how too.txt

info for install igo on gps

Unlock navigon -    09-13-2008, 02:18 PM
1. use 4gb or > SD card. Donot use original SD card, if you use must back up. Then Format SD card in FAT32
2. download miopocket2 software from gpspassion forum
http://www.gpspassion.com/forumsen/t...OPIC_ID=109690

3.UnZip and copy to your sd card
4. Find file MioAutoRun And MioAutoRun.mscr change them to autorunce and autorunce.mscr( this is for 2100Max and 7100 USA make sure your navigon device has same name. program name with navigon symbol)
5. Power off insert SD card and use reset button on bottom leftside. May need a papper clip to push
6. wait few second do nothing program will install and u ll see window screen.
7. now copy ur all Navigon files in SD card in program file if u want
now you can run navigon and other program In Your GPS
8. to goback to original navigon system , Shut down device and hold down power button for >15 sec and insert Original SD car and start again. May have to hold button for few second.

iGo8 on Navigon 8110?
Check ur navigon directory which file has a navigon symbol. it might have a different name. 2100 7100 5100 uses "autorunce" 8110 uses another name.
u have to rename mioautorun into that name.
I use the navigon 2150 max and i can use "UpdateMe.exe and UpdateMe.mscr.



Hi All,
I installed Miopocket (2.0R32) on my Navigon 2100Max. Now the only hardware button (Power) does not work, even if I uninstalll Miopocket. I went through the postings here, and tried to figure it out with PowerButtonTest.exe, it does not pop out any message box. Don't think there is anything wrong with the button itself, it wakes up the GPS from standby fine.
Does anyone have a code for the button to put in PowerButton.ini file? Else I am willing to uninstall MioPocket too. Does anyone know how to remove it cleanly (last time I did, MioAutoRun directory was still in the flash). either automatically, or manually.
Thanks.
@ timberwolf60 :
I found that in another Forum :

Posted by Gollemano
"Ok, I had some issues with MioPocket and my Navigon 2100 Max where I lost the "off" functionality of the hardware button. Just in case someone else is struggeling with the same issue,
editing reg key
HKEY_LOCAL_MACHINE\Hardware\DeviceMap\KEYBD\Driver name
wich most likely points to kbmouse.dll after a MP installation
and instead let it point to keybddr.dll (in ROM) sorted it out.
Is MP updating this key on a standard install or just when using full keyboard? What about previous releases? If so and if I'm correct, CE will use keybddr.dll as default if no other driver is specified, so perhaps MP should only update the reg if no value is present for that key."

Hope this helps.