虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

two-input

  • 电网现场作业管理系统的信息化设计

    为了改变目前电网现场作业管理的变电巡检、变电检修试验、输电线路巡检检修等管理系统各自独立运行,信息不能共享,功能、效率受限,建设和维护成本高的现状,提出了采用B/S+C/S构架模式,将各现场作业管理模块和生产MIS(管理系统)集成为一体的现场作业管理系统的设计方案,做到各子系统和生产MIS软硬资源共享,做到同一数据唯一入口、一处录入多处使用。各子系统设备人员等基础信息来源于生产管理系统,各子系统又是生产管理系统的作业数据、缺陷信息的重要来源。经过研究试用成功和推广应用,目前该系统已在江西电网220 kV及以上变电站全面应用。 Abstract:  In order to improve the status that the substation field inspection system, substation equipments maintenance and testing system, power-line inspection and maintenance system are running independent with each other. They can?蒺t share the resource information which accordingly constrains their functions and efficiency, and their construction and maintenance costs are high. This paper introduces a field standardized work management system based on B/S+C/S mode, integrating all field work management systems based on MIS and share the equipments and employee?蒺s data of MIS,the field work data of the sub systems are the source information of MIS, by which the same single data resouce with one-time input can be utilized in multiple places. After the research and testing, this system is triumphantly using in all 220kV and above substations in Jiangxi grid.

    标签: 电网 信息化 管理系统

    上传时间: 2013-11-15

    上传用户:han_zh

  • SKS-100 Single Output Switchin

    Features:   High efficiency, high reliability, low cost  AC input range selected by switch  100% full load burn-in test  Protections: Short circuit / Over load  Fixed switching frequency at 25KHz  Cooling by free air convection  1 year warranty   Dimensions: 199*98*38mm (L*W*H)    

    标签: Switchin Output Single SKS

    上传时间: 2013-10-30

    上传用户:taa123456

  • LTC6994参考设计及PCB布线规则

    Demonstration circuit 1562A is an engineering toolto design and evaluate the LTC699X-X family ofTimerBlox circuits. The center section of the boardcontains a pre-configured TimerBlox function.DC1562A comes in twelve timing function variationsas outlined in Table 1.Surrounding the center board is a ”playground”prototyping area. The prototyping area has padsfor Dip-8, S8, MS8, or S6 packages with breadboarding connections to each pin and two convenientpower buses and ground bus surrounding theentire area. This area is for conditioning signals tocontrol the timer function and for adding loads controlled in time.

    标签: 6994 LTC PCB 参考设计

    上传时间: 2013-10-18

    上传用户:如果你也听说

  • P89LPC912英文资料

    The P89LPC912/913/914 are single-chip microcontrollers in low-cost 14-pin packages, based on a high performance processor architecture that executes instructions in two to four clocks, six times the rate of standard 80C51 devices. Many system level functions have been incorporated into the P89LPC912/913/914 in order to reduce component count, board space, and system cost.

    标签: P89 LPC 912 89

    上传时间: 2013-10-12

    上传用户:司令部正军级

  • 西门子S7-300 PLC模拟量转换

    Analog Inputs and Outputs in an S7 PLC are represented in the PLC as a 16-bit integer. Over the nominal span of the analog input or output, the value of this integer will range between - 27648 and +27648. However, it is easier to use the analog values if they are scaled to the same units and ranges as the process being controlled. This applications tip describes methods for scaling analog values to and from engineering units.

    标签: 300 PLC 西门子 模拟量

    上传时间: 2013-11-17

    上传用户:3294322651

  • C8051F020

    HIGH SPEED 8051 μC CORE - Pipe-lined Instruction Architecture; Executes 70% of Instructions in 1 or 2 System Clocks - Up to 25MIPS Throughput with 25MHz System Clock - 22 Vectored Interrupt Sources MEMORY - 4352 Bytes Internal Data RAM (256 + 4k) - 64k Bytes In-System Programmable FLASH Program Memory - External Parallel Data Memory Interface – up to 5Mbytes/sec DIGITAL PERIPHERALS - 64 Port I/O; All are 5V tolerant - Hardware SMBusTM (I2CTM Compatible), SPITM, and Two UART Serial Ports Available Concurrently - Programmable 16-bit Counter/Timer Array with 5 Capture/Compare Modules - 5 General Purpose 16-bit Counter/Timers - Dedicated Watch-Dog Timer; Bi-directional Reset CLOCK SOURCES - Internal Programmable Oscillator: 2-to-16MHz - External Oscillator: Crystal, RC, C, or Clock - Real-Time Clock Mode using Timer 3 or PCA SUPPLY VOLTAGE ........................ 2.7V to 3.6V - Typical Operating Current: 10mA @ 25MHz - Multiple Power Saving Sleep and Shutdown Modes 100-Pin TQFP (64-Pin Version Available) Temperature Range: –40°C to +85°C

