以C8051F020为核心处理器，设计无线传感器网络数据采集系统。系统采用SZ05-ADV型无线通讯模块组建Zigbee无线网络，结合嵌入式系统的软硬件技术，完成终端节点的8路传感器信号的数据采集。现场8路信号通过前端处理后，分别送入C8051F020的12位A/D转换器进行转换。经过精确处理、存储后的现场数据，通过Zigbee无线网络传送到上位机，系统可达到汽车试验中无线测试的目的。 Abstract: This paper designs a wireless sensor network system for data acquisition with C8051F020 as core processors.The system used SZ05-ADV wireless communication module，set up a Zigbee wireless network， combined with hardware and software technologies of embedded systems，completed the end-node 8-locale sensor signal data acquisition.Eight locale signals were sent separately into the 12-bit ADC of C8051F020 for conversion through front treatment.After accurate processing and storage，the locale data was transmitted to the host computer through Zigbee wireless.The system achieves the purpose of wireless testing in vehicle trial.
标签： C8051F020 Zigbee 汽车测试 系统设计
上传时间： 2013-11-23
上传用户：dsgkjgkjg
针对视频监控中摄像机镜头光圈大小、图像聚焦、图像变焦三项参数的控制问题，介绍了一种基于89C51单片机的镜头控制电路的设计。 该电路以89C51单片机为核心，结构简单，成本低廉，控制可靠，实现了智能监控终端对摄像参数的完全控制。 Abstract: The design of camera lens control circuit based on 89C51 is introduced. This circuit can adjust parameters of camera such as aperture, zoom and focusing. The practice of project shows that this circuit has advantages of structure simple, low cost and high reliability.
上传时间： 2013-10-29
上传用户：Wwill
基于幅移键控技术ASK（Amplitude-Shift Keying），以C8051F340单片机作为监测终端控制器，C8051F330D单片机作为探测节点控制器，采用半双工的通信方式，通过监控终端和探测节点的无线收发电路，实现数据的双向无线传输。收发电路采用直径为0.8 mm的漆包线自行绕制成圆形空心线圈天线，天线直径为（3.4±0.3）cm。试验表明，探测节点与监测终端的通信距离为24 cm，通过桥接方式，节点收发功率为102 mW时，节点间的通信距离可达20 cm。与传统无线收发模块相比，该无线收发电路在受体积、功耗、成本限制的场合有广阔的应用前景。 Abstract: Based on ASK technology and with the C8051F340 and C8051F330D MCU as the controller， using half-duplex communication mode， this paper achieves bi-directional data transfer. Transceiver circuit constituted by enameled wire which diameter is 0.8mm and wound into a diameter （3.4±0.3） cm circular hollow coil antenna. Tests show that the communication distance between detection and monitoring of the terminal is 24cm，the distance is up to 20cm between two nodes when using the manner of bridging and the node transceiver power is 102mW. Compared with the conventional wireless transceiver modules， the circuit has wide application prospect in small size， low cost and low power consumption and other characteristics.
上传时间： 2013-10-19
上传用户：xz85592677
为解决输油管道温度压力参数实时监测的问题，设计了以C8051F930单片机作为控制核心的超低功耗输油管道温度压力远程监测系统。现场仪表使用高精度电桥采集数据，通过433 MHz短距离无线通信网络与远程终端RTU进行通信，RTU通过GPRS网络与PC上位机进行远程数据传输，在上位机中实现数据存储和图形化界面显示，从而实现输油管道温度压力参数的实时监测和异常报警。经实验证明，该系统的12位数据采集精度满足设计要求，漏码率小于1%，正常工作时间超过5个月，能实时有效地监测输油管道的温度压力参数，节省大量人工成本，有效预防管道参数异常造成的经济损失和环境污染。 Abstract: In order to solve the problems on real-time monitoring of pipeline temperature and pressure parameters， the ultra-low power remote pipeline temperature and pressure monitoring system was designed by using the single chip processor C8051F930 as the control core. The high-precision electric bridge was used in field instruments for data collection， the 433MHz short-range wireless communication network was used to make communication between field instrument and RTU， the GPRS was used by the RTU to transmit data to the PC host computer， and the data was stored and displayed in the PC host computer， so the real-time monitoring and exception alerts of pipeline temperature and pressure parameters were achieved. The experiment proves that the system of which error rate is less than 1% over five months working with the 12-bit data acquisition accuracy can effectively monitor the pipeline temperature and pressure parameters in real time， it saves a lot of labor costs and effectively prevents environmental pollution and economic losses caused by abnormal channel parameters.
