CANopen is a networking system based on the CAN serial bus. CANopen assumes that the device’s hardw
CANopen is a networking system based on the CAN serial bus. CANopen assumes that the device’s hardw...
Bus+Protocol技术资料
资源总数：638
Bus+Protocol全部资料 (638个)
can-bus通用测试软件接口函数库使用手册
can-bus通用测试软件接口函数库使用手册...
linux下的CAN BUS驱动代码。适合在arm平台使用。
linux下的CAN BUS驱动代码。适合在arm平台使用。...
This document describes how to switch to and program the unisersal serial bus (USB) analog phase-lo
This document describes how to switch to and program the unisersal serial bus (USB) analog phase-lo...
The SL11RIDE is a low cost, high speed Universal Serial Bus RISC based Controller board. It contains
The SL11RIDE is a low cost, high speed Universal Serial Bus RISC based Controller board. It contains...
嵌入式系統上 常用 Philips developed Inter-IC bus I2C 之介紹
嵌入式系統上 常用 Philips developed Inter-IC bus I2C 之介紹...
UART RX with simple logic flow to check the protocol correct or not. Important is that the logic flo
UART RX with simple logic flow to check the protocol correct or not. Important is that the logic flo...
Isisns is an extension of Network Simulator (ns) for the IS-IS routing protocol. It is focused on si
Isisns is an extension of Network Simulator (ns) for the IS-IS routing protocol. It is focused on si...
Design of a protoype of an FPGA-based RFID reader supporting the ISO/IEC 18000-6C UHF RFID protocol.
Design of a protoype of an FPGA-based RFID reader supporting the ISO/IEC 18000-6C UHF RFID protocol....
Stantor is a Domotic project. It is a SCADA for the computer interface board K8055 (USB bus), K8000
Stantor is a Domotic project. It is a SCADA for the computer interface board K8055 (USB bus), K8000 ...