虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

上位

  • 基于ATmega48单片机的可调交流电子负载的设计

    介绍一种无极可调交流电子负载设计的新方法,由ATmega48单片机输出PWM波,通过上位机设定不同的占空比控制场效应管的通断时间,即改变流过场效应管的平均电流。根据电流的大小,可以等效为相应的负载,并将采集的电流值显示在上位机上。文中对该系统的软﹑硬件设计思路作了详细的分析,阐述了其设计原理。   Abstract:  A new type electronic load is introduced.Due to ATmega48 microcomputer output PWM wave.The different duty is set ratio through PC to control FET turn-on time.We can equivalent homologous load according the current and display the current at PC.The hardware and software designing are analysed in detail. The principle is explained and the output is also given.

    标签: ATmega 48 单片机 交流电子

    上传时间: 2013-11-23

    上传用户:虫虫虫虫虫虫

  • 基于W77E58的跑步机联网系统的开发

    对于传统的跑步机无法联机组网,保存历史数据,实时调试等问题,介绍了一个由多台跑步机通过RS-232串行总线与上位机相连组成的跑步机联网系统。系统采用W77E58作为下位机核心控制器件,它具有双串行通讯端口,其中一个串口用于与变频器通讯,另一个串口则与上位机相连,构成跑步机网络。 Abstract:  The traditional running machine can not be connected to a network, saving historical data, real time debug etc.In this paper,a new network system which is composed of running machines connected by a RS-232 communication bus is introduced.In the system,W77E58 is used as a core control unit.W77E58 has two serial ports,one is connected to the inverter and the other is connected to the PC. Thus a network appears.

    标签: W77E58 跑步机 联网系统

    上传时间: 2014-12-27

    上传用户:哇哇哇哇哇

  • 基于C8051F005单片机的参数测试仪的设计

    介绍了基于单片机航空交流电参数测试仪的系统设计。以Silicon Labs公司的C8051F005单片机为核心设计出数据采集板,通过RS-232串口与上位机通讯。运用Lab Windows/CVI编写的上位机软件实现信号的检测以及波形和数据的显示,给出了测试仪硬件电路的组成和软件流程图。本系统具有硬件结构简单、容易实现和成本低等特点,在实际应用中其稳定性、精确性均能满足客户要求。 Abstract:  The design of aeronautics AC parameters tester based on the single-chip is introduced.The core component of data acquisition board is C8051F005 single chip of Silicon Labs Company,and communication with PC through RS-232. The signal processing software programmed with LabWindows/CVI can be used successfully to fulfill inspection of signal and display of the waveform and data. The hardware and software configuration of test instrument are provided.The hardware of the system is simple, and can be easily realized.The stability and precision of the measurement instrument are enough to meet the requirements.

    标签: C8051F005 单片机 仪的设计 参数测试

    上传时间: 2013-11-18

    上传用户:wang5829

  • 基于C8051F020的通用串口适配器的设计

    介绍了基于单片机C8051F020的通用串口适配器的设计与实现方法,即由单片机控制的智能化一对多口收发信号转换器。通过采用C51对单片机进行编程,控制与RS-232(标准RS-232电平)、RS232(TTL电平)、RS-422接口的数据通信;采用C++ Builder作为开发平台,通过RS-232接口实现上位机对适配器各个通信端口的控制。 Abstract:  Design and realization of a universal serial port adapter based on the MCU C8051F020 are introduced.The adapter is an intelligent one-to-more receiving and transmitting signal converter controlled by the MCU. By programming the MCU with the language C51,MCU control data communication between the MCU and RS-232(RS-232 level),RS-232(TTL level),RS-422 port; Using C++ Builder as the development plane, by one RS232 port, the upper PC can control each of the communication port of the adapter.

    标签: C8051F020 串口适配器

    上传时间: 2013-11-19

    上传用户:hebanlian

  • 基于MSP430F149的智能电池巡检系统的设计

    介绍了电力操作电源与智能电池巡检系统的特点,给出了一种基于超低功耗单片机MSP430 F149针对中小型变电站自动化运行的专用设备的基本设计原理及实现方法,最后给出了详细硬件构成和软件实现。该系统能满足中小型变电站安全、可靠、自动运行的要求,并通过与上位机的串行通信实现变电站的远程管理和控制。 Abstract:  The characters of the intelligent battery data logging system of the electric operation power are introduced.The basic design principle and the implemented methods of the special equipment which only designed for the middle or small transformer substation based on MSP430F149 are prescribed. Finally, the hardware block diagram and the software flow chart are also given. The function that the system finally needs to realize can basically meet with the middle or small transformer substation’s satisfy, reliably,and automatic running.And it can also realize the transformer substation long-distance management and control by serial communicating with the host computer.

