搜索结果

The software implements particle filtering and Rao Blackwellised particle filtering for conditionally Gaussian Models. The RB algorithm can be interpreted as an efficient stochastic mixture of Kalman filters. The software also includes efficient state-of-the-art resampling routines. These are generi ...

三星公司官方 GIVEIO.SYS源代码下载。 In windows NT/2000/XP, any application can’t access the I/O such as the parallel port. So, GIVEIO.SYS enables SJF.exe to access the parallel port without any memory fault. In windows 95/98, GIVEIO.SYS isn’t needed.

The TMS320VC5506/C5507/C5509A USB peripherals can be clocked from either the USB APLL or the USB DPLL. Since the APLL is inherently more noise tolerant and has less long-term jitter than the DPLL, it is recommended that you switch to it for any USB operations.

TIDA-00807 OH Fault Indicator Software (Rev. A)-故障指示器TI官方例子 

The SP2526A device is a dual +3.0V to +5.5V USB Supervisory Power Control Switch ideal for self-powered and bus-powered Universal Serial Bus (USB) applications. Each switch has low on-resistance (110mΩ typical) and can supply 500mA minimum. The fault currents are limited to 1.0A typical and the fla ...

The BTS5016SDA is a one channel high-side power switch in PG-TO252-5-11 package providing embedded protective functions. The power transistor is built by a N-channel vertical power MOSFET with charge pump. The design is based on Smart SIPMOS chip on chip technology. The BTS5016SDA has a current cont ...

This book addresses two aspects of network operation quality; namely, resource management and fault management. Network operation quality is among the functions to be fulfilled in order to offer quality of service, QoS, to the end user. It is characterized by four parameters: – packet loss; – dela ...

STM32L053C8T6数据手册Features • Ultra-low-power platform – 1.65 V to 3.6 V power supply – -40 to 125 °C temperature range – 0.27 µA Standby mode (2 wakeup pins) – 0.4 µA Stop mode (16 wakeup lines) – 0.8 µA Stop mode + RTC + 8 KB RAM retention – 139 µA/MHz Run mode at 32 MHz – 3.5 µs w ...

电子书-RTL Design Style Guide for Verilog HDL540页A FF having a fixed input value is generated from the description in the upper portion of Example 2-21. In this case, ’0’ is output when the reset signal is asynchronously input, and ’1’ is output when the START signal rises. Therefore, the FF da ...

Note: Before commissioning the value of the connected mains voltage must be set in the servo controller(factory setting=3×400 V AC). More detailed information see chapter 4"Commissioning".通讯接口所有的Servo-One系列均有USB及TCP/IP通讯接口，可通过LT-I公司的Drive-Manager5软件进行通讯，进行相关参数的 ...