or maybe you cannot find that old reference book about antenna aperture, this guide can help. It is intended to provide a basic understanding of RF technology, as well act as a quick reference for those who “know their stuff” but may be looking to brush up on that one niche term that they never quite understood. This document is also a useful reference for Maxim’s products and data sheets, an index to deeper analysis found in our application notes, and a general reference for all things RF.
上传时间： 2013-10-23
上传用户：685
Radio frequency (RF) can be a complex subject to navigate, but it does not have to be. If you are just getting started with radios or maybe you cannot find that old reference book about antenna aperture, this guide can help. It is intended to provide a basic understanding of RF technology, as well act as a quick reference for those who “know their stuff” but may be looking to brush up on that one niche term that they never quite understood. This document is also a useful reference for Maxim’s products and data sheets, an index to deeper analysis found in our application notes, and a general reference for all things RF.
标签： 无线技术
上传时间： 2013-10-08
上传用户：kinochen
The LTC®3207/LTC3207-1 is a 600mA LED/Camera driverwhich illuminates 12 Universal LEDs (ULEDs) and onecamera fl ash LED. The ULEDs are considered universalbecause they may be individually turned on or off, setin general purpose output (GPO) mode, set to blink at aselected on-time and period, or gradate on and off at aselected gradation rate. This device also has an externalenable (ENU) pin that may be used to blink, gradate, orturn on/off the LEDs without using the I2C bus. This may beuseful if the microprocessor is in sleep or standby mode. Ifused properly, these features may save valuable memoryspace, programming time, and reduce the I2C traffi c.
上传时间： 2014-01-04
上传用户：LANCE
The LPC4350/30/20/10 are ARM Cortex-M4 based microcontrollers for embeddedapplications. The ARM Cortex-M4 is a next generation core that offers systemenhancements such as low power consumption, enhanced debug features, and a highlevel of support block integration.The LPC4350/30/20/10 operate at CPU frequencies of up to 150 MHz. The ARMCortex-M4 CPU incorporates a 3-stage pipeline, uses a Harvard architecture withseparate local instruction and data buses as well as a third bus for peripherals, andincludes an internal prefetch unit that supports speculative branching. The ARMCortex-M4 supports single-cycle digital signal processing and SIMD instructions. Ahardware floating-point processor is integrated in the core.The LPC4350/30/20/10 include an ARM Cortex-M0 coprocessor, up to 264 kB of datamemory, advanced configurable peripherals such as the State Configurable Timer (SCT)and the Serial General Purpose I/O (SGPIO) interface, two High-speed USB controllers,Ethernet, LCD, an external memory controller, and multiple digital and analog peripherals
上传时间： 2013-10-28
上传用户：15501536189
This book evolved over the past ten years from a set of lecture notes developed while teaching the undergraduate Algorithms course at Berkeley and U.C. San Diego. Our way of teaching this course evolved tremendously over these years in a number of directions, partly to address our students' background (undeveloped formal skills outside of programming), and partly to reect the maturing of the eld in general, as we have come to see it. The notes increasingly crystallized into a narrative, and we progressively structured the course to emphasize the story line implicit in the progression of the material. As a result, the topics were carefully selected and clustered. No attempt was made to be encyclopedic, and this freed us to include topics traditionally de-emphasized or omitted from most Algorithms books.
标签： Algorithms 算法
上传时间： 2013-11-11
上传用户：JamesB
摘要：采用表面组装技术（surface mountt echnology,SMT）进行印制板级电子电路组装是当代组装技术发展的主流。典型的SMT生产线是由高速机和多功能机串联而成，印制电路板（printed circuit board,PCB）上的元器件在贴片机之间的负荷均衡优化问题是SMT生产调度的关键问题。以使贴片时间与更换吸嘴时间之和最大的工作台生产时间最小化为目标构建了负荷均衡模型，开发了相应的遗传算法，并进行了数值实验与算法评价。与生产时间理论下界和现场机器自带软件调度方案的对比表明了模型及其算法的有效性。关键词：印制电路板；表面组装生产线；负荷分配；生产线优化
上传时间： 2013-10-09
上传用户：亚亚娟娟123
IBIS 模型在做类似板级SI 仿真得到广泛应用。在做仿真的初级阶段，经常对于ibis 模型的描述有些疑问，只知道把模型拿来转换为软件所支持的格式或者直接使用，而对于IBIS 模型里面的数据描述什么都不算很明白，因此下面的一些描述是整理出来的一点对于ibis 的基本理解。在此引用很多presention来描述ibis 内容（有的照抄过来，阿弥陀佛，不要说抄袭，只不过习惯信手拈来说明一些问题），仅此向如muranyi 等ibis 先驱者致敬。本文难免有些错误或者考虑不周，随时欢迎进行讨论并对其进行修改！IBIS 模型的一些基本概念IBIS 这个词是Input/Output buffer information specification 的缩写。本文是基于IBIS ver3.2 所撰写出来（www.eigroup.org/IBIS/可下载到各种版本spec）,ver4.2增加很多新特性，由于在目前设计中没用到不予以讨论。。。在业界经常会把spice 模型描述为transistor model 是因为它描述很多电路细节问题。而把ibis 模型描述为behavioral model 是因为它并不象spice 模型那样描述电路的构成，IBIS 模型描述的只不过是电路的一种外在表现，象个黑匣子一样，输入什么然后就得到输出结果，而不需要了解里面驱动或者接收的电路构成。因此有所谓的garbage in, garbage out，ibis 模型的仿真精度依赖于模型的准确度以及考虑的worse case，因此无论你的模型如何精确而考虑的worse case 不周全或者你考虑的worse case 如何周全而模型不精确，都是得不到较好的仿真精度。
上传时间： 2013-10-16
上传用户：zhouli
