介绍了ATM 技术的特点以及深入分析了PowerPC MPC826o的ATM 步长控制器(APC)的原理，分析了VxW0rks网络模块． 给出了在VxWorks 实时操作系统下的END 模式的ATM 驱动程序设计．重点讨论了ATM 驱动开发中需注意的特殊问题
上传时间： 2013-10-11
上传用户：wwwwwen5
The XL6003 regulator is fixed frequency PWM Boost (step-up) DC/DC converter, capable ofdriving 1050mA load current with excellent line and load regulation. The regulator is simple to use because it includes internal frequency compensation and a fixed-frequency oscillator so that it requires a minimum number of external components to work. The XL6003 could directly drive 5~10 3W LED units at VIN=12V.
上传时间： 2013-11-07
上传用户：xy@1314
PCF8583的工作原理及在单片机接口中的实现:时钟/日历芯片PCF8583是一种实时时钟集成电路，硬件方面介绍了PCF8583的结构、功能厦工作原理；软件方面，因为PCF8583是通过I C总线方式与各种单片机接口的，先介绍了I。C总线的时序，最后采用C51语言对51单片机进行软件编程，实现了对PCF8583芯片的读写，并调试成功，最终完成了串行实时时钟功能。
上传时间： 2013-10-30
上传用户：z240529971
单片机在检测和控制系统中得到广泛的应用，温、湿度则是系统常需要测量、控制和保持的量。文中介绍了一种基于ATA9C51 的单片机的温度和湿度检测与控制的方案,针对被测对象的温度与湿度在不同变化范围需要不同的PID 参数的特点，根据检测温度和湿度自动选择合适的一组PID 参数进行控制的方案，整个设计简明、清晰。
上传时间： 2013-10-30
上传用户：wxnumen
P89C51Rx2xx是具有ISP功能的FLASH单片机，使用ISP功能可以实现在系统中更新应用程序。进入ISP的前提是芯片的向量字为0FCH，这是指明ISP的入口地址为0FC00H。另外还有一个状态字用于指明复位后是运行用户程序还是直接进入ISP，若状态字为0则运行用户程序，否则进入ISP。当状态字为0时，进入ISP需要硬件触发，即PSEN脚接地，复位系统即进入ISP。
上传时间： 2013-10-23
上传用户：透明的心情
PCA9515 是一款采用BiCMOS 工艺的总线中继器，通过它可以扩展I2C 和SMBus 系统。PCA9515 在保持总线操作模式和特性的情况下，通过缓存数据线（SDA）和时钟线（SCL）的数据实现I2C 总线扩展，总线容性负载能力最大为400pF。
上传时间： 2013-11-10
上传用户：asdgfsdfht
The PCA9546A is a quad bidirectional translating switch controlled via the I2C-bus. TheSCL/SDA upstream pair fans out to four downstream pairs, or channels. Any individualSCx/SDx channel or combination of channels can be selected, determined by thecontents of the programmable control register.
上传时间： 2013-11-16
上传用户：cc1915
The PCA9673 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9673 is a drop in upgrade for the PCF8575 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(400 mA versus 100 mA) that supports having all 25 mA LEDs on at the same time andmore device addresses (16 versus 8) are available to allow many more devices on the buswithout address conflicts.
上传时间： 2013-10-29
上传用户：wkchong
关键词 LM3S2016、CTM系列隔离CAN收发器摘 要 基于32位Luminary ARM的CAN节点设计
上传时间： 2013-10-13
上传用户：guanliya
The MAX3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact Discharge)protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides theelectrical interface between an asynchronous communication controller and the serial-port connector. Thiscombination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, orcompatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-Vsupply. In addition, the device includes an always-active noninverting output (ROUT2B), which allowsapplications using the ring indicator to transmit data while the device is powered down. The device operates atdata signaling rates up to 250 kbit/s and a maximum of 30-V/ms driver output slew rate.
标签： MULTICHANNEL 5.5 TO RS
上传时间： 2013-10-19
上传用户：ddddddd
