_422_receiver_1.v.bak

多功能卡的源代码

//同步串口接收模块
//原作者：刘通
//
//
//		
module _422_receiver_1(reset,sdin,sys_clock,sclk,r_enable
						,dout,wrn
						//,bit_counter_2
						//,state
					);

input reset,sdin,sys_clock,sclk,r_enable;
output wrn;
output [7:0]dout;
//output bit_counter_2;
//output [1:0]state;
//-------------------------------------
wire bit_counter_2;
reg wrn;
reg [7:0]dout;
wire [7:0] dout;
reg [7:0]data;
reg [2:0]bit_counter;
reg data_receive_begin;
reg [1:0]state;
wire bit_counter_or;
reg bit_counter_or_reg;
reg data_receive_begin_reg;
///////////////////////////////////////////////////////////
assign bit_counter_2=bit_counter[2];
//assign dout=data;
assign bit_counter_or=|bit_counter;
///////////////////////////////////////////////////////////
///////////////////////////////////////////////////////////
always @(negedge sclk or negedge reset)
begin
	if (!reset)	
		data<=8'b0;	
	else if(r_enable)
		data[7:0]<={sdin,data[7:1]};
	else 
		data<=8'b0;	
end
/////////////////////////////////////////////////////////
always @(negedge sclk or negedge reset)
begin
	if (!reset)	
		bit_counter<=3'd0;	
	else if(r_enable)
		bit_counter<=bit_counter+3'd1;
	else 
		bit_counter<=3'd0;
end
/////////////////////////////////////////////////////////
always @(negedge sclk or negedge reset)
begin
	if (!reset)	
		data_receive_begin<=1'b0;	
	else if(r_enable)
		data_receive_begin<=1'b1;
	else 
		data_receive_begin<=1'b0;
end
/////////////////////////////////////////////////////////
always @(posedge sys_clock)
begin
	bit_counter_or_reg<=bit_counter_or;
	data_receive_begin_reg<=data_receive_begin;
end
always @(posedge sys_clock or negedge reset)
begin
	if(!reset)	
	begin
		dout<=8'd0;
		wrn<=1'b0;
		state<=2'b00;
	end
	else if((bit_counter_or_reg==1'b0)&&(data_receive_begin_reg==1'b1))
		case(state)
			2'b00:	
			begin	
				dout<=data;
				wrn<=1'b1;
				state<=2'b01;
			end
			2'b01: 	
			begin	
				wrn<=1'b0;
				state<=2'b11;	
			end
			default:	
			begin	
				state<=state;
				wrn<=1'b0;
			end
		endcase
	else	
	begin
		dout<=8'd0;//更改了此句话后，写错的数据就变成了00H（原来写错的数为没错之前的一个数）。
		wrn<=1'b0;
		state<=2'b00;
	end
end

//-------------------------------------------------------
////////////////////////////////////////////////////////
endmodule