虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

无线参数

  • 无线遥控模块(单片机)

    无线遥控模块(单片机)

    标签: 无线遥控 单片机 模块

    上传时间: 2013-10-13

    上传用户:netwolf

  • 基于单总线式无线温度采集系统设计

    为提高温度测量效率,降低系统的成本,扩展传输距离,设计出一种新型温度采集系统。单片机通过控制具有单总线方式的温度传感器DS18B20实现对温度的测量,同时单片机通过控制具有单总线方式300~450MHz频率范围内的MAX7044与MAX7033无线发射与接收芯片实现温度数据的无线传输。与传统温度采集系统相比,该系统利用单总线方式连接,采用无线传输方式实现远距离通信,易于系统的集成与扩展。实验结果表明,该系统结构简单、方便移植,能够同时实现多达上百点温度的测量与500m范围的传输。 Abstract:  To improve the temperature measurement efficiency and reduce system cost,expansion of transmission distance,a new type of temperature acquisition system is designed.Microcontroller controlled temperature sensor DS18B20which has a single-bus achieves temperature measurement,while microcontroller by controlled the MAX7044and MAX7033chip with a single-bus and having300~450MHz radiofrequency to achieve the wireless transmission of temperature data.Compared with conventional temperature acquisition system,the system uses single-bus connected,and uses wireless transmission means to achieve long-distance communications,easy-to-system integration and expansion.The experimental results show that the system is simple,convenient transplantation,and can be implemented in as many as a hundred-point temperature measure-ment and the transmission range of500meters.

    标签: 单总线 无线温度 采集 系统设计

    上传时间: 2013-10-29

    上传用户:515414293

  • 基于51单片机的无线识别装置系统

    介绍一种简单射频识别系统设计。该设计包括阅读器、应答器和线圈3部分。由单片机控制阅读器向应答器发射无线信号,并接收应答器回送的信号,再通过分析回送信号识别物品。阅读器和应答器之间以半双工通信方式通信。 Abstract:  A simple design of radio frequency identification system is given in this paper.The design includes reader,responder and winding.Through MCU,signals are sent to responder from reader,then corresponding signals are sent back. According to the analysis of the signals sent back,the objects can be identified.Half-duplex communication is adopted? between? reader? and? responder.

    标签: 51单片机 无线识别 装置

    上传时间: 2013-10-11

    上传用户:plsee

  • 基于C8051F005单片机的参数测试仪的设计

    介绍了基于单片机航空交流电参数测试仪的系统设计。以Silicon Labs公司的C8051F005单片机为核心设计出数据采集板,通过RS-232串口与上位机通讯。运用Lab Windows/CVI编写的上位机软件实现信号的检测以及波形和数据的显示,给出了测试仪硬件电路的组成和软件流程图。本系统具有硬件结构简单、容易实现和成本低等特点,在实际应用中其稳定性、精确性均能满足客户要求。 Abstract:  The design of aeronautics AC parameters tester based on the single-chip is introduced.The core component of data acquisition board is C8051F005 single chip of Silicon Labs Company,and communication with PC through RS-232. The signal processing software programmed with LabWindows/CVI can be used successfully to fulfill inspection of signal and display of the waveform and data. The hardware and software configuration of test instrument are provided.The hardware of the system is simple, and can be easily realized.The stability and precision of the measurement instrument are enough to meet the requirements.

    标签: C8051F005 单片机 仪的设计 参数测试

    上传时间: 2013-11-18

    上传用户:wang5829

  • 基于C8051F系列单片机的无线收发电路设计

    基于幅移键控技术ASK(Amplitude-Shift Keying),以C8051F340单片机作为监测终端控制器,C8051F330D单片机作为探测节点控制器,采用半双工的通信方式,通过监控终端和探测节点的无线收发电路,实现数据的双向无线传输。收发电路采用直径为0.8 mm的漆包线自行绕制成圆形空心线圈天线,天线直径为(3.4±0.3)cm。试验表明,探测节点与监测终端的通信距离为24 cm,通过桥接方式,节点收发功率为102 mW时,节点间的通信距离可达20 cm。与传统无线收发模块相比,该无线收发电路在受体积、功耗、成本限制的场合有广阔的应用前景。 Abstract:  Based on ASK technology and with the C8051F340 and C8051F330D MCU as the controller, using half-duplex communication mode, this paper achieves bi-directional data transfer. Transceiver circuit constituted by enameled wire which diameter is 0.8mm and wound into a diameter (3.4±0.3) cm circular hollow coil antenna. Tests show that the communication distance between detection and monitoring of the terminal is 24cm,the distance is up to 20cm between two nodes when using the manner of bridging and the node transceiver power is 102mW. Compared with the conventional wireless transceiver modules, the circuit has wide application prospect in small size, low cost and low power consumption and other characteristics.

