搜索结果
找到约 59 项符合
configured 的查询结果
按分类筛选
单片机开发 This program demonstrates operation of ADC0 in polled mode. The ADC0 is // configured to use writes
This program demonstrates operation of ADC0 in polled mode. The ADC0 is
// configured to use writes to AD0BUSY as its start of conversion source and
// to measure the output of the on-chip temperature sensor. The temperature
// sensor output is converted to degrees Celsius and is transmitted out UAR ...
单片机开发 // This program accesses a SPI EEPROM using polled mode access. The F06x MCU // is configured in 4-
// This program accesses a SPI EEPROM using polled mode access. The F06x MCU
// is configured in 4-wire Single Master Mode, and the EEPROM is the only
// slave device connected to the SPI bus. The read/write operations are
// tailored to access a Microchip 4 kB EEPROM 25LC320. The relevant hardware
...
单片机开发 // This program accesses a SPI EEPROM using polled mode access. The F06x MCU // is configured in 4-
// This program accesses a SPI EEPROM using polled mode access. The F06x MCU
// is configured in 4-wire Single Master Mode, and the EEPROM is the only
// slave device connected to the SPI bus. The read/write operations are
// tailored to access a Microchip 4 kB EEPROM 25LC320. The relevant hardware
...
单片机开发 This program accesses a SPI EEPROM using polled mode access. The F12x MCU is configured in 4-wire Si
This program accesses a SPI EEPROM using polled mode access. The F12x MCU is configured in 4-wire Single Master Mode, and the EEPROM is the only slave device connected to the SPI bus. The read/write operations are tailored to access a Microchip 4 kB EEPROM
行业应用文档 效率85％的12v转5v降压转换器
This application note describes how the NCP3063 can be configured as a buck controller to drive an e
技术资料 效率85％的12v转5v降压转换器
This application note describes how the NCP3063 can be configured as a buck controller to drive an e
技术资料 采用阻抗测量技术 CS5516 CS5520 A D转换器可以用于精密温度测量
The CS5516/CS5520 bridge-measurement A/Dconverters can be configured for precisemeasurement
技术资料 可编程逻辑器件在带电插入应用中的影响以及在进行带电插入设计中的其他因素的考虑
The PLC42VA12 contains 10 flip-flops thatmay flexibly be configured to build counters,shifte
单片机开发 This example program shows how to configure PCA Module 4 as a watchdog timer. In this example, the
This example program shows how to configure PCA Module 4 as a
watchdog timer. In this example, the watchdog is configured to
overflow after 0xFF00 clock cycles.
DSP编程 using gpio of 2812 This program requires the DSP281x V1.00 header files. As supplied, this project
using gpio of 2812
This program requires the DSP281x V1.00 header files. As supplied, this project is configured for "boot to H0" operation.