PCA9624是一款带I2C总线的8位LED的电压开关优化的LED驱动器，它主要应用于电流为100mA 的红/绿/蓝/琥珀（RGBA）的LED的亮度和闪烁的控制。每个LED输出均有独立的8位分辨率（256个梯度）且输出频率固定为97KHz的PWM控制器它可以在0%到99.6%的范围内对LED的亮度进行调整，使发光二极管被设置为一个特定的亮度值。额外的8位分辨率（256个梯度）PWM控制器组既有固定的190Hz的频率又可以在24Hz和每10.73秒的固定周期内对LED灯亮度从0％至99.6％的范围内调整，使它们保持同样的亮度或闪烁速度。
上传时间： 2013-11-24
上传用户：38553903210
PCA9624是一款带I2C总线的8位LED的电压开关优化的LED驱动器，它主要应用于电流为100mA 的红/绿/蓝/琥珀（RGBA）的LED的亮度和闪烁的控制。每个LED输出均有独立的8位分辨率（256个梯度）且输出频率固定为97KHz的PWM控制器它可以在0%到99.6%的范围内对LED的亮度进行调整，使发光二极管被设置为一个特定的亮度值。额外的8位分辨率（256个梯度）PWM控制器组既有固定的190Hz的频率又可以在24Hz和每10.73秒的固定周期内对LED灯亮度从0％至99.6％的范围内调整，使它们保持同样的亮度或闪烁速度。
上传时间： 2014-12-27
上传用户：zhangliming420
强人写的UCOS_II,V2.52
上传时间： 2013-12-18
上传用户：2218870695
特性及优点• 内嵌FLASH和CAN的低成本器件– S12系列的低端产品– 16-位的性能8-位的价格• 引脚/封装– 48/52 LQFP– 80 QFP, 与B&D 系列引脚兼容– Flash从16K-128K,易于产品升级• 8通道10位AD– 7μsec, 10-bit 单次转换时间, 具有扫描模式
上传时间： 2013-10-28
上传用户：小宝爱考拉
This application note describes how to decode standard DTMF tones using the minimum number of external discrete components and a PIC. The two examples use a PIC which has an 8 bit timer and either a comparator or an ADC, although it can be modified for use on a PIC which has only digital I/O. The Appendices have example code for the 16C662 (with comparator) and 16F877 (using the ADC). As the majority of the Digital Signal Processing is done in software, little is required in the way of external signal conditioning. Software techniques are used to model the individual elements of a DTMF Decoder IC.
上传时间： 2013-11-21
上传用户：zhaoke2005
当今集成电路设计已经进入 SOC 时代，于是各公司针对自己的设计需求挑选一款性价比较高的处理器作为内核是一件非常重要的事情。下面将介绍一款集成了DSP 和MCU 功能的处理器ZSP neo 。ZSP neo 是一类新型的处理器，它在一个的内核中集成了DSP 和MCU 的功能。对于那些需要比现有8 位微控制器更高的控制处理性能，而又无需32 位微控制器的对成本敏感的应用来说，ZSP neo 是一个理想的选择。ZSP neo 针对其性能要求采用了相应的架构：·采用基于 RISC 的架构：处理器具有静态分支预测功能；所以程序员设计程序时无需考虑跳转延时。·采用了 Load-Store 架构：处理器对存储器的操作使用 load 和store 指令；操作不直接发生在存储器中。所有其他指令均为寄存器-寄存器操作；使用寄存器节省了存储器带宽。采用多种load/store 指令，这样优化了存储器操作；同时支持32 位和16 位的数据操作。处理器允许前推的灵活架构；功能单元的结果能够在下个周期无条件地被其他功能单元使用。
上传时间： 2013-10-19
上传用户：奔跑的雪糕
<Almost since the introduction of microcontrollers as electronic components there always has been an oscillatorcircuit on the device to make it work. From application point of view only some external components wererequired to make it work. However, to make sure that it will always work required more effort. This report is basedon feedback from the market from customers applying 8-bit mircrocontrollers.>
标签： oscillators X-tal bit mic
上传时间： 2013-11-12
上传用户：穿着衣服的大卫
The PCA9670 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9670 is a drop-in upgrade for the PCF8574 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(200 mA versus 100 mA) that supports having all 25 mA LEDs on at the same time andmore device addresses (64 versus 8) are available to allow many more devices on the buswithout address conflicts.
上传时间： 2013-10-15
上传用户：stella2015
The PCA9672 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9672 is a drop-in upgrade for the PCF8574 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(200 mA versus 100 mA) that supports having all LEDs on at the same time and moredevice addresses (16 versus 8) are available to allow many more devices on the buswithout address conflicts.
上传时间： 2013-10-23
上传用户：jasonheung
The PCA9674/74A is a drop-in upgrade for the PCF8574/74A providing higher Fast-modePlus I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(200 mA versus 100 mA) that supports having all LEDs on at the same time and moredevice addresses (64 versus 8) are available to allow many more devices on the buswithout address conflicts.
上传时间： 2013-10-22
上传用户：wwwwwen5
