虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

通信前景

  • 基于ISA总线的计算机与DSP的通信

    在开放式数控系统结构模型的基础上,研究了基于ISA总线的DSP通信控制原理。采用中断方式完成了PC机和DSP之间的通信。介绍了以DriverWorks为工具开发ISA设备WDM驱动程序的方法,探讨了中断处理、驱动程序与应用程序之间的通信,简要说明了驱动程序的安装与调试。通过调试,系统设计运行稳定。 Abstract:  The ISA bus and DSP correspondence control principle is investigated in the basis of the existing open architecture numerical control system.The interrupt method is used to realize the communication between PC and DSP based on the ISA bus.The methods of WDM driver exploitation for ISA device using Driver Works are introduced.The main process of driver program and the keys such as handle interrupt and the communication between the drivers and application are presented.And how to debug and install the drive is explained.

    标签: ISA DSP 总线 计算机

    上传时间: 2013-11-04

    上传用户:kang1923

  • 基于C8051F系列单片机的无线收发电路设计

    基于幅移键控技术ASK(Amplitude-Shift Keying),以C8051F340单片机作为监测终端控制器,C8051F330D单片机作为探测节点控制器,采用半双工的通信方式,通过监控终端和探测节点的无线收发电路,实现数据的双向无线传输。收发电路采用直径为0.8 mm的漆包线自行绕制成圆形空心线圈天线,天线直径为(3.4±0.3)cm。试验表明,探测节点与监测终端的通信距离为24 cm,通过桥接方式,节点收发功率为102 mW时,节点间的通信距离可达20 cm。与传统无线收发模块相比,该无线收发电路在受体积、功耗、成本限制的场合有广阔的应用前景。 Abstract:  Based on ASK technology and with the C8051F340 and C8051F330D MCU as the controller, using half-duplex communication mode, this paper achieves bi-directional data transfer. Transceiver circuit constituted by enameled wire which diameter is 0.8mm and wound into a diameter (3.4±0.3) cm circular hollow coil antenna. Tests show that the communication distance between detection and monitoring of the terminal is 24cm,the distance is up to 20cm between two nodes when using the manner of bridging and the node transceiver power is 102mW. Compared with the conventional wireless transceiver modules, the circuit has wide application prospect in small size, low cost and low power consumption and other characteristics.

    标签: C8051F 单片机 无线收发 电路设计

    上传时间: 2013-10-19

    上传用户:xz85592677

  • 基于MSP430单片机和DS18B20的数字温度计

    为了在工业生产及过程控制中准确测量温度,设计了一种基于低功耗MSP430单片机的数字温度计。整个系统通过单片机MSP430F1121A控制DS18B20读取温度,采用数码管显示,温度传感器DS18B20与单片机之间通过串口进行数据传输。MSP430系列单片机具有超低功耗,且外围的整合性高,DS18B20只需一个端口即可实现数据通信,连接方便。通过多次实验证明,该系统的测试结果与实际环境温度一致,除了具有接口电路简单、测量精度高、误差小、可靠性高等特点外,其低成本、低功耗的特点使其拥有更广阔的应用前景。 Abstract:  In order to obtain accurate measuring temperature in industrial production and process control, a digital thermometer based on MSP430 MCU is designed. The system uses MSP430F1121A MCU to control DS18B20, and gets the temperature data, which is displayed on the LED. The temperature sensor DS18B20 and MCU transmit data through serial communication. MSP430 series has ultra-low power and high integration, DS18B20 only needs one port to achieve data communication. Through many experimental results prove, this system is consistent with actual environment temperature. The system has characteristics of interface circuit simple, high measuring accuracy, minor error, high reliability, besides, the characteristics of low cost and low power make it having vaster application prospect.