    标签: 430F F149 MSP 430

    上传时间: 2013-11-25

    上传用户:黄华强

  • 基于MSP430F149的无线环境监测传感器系统设计

    为了提高环境参数采集的自动化水平,提升效率,设计了无线传感器系统。本系统运用了传感器技术、通信技术和单片机技术,实现了对环境温度、湿度、光照度以及可燃性气体浓度等参数的检测。它能够实时地与上位机进行无线通信,满足对环境参数实时监测的要求。 Abstract:  In order to increase the degree of automation and improve the efficiency of the environment monitoring parameters,the wireless sensor system was developed.Combining with the technique of sensor,automatic monitoring,communication and single-chip microcomputer,it realized real-time monitoring environment parameters,such as temperature,humidity,illumination,concentration of com- bustible gas and so on.At the same time it can communicate with upper personal computers,satisfy the desire of real-time monitoring.

    标签: 430F F149 MSP 430

    上传时间: 2013-11-22

    上传用户:longlong12345678

  • 基于C8051F930的管道温度压力远程监测系统

       为解决输油管道温度压力参数实时监测的问题,设计了以C8051F930单片机作为控制核心的超低功耗输油管道温度压力远程监测系统。现场仪表使用高精度电桥采集数据,通过433 MHz短距离无线通信网络与远程终端RTU进行通信,RTU通过GPRS网络与PC上位机进行远程数据传输,在上位机中实现数据存储和图形化界面显示,从而实现输油管道温度压力参数的实时监测和异常报警。经实验证明,该系统的12位数据采集精度满足设计要求,漏码率小于1%,正常工作时间超过5个月,能实时有效地监测输油管道的温度压力参数,节省大量人工成本,有效预防管道参数异常造成的经济损失和环境污染。 Abstract:  In order to solve the problems on real-time monitoring of pipeline temperature and pressure parameters, the ultra-low power remote pipeline temperature and pressure monitoring system was designed by using the single chip processor C8051F930 as the control core. The high-precision electric bridge was used in field instruments for data collection, the 433MHz short-range wireless communication network was used to make communication between field instrument and RTU, the GPRS was used by the RTU to transmit data to the PC host computer, and the data was stored and displayed in the PC host computer, so the real-time monitoring and exception alerts of pipeline temperature and pressure parameters were achieved. The experiment proves that the system of which error rate is less than 1% over five months working with the 12-bit data acquisition accuracy can effectively monitor the pipeline temperature and pressure parameters in real time, it saves a lot of labor costs and effectively prevents environmental pollution and economic losses caused by abnormal channel parameters.

    标签: C8051F930 温度 压力 远程监测系统

    上传时间: 2013-11-07

    上传用户:cuibaigao

  • 基于VB与单片机的温度测控系统设计

     在现代测控系统中,由于PC机具有强大的数据处理能力和良好的用户交互界面,单片机具有较强的现场抗干扰能力及良好的性价比,因此以PC机为上位机实施用户控制和以单片机为下位机进行实时数据采集的分布式智能化控制系统无疑具有很好的应用前景。本文中单片机实现了温度检测,具有较好的实时性;PC机完成了数据显示、存储及统计分析,绘制了实时温度曲线,并对系统目前所处状况做出了评判。两者之间以串行口进行通信联络

    标签: 单片机 温度测控 系统设计

    上传时间: 2013-11-06

    上传用户:joheace

  • STC单片机程序下载器设计

    为我国设计、生产的sTC单片机设计了程序下载器,它由40点DIP锁紧座、USB—UART转换电路、握手信号触发开关等电路和上位机控制程序组成.它利用FT232BM组成串口转换器,将USB串口虚拟成RS232串口,解决了STC单片机与PC机的通信问题.它携带方便,由USB I:/供电,适合在调试现场随时下载程序.

    标签: STC 单片机程序 下载器

    上传时间: 2014-01-09

    上传用户:suoyuan

  • 基于AVR单片机的自动对靶喷雾控制系统设计

    摘要:设计以ATmega16单片机为核心的自动对靶控制系统。该系统利用PC机作为上位机,控制摄像头定时摄取图像,利用2g-r-b颜色特征分割该彩色图像,当绿色颜色分量大于预设阀值时,便判定摄像头下有靶标,用PC机的串口通信系统发送指令到单片机,延迟预设的时间后,控制执行机构进行喷雾,实现自动对靶喷雾,并且可以设定延迟时间,从而实现在不同行走速度下的自动对靶喷雾。关键词:自动对靶;AVR;串口通信;颜色分割

    标签: AVR 单片机 自动 控制系统设计

    上传时间: 2014-12-27

    上传用户:redmoons