    标签: C8051F020

    上传时间: 2013-10-12

    上传用户:lalalal

  • 基于MSP430F1611单片机的音频信号分析仪设计

      为了使音频信号分析仪小巧可靠,成本低廉,设计了以2片MSP430F1611单片机为核心的系统。该系统将音频信号送入八阶巴特沃兹低通滤波器,对信号进行限幅放大、衰减、电平位移、缓冲,并利用一单片机负责对前级处理后的模拟信号进行采样,将采集得到的音频信号进行4 096点基2的FFT计算,并对信号加窗函数提高分辨率,另一单片机负责对信号的分析及控制显示设备。此设计精确的测量了音频信号的功率谱、周期性、失真度指标,达到较高的频率分辨率,并能将测量结果通过红外遥控器显示在液晶屏上。   Abstract:   o make the audio signal analyzer cheaper, smaller and more reliable, this system sends the audio signal to the eight-order butterworth filter, and then amplifies, attenuates, buffers it in a limiting range, transfers the voltage level of the signal before utilizing two MSP430F1611 MCU to realize the audio analysis. One is charged for sampling and dealing with the processed audio signal collected by the 4096 point radix-2 FFT calculation and imposes the window function to improve the frequency resolution. The other one controls the display and realizes the spectrum, periodicity, power distortion analysis in high resolution which is displayed in the LCD screen through the infrared remote control.

    标签: F1611 1611 430F MSP

    上传时间: 2013-12-11

    上传用户:jasonheung

  • AVR常用库函数介绍

    目录: 1. Character Type Functions - 字符类型函数 2. Standard C Input/Output Functions - 标准输入输出函数 3. Standard Library Functions - 标准库和内存分配函数 4. Mathematical Functions - 数学函数 5. String Functions - 字符串函数 6. BCD Conversion Functions - BCD 转换函数 7. Memory Access Functions - 存储器访问函数 8. Delay Functions - 延时函数 9. LCD Functions - LCD函数 10. LCD Functions for displays with 4x40 characters - 4×40 字符型LCD函数 11. LCD Functions for displays connected in 8 bit memory mapped mode -以8 位外部存储 器模式接口的LCD显示函数 12. I2C Bus Functions - I2C 总线函数 13. National Semiconductor LM75 Temperature Sensor Functions - LM75 温度传感器函数 14. Dallas Semiconductor DS1621 Thermometer/Thermostat Functions - DS1621 温度计函 数 15. Philips PCF8563 Real Time Clock Functions - PCF8563 实时时钟函数 16. Philips PCF8583 Real Time Clock Functions - PCF8583 实时时钟函数 17. Dallas Semiconductor DS1302 Real Time Clock Functions - DS1302 实时时钟函数 18. Dallas Semiconductor DS1307 Real Time Clock Functions - DS1307 实时时钟函数 19. 1 Wire Protocol Functions - 单线通讯协议函数 20. Dallas Semiconductor DS1820/DS1822 Temperature Sensors Functions - DS1820/1822 温度传感器函数 21. SPI Functions - SPI 函数 22. Power Management Functions - 电源管理函数 23. Gray Code Conversion Functions - 格雷码转换函数

    标签: AVR 库函数

    上传时间: 2013-10-22

    上传用户:归海惜雪

  • 基于CH341A的USB串口通讯设计

    为解决当前计算机串行通讯接口只有USB,难以满足旧型号设备或某些单片机要求RS232通讯的问题,设计出两款RS232/USB电路。采用CH341A与MAX223集成电路芯片构建标准9线RS232/USB通用接口转换器,无需编程。采用CH341A与PIC16F877A构建单片机与计算机之间的USB通讯电路,软件遵循RS232通讯协议,硬件进行电平转换。实际使用表明,这两款产品与计算机端Windows 操作系统下的串口应用程序完全兼容,且通讯过程中无握手失败现象。 Abstract:  To solve the problem that current computer serial communication only with USB interface can not satisfy with the old type equipments or MCU to communicate with RS232, two kinds of RS232/USB circuit were designed.CH341A and MAX223 integrated circuit chips were used to create a standard 9-line RS232/USB universal interface convertor without programme. CH341A and PIC16F877A chips were adopted to build the USB communication circuit between computers and MCU. The software follows RS232 communication protocol, and the hardware converts electrical levels. Actual practices indicate that the two manufactures are compatible with serial application program of Windows operation system completely,and get avoid of handshake lost.    

    标签: 341A 341 USB CH

    上传时间: 2013-11-03

    上传用户:siying

  • 基于C8051F040的以太网-CAN转换电路设计

    以太网和CAN总线应用广泛,但由于其通信协议不同,两种总线器件间无法进行数据通信,因此,设计了基于CP2200与C8051F040的以太网总线与CAN总线接口转换电路,并给出部分相关硬件电路与软件设计分析。在保证数据完整和协议可靠的前提下,通过握手协议和简化的以太网协议,不仅实现了以太网数据与CAN数据的转发,同时还顺利的解决了以太网的高速性与CAN的低速率冲突,以及两者数据包之间的大小不同的矛盾。 Abstract:  In the development of actual application, Ethernet and CAN bus are used very extensively. Owing to its various communication protocols, the communicating between two kinds of bus device can’t be carried out. Therefore, in order to solve this problem, the Ethernet-CAN bus interface circuit based on CP2200 and C8051F040 was designed in this paper, and part of the related hardware circuit and software design analysis were given. On the condition of data’s integrity and protocols’reliability, through the handshaking protocols and the simplified the Ethernet protocol, not only the data switching between CAN and Ethernet was realized, but also the differ in velocity and packet size was solved.

    标签: C8051F040 CAN 以太网 转换

    上传时间: 2013-10-15

    上传用户:Ants