adcsing.c

ADuC7020ADC程序, 授权开发, 内部资料,共享, 后续程序值得学习

/*********************************************************************

 Author        : ADI - Apps            www.analog.com/MicroConverter

 Date          : Sept. 2005

 File          : ADCsing.c

 Hardware      : Applicable to ADuC702x rev H or I silicon
                 Currently targetting ADuC7026.

 Description   : Performs single ADC conversions on ADC0,
		 		 and send the result through UART at 9600bps
		
*********************************************************************/
#include <ADuC7026.h>

void senddata(short);
void ADCpoweron(int);
char hex2ascii(char);

int main (void)  {

	ADCpoweron(20000);			// power on ADC										
 	ADCCP = 0x00;				// Selecting ADC Channel 0
	REFCON = 0x01;				// connect internal 2.5V reference to Vref pin

	GP0CON = 0x10100000; 		// enable ECLK output on P0.7, and ADCbusy on P0.5

 	// configures GPIO to flash LED P4.2
	GP4DAT = 0x04000000;		// P4.2 configured as an output. LED is turned on	

	// Setup tx & rx pins on P1.0 and P1.1
	GP1CON = 0x011;

   // Start setting up UART
	COMCON0 = 0x80;				// Setting DLAB			
	COMDIV0 = 0x88;				// 
   	COMDIV1 = 0x00;
   	COMCON0 = 0x07;				// Clearing DLAB
			
	while(1)
	{
		ADCCON = 0x7E3;				// ADC config: fADC/2, acq. time = 16 clocks => ADC Speed = 1MSPS
		while (!ADCSTA){}			// wait for end of conversion
		senddata (ADCDAT >> 16);
		GP4DAT ^= 0x00040000;		// Complement P4.2
	}
}


void senddata(short to_send)
{
	while(!(0x020==(COMSTA0 & 0x020))){}
		COMTX = 0x0A;						// output LF 
	while(!(0x020==(COMSTA0 & 0x020))){}
		COMTX = 0x0D;						// output CR 
	while(!(0x020==(COMSTA0 & 0x020))){}
		COMTX = hex2ascii ((to_send >> 8) & 0x0F);
	while(!(0x020==(COMSTA0 & 0x020))){}
		COMTX = hex2ascii ((to_send >> 4) & 0x0F);						
	while(!(0x020==(COMSTA0 & 0x020))){}
		COMTX = hex2ascii (to_send & 0x0F);	
					

}


char hex2ascii(char toconv)
{
	if (toconv<0x0A) 
	{
		toconv += 0x30;
	}
	else 
	{
		toconv += 0x37;
	}
	
	return (toconv);
}

void ADCpoweron(int time)
{
	ADCCON = 0x20;	 					// power-on the ADC
	while (time >=0)	  				// wait for ADC to be fully powered on
    time--;
}