由热电偶的测温原理可知，热电偶产生的热电势与热端（又称测量端）、参比端（又称冷端）的热电势有关，只有参比端温度t1 为零或恒定不变，热电势才是热端温度的单值函数（见图1）。如果不补偿的话，则热电偶的参比端温度与仪表接线端温度t2间的温差t1-t2越大，测量误差也越大。由于大多数热电偶的热电势与温度的关系近似线性，所以造成的测量误差大致等于上述温差。以K 分度号的镍铬-镍硅热电偶为例，当t1=50℃，t2=20℃时，如热端温度为1000℃，则显示温度仅969℃，误差达31℃。
上传时间： 2013-10-15
上传用户：哈哈hah
内含测距底板原理图及datasheet、超声波p89lpc932a1fdh电平触发测距，超声波测温测距三合一，超声波测距程序C51等待，反正很全了。
标签： 超声波测距
上传时间： 2013-11-13
上传用户：heheh
按键可调测温报警
上传时间： 2013-10-11
上传用户：黄酒配奶茶
基于51单片机的测温
上传时间： 2014-12-24
上传用户：
DS1302时钟，18b20测温，单片机控制，keil仿真程序，proteus仿真通过
上传时间： 2013-11-14
上传用户：wweqas
多点测温
上传时间： 2013-10-26
上传用户：wushengwu
a_bit equ 20h ;个位数存放处 b_bit equ 21h ;十位数存放处 temp equ 22h ;计数器寄存器 star: mov temp,#0 ;初始化计数器 stlop: acall display inc temp mov a,temp cjne a,#100,next ;=100重来 mov temp,#0 next: ljmp stlop ;显示子程序 display: mov a,temp ;将temp中的十六进制数转换成10进制 mov b,#10 ;10进制/10=10进制 div ab mov b_bit,a ;十位在a mov a_bit,b ;个位在b mov dptr,#numtab ;指定查表启始地址 mov r0,#4 dpl1: mov r1,#250 ;显示1000次 dplop: mov a,a_bit ;取个位数 MOVC A,@A+DPTR ;查个位数的7段代码 mov p0,a ;送出个位的7段代码
上传时间： 2013-11-06
上传用户：lx9076
设计了一种基于PIC16C71单片机的数字水温配制阀。该配制阀采用NTC热敏电阻作温度传感器，与固定电阻组成简单分压电路作为水温测量电路，利用PIC16C71单片机内置的8位A/D转换器把热敏电阻上的模拟电压转换为数字量，PIC16C71单片机控制直流电机驱动混水阀调节冷热水的混合比例实现水温调节。给出了控制电路图，对水温测量电路的参数选择和测温精度作了详细讨论。实验和分析表明，选用阻值较大的NTC热敏电阻和分压电阻可较好地解决热敏电阻因功耗较大造成的热击穿问题。 Abstract: A digital valve for controlling water temperature based on PIC16C71 was presented in this paper.A bleeder circuit which consisted of a NTC thermistor as temperature sensor and a fixed resistance was designed as water temperature measuring circuit.The analog voltage on the thermistor was converted into digital signal by a 8-bit A/D converter embedded in PIC16C71. Based on the digital signal， the MCU PIC16C71 drived the valve by a DC motor to adjust the water temperature through adjusting the proportion of hot water and cold water.The circuit diagram of controller was given，the principle，the component parameters and the accuracy of measuring temperatures were also dissertated in detail. It was found by experiment and analysis that thermal breakdown of thermistor caused by high power could be solved by selecting thermistor and fixed resistance with high impedance value.
上传时间： 2013-11-08
上传用户：Yue Zhong
介绍了一种TI公司最新推出的MSP430F247单片机，利用它自带的I2C模块驱动I2C总线的温度传感器TMP275。TMP275是一款具有高精度、低功耗的新型温度传感器。由于TMP275具有可编程功能，纤小的封装以及极大的温度范围，因而广泛应用于组建超小型温度测量装置。 Abstract: A new single chip microcomputer MSP430F247 which is released by TI is introduced.It can drive I2C interface digital temperature sensor TMP275 with I2C module.TMP275 is a new temperature sensor which has high accurate,low power. Because TMP275 has programmable function,small packages and wide temperature range,it is applied widely in very little temperature measurment equipment.
上传时间： 2013-12-06
上传用户：asdfasdfd
针对目前采用的热敏电阻测量方法，提出了采用单总线数字式温度传感器DS18B20和单片机组成的新型温度测量仪。介绍DS18B20的结构和工作原理，以及单总线工作原理，给出了由Mega8单片机和DS18B20构成的单总线温度测量仪的硬件电路及软件流程图。经试验基于单总线器件DS18B20的温度测量仪，具有测量准确、测温范围宽、体积小、控制方便等优点。 Abstract: This paper brings forward a new temperature meter composed of 1-Wire temperature sensor DS18B20 and MCU which has advantage of the thermistor. In the article, the DS18B20＇s structure and controlling principles are introduced and hardware circuit and software diagram of the temperature meter are given.After been tested,the temperature meter has the advantages of accurate measurement, wide temperature range, small volume and convenient controlling.
上传时间： 2013-10-31
上传用户：hzy5825468