    标签: C8051F 单片机 无线收发 电路设计

    上传时间: 2013-10-19

    上传用户:xz85592677

  • 基于C8051F930的管道温度压力远程监测系统

       为解决输油管道温度压力参数实时监测的问题,设计了以C8051F930单片机作为控制核心的超低功耗输油管道温度压力远程监测系统。现场仪表使用高精度电桥采集数据,通过433 MHz短距离无线通信网络与远程终端RTU进行通信,RTU通过GPRS网络与PC上位机进行远程数据传输,在上位机中实现数据存储和图形化界面显示,从而实现输油管道温度压力参数的实时监测和异常报警。经实验证明,该系统的12位数据采集精度满足设计要求,漏码率小于1%,正常工作时间超过5个月,能实时有效地监测输油管道的温度压力参数,节省大量人工成本,有效预防管道参数异常造成的经济损失和环境污染。 Abstract:  In order to solve the problems on real-time monitoring of pipeline temperature and pressure parameters, the ultra-low power remote pipeline temperature and pressure monitoring system was designed by using the single chip processor C8051F930 as the control core. The high-precision electric bridge was used in field instruments for data collection, the 433MHz short-range wireless communication network was used to make communication between field instrument and RTU, the GPRS was used by the RTU to transmit data to the PC host computer, and the data was stored and displayed in the PC host computer, so the real-time monitoring and exception alerts of pipeline temperature and pressure parameters were achieved. The experiment proves that the system of which error rate is less than 1% over five months working with the 12-bit data acquisition accuracy can effectively monitor the pipeline temperature and pressure parameters in real time, it saves a lot of labor costs and effectively prevents environmental pollution and economic losses caused by abnormal channel parameters.

    标签: C8051F930 温度 压力 远程监测系统

    上传时间: 2013-11-07

    上传用户:cuibaigao

  • 利用STC89C55RD+单片机实现无线LED点阵显示系统

    摘要:利用STC89C55RD+的在应用可编程功能和射频芯片nRF401,设计了一个无线数据通信方式下的LED点阵显示系统。该系统采用了上一下位机的结构构建,利用无线收发模块实现显示信息及控制命令的发送,并且充分利用了该单片机大容量的数据Flash区,通过在应用可编程功能实现多条信息的实时发布、擦除和修改。关键词:单片机,在应用可编程,无线,点阵

    标签: STC LED 89 55

    上传时间: 2013-11-03

    上传用户:zjwangyichao

  • 单片机和工业无线网络

    摘要:本文详细探讨了单片机在工业无线网络中的具体应用。关键词:单片机(MCU);工业无线网络;ZIGBEE;SOC

    标签: 单片机 工业无线网络

    上传时间: 2013-12-24

    上传用户:qijian11056

  • 基于ATmega8515L的舞蹈机器人控制系统设计与研究

    娱乐 机 器 人作为机器人的一个重要分支,已经发展为一种产业。舞蹈机器人是娱乐机器人的一种,它集软件和硬件于一身,而控制系统是机器人的核心,在机器人中发挥着重要的作用。本 文针 对 舞蹈机器人控制系统的设计过程,主要研究其硬件电路设计、软件程序设计和关键算法。在分 析 了 机器人性能要求和相关控制方法的基础上,提出了基于上下位机的控制结构,通过无线通信方式传输数据和指令,从而实现机器人的遥控。硬 件 设 计过程中,以提高集成度、减小体积、提高性价比为设计原则,将各部分电路按照功能划分。利用无线通讯模块,实现上下位机之间的远程通信;通过端口扩展,解决I/0资源紧张问题:采用CPLD对机器人驱动轮的脉冲进行反馈检测,并加上四倍频环节,提高了检测精度;通过工2C总线扩展存储器,满足存放大量舞蹈动作数据的要求。软 件 设 计过程中,采用模块化的设计方法。在上位机设计友好的人机界面,以方便用户设置控制参数和指令,实现舞蹈动作的可视化编辑。机器人行走过程中,采取数字PID算法,通过闭环反馈控制,实现机器人行走路径的准确定位,并结合同步补偿算法,可较好的解决机器人的直线行走问题。为 了 使 机器人的舞蹈动作更好地表现音乐的内涵,提出一种基干音乐特征识别的策略,在音乐特征识别的基础上结合专家系统、模糊控制等智能手段,通过舞蹈动作与音乐的自动匹配、同步演示等方法,从而最终实现舞蹈动作与音乐协调一致。

    标签: ATmega 8515L 8515 舞蹈机器人

    上传时间: 2013-10-14

    上传用户:macarco

  • 基于NRF9E5射频无线遥控系统的设计

    介绍了一种基于8051内核的无线射频传输芯片nRF9E5,采用该芯片制作了扑翼微型飞行器的遥控系统,对遥控系统的收发装置进行了硬件设计,并对设计出的硬件系统进行了软件编程和系统的调试,实验表明,该系统具有成本少、功耗低、尺寸小的特点,能以较高质量在100~150米范围内进行信号的无线传输。

    标签: NRF9E5 射频 无线遥控系统

    上传时间: 2013-11-17

    上传用户:1234xhb