虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

导航控制<b>系统</b>

  • 51单片机的靶机自动控制系统

    实弹射击训练是野战部队及武警的重要训练项目,目前国内部队在实弹射击训练中采用的打靶系统普遍价格较高,造成部队实弹训练成本提高,因此难于在部队中大范围推广使用。本系统采用一些价格便宜的一般电子器件来设计一个能够自动示靶、检靶、报靶,且安装和操作方便,性价比较高的适用于当前部队训练实际需要的射击场靶机自动控制系统。

    标签: 51单片机 自动控制系统

    上传时间: 2014-12-26

    上传用户:arnold

  • 基于单片机的数字化B超键盘设计

    针对目前使用的RS232接口数字化B超键盘存在PC主机启动时不能设置BIOS,提出一种PS2键盘的设计方法。基于W78E052D单片机,采用8通道串行A/D转换器设计了8个TGC电位器信息采集电路,电位器位置信息以键盘扫描码序列形式发送,正交编码器信号通过XC9536XL转换为单片机可接收的中断信号,软件接收到中断信息后等效处理成按键。结果表明,在满足开机可设置BIOS同时,又可实现超声特有功能,不需要专门设计驱动程序,接口简单,成本低。 Abstract:  Aiming at the problem of the digital ultrasonic diagnostic imaging system keyboard with RS232 interface currently used couldn?蒺t set the BIOS when the PC boot, this paper proposed a design method of PS2 keyboards. Based on W78E052D microcontroller,designed eight TGC potentiometers information acquisition circuit with 8-channel serial A/D converter, potentiometer position information sent out with keyboard scan code sequentially.The control circuit based on XC9536 CPLD is used for converting the mechanical actions of the encoders into the signals that can be identified by the MCU, software received interrupt information and equivalently treatmented as key. The results show that the BIOS can be set to meet the boot, ultrasound specific functionality can be achieved at the same time, it does not require specially designed driver,the interface is simple and low cost.    

    标签: 单片机 B超 数字化 键盘设计

    上传时间: 2013-10-10

    上传用户:asdfasdfd

  • 基于ATmega16L单片机的温度控制系统设计

     设计一种基于ATmega16L单片机的温度控制系统,阐述该系统的软硬件设计方案。采用模块化设计方法,利用增量式PID算法使被控对象的温度值趋于给定值。实验结果表明该系统具有良好的检测和控制功能。 Abstract:  This paper designs a temperature control system based on ATmega16L,describes the hardware and software de-sign scheme of the system,adopts the modularized design method and utilizes the incremental PID algorithm to realize the temperature of controlled device incline to the given value.The experiment result indicates that the system has good detec-tion and control function

    标签: ATmega 16L 16 单片机

    上传时间: 2013-10-09

    上传用户:stvnash

  • 基于ATmega16的标记机控制系统

    介绍了当前普通标记机控制系统现状及其存在缺点,给出气动标记机及相频修正PWM模式的工作原理。采用ATmega16单片机和USB转换RS232接口器件CH341T实现驱动控制系统与PC的实时通讯,标记控制系统可升级到USB接口。采用基于ATmega16的相频修正PWM替换555振荡电路产生的PWM,可直接通过软件调整PWM信号。使用达林顿三极管TIP122替代直流继电器驱动高频电磁阀,使得电磁阀驱动电路简单,成本低廉。该控制系统已成功应用于气动标记机。 Abstract:  In this paper,the actuality and demerit of the common gas marking machine control systems are described.The operation principle of the gas marking machine and the phase and frequency correct PWM of ATmega16is introduced.The real-time communication between the driving control system and PC by CH341T which its function is translated USB to RS232is realized,the control systems is updated grade to USB interface.The PWM signal can be adjustable by software for the555surge circuit was substituted by the phase and frequency.The high frequency electromagnetic value’s driving circuit by DC relay is replaced by TIP122,therefore,the circuit is become simple and the cost cheap.The control systems has been widely used in gas marking machine.

    标签: ATmega 16 标记 控制系统

    上传时间: 2013-10-18

    上传用户:1427796291

  • 海丰热电公司800立方米水箱单片机控制系统

    摘要 本单片机系统设计的目的是应用单片机控制技术,以8051单片机为核心控制庆丰热电公司的800立方米的水箱的水位,并实现了报警和手动、自动切换功能。该系统操作方便、性能良好,比较符合电厂生产用水系统控制的需要。本文还详细的给出了相关的硬件框图和软件流程图,并编制了该汇编语言程序。

    标签: 800 水箱 单片机

    上传时间: 2013-11-15

    上传用户:ywcftc277

  • 基于AT89C52单片机的飞机副翼控制系统设计

    基于AT89C52单片机的飞机副翼控制系统设计

    标签: 89C C52 AT 89

    上传时间: 2013-10-25

    上传用户:csgcd001

  • 基于ATmgea8单片机的加热控制系统

     介绍基于ATmega8型单片机的温度测量及加热控制系统。分析系统的工作原理,详尽讨论系统的硬件电路和软件流程。实验证明,该系统工作可靠,稳定性高。 Abstract:  The new temperature measuring and heating control system based on ATmega8 MCU is introduced.The system’s working principles is analyzed.The design principles of hardware and software are also discussed in detail.This system has been testified and it works steady and reliably.

    标签: ATmgea8 单片机 加热控制

    上传时间: 2013-11-21

    上传用户:caiguoqing

  • 基于CAN总线的数字式自动找平控制系统设计

    对于沥青混凝土摊铺机自动找平控制系统来说,数字式控制系统的研制是目前的一个方向。介绍了一种基于CAN总线的数字式自动找平控制系统。该系统以CAN总线作为通信方式,PWM控制信号通过C8051F040单片机内部PCA可编程计数器阵列产生,并具有结构简单、信号稳定、实时性强、易扩展的特点。通过硬件实现和系统运行达到了比较理想的控制效果,验证了系统的可行性。 Abstract:  A digital auto-leveling control system based on CAN Bus is introduced.It uses CAN Bus as the method of communication and creates PWM signals by programmable counter array in C8051F040 microcontroller. The system is simple, stable, real-time and expansive.

    标签: CAN 总线 数字式 控制系统设计

    上传时间: 2013-10-09

    上传用户:ligi201200

  • 基于AT89S52的空调温度控制系统的设计

    设计并制作了基于AT89S52 的高精度家用空调温度控制系统。系统硬件主要由电源电路、温度采集电路(DS18B20)、按键、显示电路、控制电路及其他辅助电路等部分组成,软件采用8051C语言编程。该系统可以完成温度显示、温度设定、空调控制及限温报警等多项功能,在现代生产生活中具有极高的应用价值。

    标签: 89S S52 AT 89

    上传时间: 2013-11-04

    上传用户:lijianyu172

  • 基于AT89S52 的水温控制系统的设计

    本文介绍了基于AT89C52 单片机的自动水温控制系统的设计及实现过程。该系统具有实时显示、温度测量、温度设定并能根据设定值对环境温度进行调节实现控温的目的以及达到上下限温度报警功能,控制算法是基于数字PID 算法。关键词 :PID AT89C52 脉宽调制 实时 Abstract : This article describes AT89C52 single-chip microcomputer-basedautomatic water temperature control system design and implementation process. Thesystem has real-time display, temperature measurement, temperature settings and theenvironment in accordance with the temperature settings adjusted to achieve thepurpose of temperature control and reach the upper and lower limits of temperaturealarm function, the control algorithm is based on the digital PID algorithm.Keyword: PID AT89C52 PWM real time

    标签: 89S S52 AT 89

    上传时间: 2013-10-10

    上传用户:归海惜雪