    标签: MSP 430 18B B20

    上传时间: 2013-10-16

    上传用户:wettetw

  • 基于VB与单片机的温度测控系统设计

     在现代测控系统中,由于PC机具有强大的数据处理能力和良好的用户交互界面,单片机具有较强的现场抗干扰能力及良好的性价比,因此以PC机为上位机实施用户控制和以单片机为下位机进行实时数据采集的分布式智能化控制系统无疑具有很好的应用前景。本文中单片机实现了温度检测,具有较好的实时性;PC机完成了数据显示、存储及统计分析,绘制了实时温度曲线,并对系统目前所处状况做出了评判。两者之间以串行口进行通信联络

    标签: 单片机 温度测控 系统设计

    上传时间: 2013-11-06

    上传用户:joheace

  • PC机与MCS51单片机串行通信接口电路的设计

    摘要:介绍了采取专用电平转换芯片MAX232实现PC机与MCS51单片机之间的串行通信的方法.通过对系统的通信方式选择89C51通信波特率的设置、通信的设置,以及对接口电路的软件和硬件的设计分析,展示了该电路的实用性.关键词:微处理器;PC机;串行通信;RS-232接口;MAX232芯片

    标签: MCS 51 PC机 单片机串行

    上传时间: 2014-01-22

    上传用户:shizhanincc

  • 基于VB与单片机串行通信的数据采集系统设计

    摘要:设计了基于单片机的罐道倾角数据采集系统,介绍了系统的构成、工作原理和流程图,给出了单片机AT89S52与外围器件的硬件接口电路。使用汇编语言和VisualBasic设计了PC机与单片机间的串行通信程序,并提出了数据趋势曲线的绘制方法。设计的数据采集系统具有易实现、易编程、可移植、体积小、功耗低等优点。关键词:单片机;数据采集系统;罐道倾角;串行通信;VB

    标签: 单片机 串行通信 数据采集 系统设计

    上传时间: 2013-11-19

    上传用户:012345

  • 基于单片机的串行通信

    一、实验目的1.了解串行通信的基本知识;2.掌握用单片机串行口实现串行通信的方法。二、实验器材微机、示波器、万用表、电源、AEDK仿真开发系统,面包板一块,MAX202C芯片一块,电容、电阻、导线若干。三、实验原理此处仅介绍与本实验内容密切相关的串行通信基本知识,其它有关基本知识介绍请见本讲义实验七。

    标签: 单片机 串行通信

    上传时间: 2013-10-17

    上传用户:hongmo

  • 用51单片机控制RTL8029实现以太网通信

    摘要:本文介绍了TCP/IP协议、RTL8029的结构特性以及PCI总线协议的特点,给出了一种用P89C51RD2单片机控制以太网接口芯片RTL80内实现以太网通信的设计方案,阐述了用EMP7128型CPLD实现单片机接口与PCI接口之间的转换,以及TCP/IP协议的实砚关键词:RTL8029,PCI总线,TCP/IP

    标签: 8029 RTL 51单片机 控制

    上传时间: 2013-11-14

    上传用户:thinode

  • AT89S51单片机学习板串行通信实验讲义--STK-070

    计算机的串行口与控制 单片机串行口除用作单片机之间串行通信的通道外,还能和普通计算机的RS-232口(串口)进行通信。 这是单片机的一大特色,使得它在通信与控制领域得到广泛的应用。 本部分从一些基础的RS-232标准谈起,并结合一些串口基础实验加深对知识的理解。最后,讲解如何用Visual Basic语言编写一个简单的串口通信程序。

    标签: 070 89S S51 STK

    上传时间: 2014-01-12

    上传用户:siguazgb

  • 键盘接口在单片机系统与PC机通信中的应用

    摘要:提出一种全新的利用键盘接口实现单片机系统和PC机通信的方案,介绍了键盘与PC机通信的原理,并成功地应用于实际系统。该方案为外部单片机系统与3-机通信提供了一条有效的途径。关键词:键盘接口  单片机系统  时序  命令字

    标签: 键盘接口 单片机系统 PC机通信 中的应用

    上传时间: 2013-11-03

    上传用户:drink!