上传时间： 2013-11-07
上传用户：cuibaigao
针对船舶气象仪保障维修而设计的船舶气象仪测试系统，包括信息处理终端、主仪器检测模块、传感器检测模块，各个模块都采用基于AVR单片机的嵌入式系统，模块之间通过CAN总线进行通信。结果表明，船舶气象仪测试系统能够快速检测船舶气象仪故障，与单纯依靠人工方式排查故障相比，故障检测时间缩短了60%以上。 Abstract: The test system of ship meteorological instrument was developed to satisfy the maintenance of ship meteorological instruments，which composed of information processing terminal， testing module of main instrument and testing module of sensors. Each of these modules included an embedded system based on microcontroller of AVR series and communicated with other module by CAN bus. The results show that the test system can judge the fault of ship meteorological instrument quickly and shorten the fault detection time as much as 60% compared with simple manual troubleshooting.
上传时间： 2013-11-23
上传用户：stvnash
电路图非常简单，主要的问题不在于电路，电路用一上午的时间就都搞定了，剩下的就是程序问题。为了美观要达到的目的是LED灯要不断地闪烁，同时这LED中P2口控制的都是绿色的，P1口控制的都是红色的，这样就容易编程了。起初在主函数中直接对LED灯控制并且检测HS0038的电位变化但是始终检测不到，后来发现延时太长在延时的过程中掩盖了对HS0038的检测。所以缩小延时，但是无论怎么减小对于检测的时间来讲都是太大的。最后想到了用单片机的外部中断的功能，所以将HS0038的OUT接到P3.3口用外部中断1 将检测放在终端函数中最后解决了问题，实现检测和LED闪烁的功能。
上传时间： 2013-10-18
上传用户：stewart·
摘要:介绍一种基于单片机的温室温度自动控制系统。热敏电阻采集温室内的温度,单片机控制温度在液晶屏上实时显示,利用上位机进行实时监控,通过串行通信将采集到的数据送至上位机,应用系统自带的超级终端软件实现温室温度在上位机中的实时显示。关键词:P89V51RD2单片机;温度检测;液晶显示器
上传时间： 2014-12-27
上传用户：拔丝土豆
设计了一种由AT89C51和nRF401模块所构成的矿山中的信号采集和控制系统。采集的信号为温度、湿度、甲烷浓度。分别介绍了各个信号采集模块的电路图，并给出了系统的硬件原理图和软件设计方案。实验结果表明：现场指定点的信号能准确的传输到控制终端并在显示器上显示。信号超出上下限时会发出报警信号，从而对现场进行有效地控制。
上传时间： 2013-10-10
上传用户：cuiyashuo
采用RISC结构型单片机Atmega128作为微处理器，320×240点阵大屏幕液晶显示器，全中文界面，读数直观，测量迅速，可在规程要求的测量点自动进行测量。模拟线路采用电位差式测量原理，具有较高的抗电磁干扰能力和较好的稳定性，结合微处理器技术及系统的引入，使该产品成为高智能化数字测量仪器。本产品执行标准及检定规格：《JJG169-93互感器校验仪检定规程》、《JJG313-94测量用电流互感器检定规程》、《GB1208-1997电流互感器》、《DL/T668-1999测量用互感器检验装置》、《DL/T448-2000电能计量装置技术管理规程》，测量对象为0.5级及以下精度电流互感器。
上传时间： 2013-11-11
上传用户：ginani
摘要：介绍一种以单片机AT89S52为核心的多功能出租车计价器的设计，阐述软硬件设计过程中关键技术的处理。仿真结果表明该计价器具有集计程、计时、计费、存储、查看、统计等多种计量功能，并且具有超速提醒、防止司机作弊、语音、打印和显示等多种功能。与已有的系统相比，该系统具有超速提醒等更强的功能。关键词：出租车计价器；多功能；AT89C52；软硬件设计
上传时间： 2014-12-27
上传用户：lanhuaying
