OFDMA Resource Allocation Simulations A Low Complexity Algorithm for Proportional
标签： Proportional Simulations Allocation Complexity
上传时间： 2014-08-11
上传用户：xuanjie
This is a device for use by RC hobbysts: it transforms a servo from Proportional to integrative. For RC boats, it allows user not to change the functionality of the throttle stick, UP/DOWN in stead of Proportional. The archive contains also the PCB files.
标签： Proportional integrative transforms hobbysts
上传时间： 2014-01-25
上传用户：love1314
CANopen - Profile Fluid Power Technology Proportional Valves and Hydrostatic Transmissions
标签： Transmissions Proportional Hydrostatic Technology
上传时间： 2017-05-14
上传用户：AbuGe
I. C. Wong, Z. Shen, J. G. Andrews, and B. L. Evans, ``A Low Complexity Algorithm for Proportional Resource Allocation in OFDMA Systems , Proc. IEEE Int. Work. Signal Processing Systems, 针对这篇文章给出的源代码
上传时间： 2014-01-24
上传用户：zhichenglu
Abstract: Quartz crystals are mechanical resonators with piezoelectric properties. The piezoelectricproperties (electric potential across the crystal is Proportional to mechanical deformation) allow their use
标签： 晶体振荡器
上传时间： 2013-10-17
上传用户：时代将军
Sensors for pressure, load, temperature, acceleration andmany other physical quantities often take the form of aWheatstone bridge. These sensors can be extremely linearand stable over time and temperature. However, mostthings in nature are only linear if you don’t bend them toomuch. In the case of a load cell, Hooke’s law states that thestrain in a material is Proportional to the applied stress—as long as the stress is nowhere near the material’s yieldpoint (the “point of no return” where the material ispermanently deformed).
上传时间： 2013-11-12
上传用户：墙角有棵树
锁定放大是微弱信号检测的重要手段。基于相关检测理论，利用开关电容的开关实现锁定放大器中乘法器的功能，提出开关电容和积分器相结合以实现相关检测的方法，并设计出一种锁定放大器。该锁定放大器将微弱信号转化为与之相关的方波，通过后续电路得到正比于被测信号的直流电平，为后续采集处理提供方便。测量数据表明锁定放大器前级可将10-6 A的电流转换为10-1 V的电压，后级通过带通滤波器级联可将信号放大1×105倍。该方法在降低噪声的同时，可对微弱信号进行放大，线性度较高、稳定性较好。 Abstract: Lock-in Amplifying（LIA）is one of important means for weak signal detection. Based on cross-correlation detection theory， switch in the swithched capacitor was used as multiplier of LIA， and a new method of correlation detection was proposed combining swithched capacitor with integrator. A kind of LIA was designed which can convert the weak signal to square-wave， then DC Proportional to measured signal was obtained through follow-up conditioning circuit， providing convenience for signal acquisition and processing. The measured data shows that the electric current（10-6 A） can be changed into voltage（10-1 V） by LIA， and the signal is magnified 1×105 times by cascade band-pass filter. The noise is suppressed and the weak signal is amplified. It has the advantages of good linearity and stability.
上传时间： 2013-11-28
上传用户：黑漆漆
he LPC932 can be used to create a Pulse Width Modulated PWM signal. That s an analog signal, with only 2 discrete levels, for example 0V and 5V and a constant period. The current value of this signal at a certain poiTnt of time is Proportional to its Duty Cycle. That s the High Time during one period divided by the period. It can also be calculated as the average value during a particular period. That means after low pass filtering, (e.g. RC circuit) the signal becomes analog, with an actual value controlled by the microcontroller. The PWM functionality enables the LPC932 to control for example the speed of DC motors or the brightness of electric lighting.
标签： signal Modulated analog create
上传时间： 2015-05-14
上传用户：CHINA526
This software is developed to provide ease with controller design. For PID control, options are given to design and analyse the compensated and uncompensated system. You are free to choice among Proportional PI, PD and PID mode of control. Both frequency and time domain characteristics can be observed. Special Menus are given to observe time and frequency response plots. For Statefeedback controller similar options are given. But this is limited to second order system only.
标签： controller developed software control
上传时间： 2017-07-25
上传用户：aysyzxzm
本应用笔记介绍一种采用dsPIC数字信号控制器（Digital Signal Controller，DSC）或PIC24单片机来实现无刷直流（Brushless Direct Current，BLDC）电机无传感器控制的算法。该算法利用对反电动势（Back-Electromotive Force，BEMF）进行数字滤波的择多函数来实现。通过对电机的每一相进行滤波来确定电机驱动电压换相的时刻。这一控制技术省却了分立的低通滤波硬件和片外比较器。需指出，这里论述的所有内容及应用软件，都是假定使用三相电机。该电机控制算法包括四个主要部分：·利用DSC或单片机的模数转换器（Analog-to-Digital Converter，ADC）来采样梯形波BEMF信号·PWM导通侧ADC采样，以降低噪声并解决低电感问题·将梯形波BEMF信号与VBUS/2进行比较，以检测过零点·用择多函数滤波器对比较结果信号进行滤波·以三种不同模式对电机驱动电压进行换相：-传统开环控制器·传统闭环控制器比例-积分（Proportional-Integral，Pl）闭环控制器
标签： BLDC
上传时间： 2022-07-01
上传用户：zhengtiantong
