Long-TermEvolution(LTE)isarguablyoneofthemostimportantstepsinthecurrentphaseof the development of modern mobile communications. It provides a suitable base for enhanced services due to increased data throughput and lower latency figures, and also gives extra impetus to the modernization of telecom architectures. The decision to leave the circuit- switched domainoutofthescope ofLTE/SAEsystem standardization might soundradical but itindicatesthatthetelecomworldisgoingstronglyfortheall-IPconcept----andthedeployment of LTE/SAE is concrete evidence of this global trend.
标签： Deployment Handbook LTE-SAE The
上传时间： 2020-06-01
上传用户：shancjb
switched systems are embedded devices widespread in industrial applications such as power electronics and automotive control. They consist of continuous-time dynamical subsystems and a rule that controls the switching between them. Under a suitable control rule, the system can improve its steady-state performance and meet essential properties, such as safety and stability, in desirable operating zones.
标签： Invariance Switching Analysis1 Systems by
上传时间： 2020-06-07
上传用户：shancjb
The PW5410B is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 1.8V to 5V input with up to 100mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410B ideally suited for small, battery-powered applications
标签： pw5410
上传时间： 2022-02-10
上传用户：wangshoupeng199
The PW5410A is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 2.7V to 5V input with up to 250mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410A ideally suited for small, battery-powered applications
标签： pw5410
上传时间： 2022-02-10
上传用户：nicholas28
电子书-RTL Design Style Guide for Verilog HDL540页A FF having a fixed input value is generated from the description in the upper portion of Example 2-21. In this case, ’0’ is output when the reset signal is asynchronously input, and ’1’ is output when the START signal rises. Therefore, the FF data input is fixed at the power supply, since the typical value ’1’ is output following the rise of the START signal. When FF input values are fixed, the fixed inputs become untestable and the fault detection rate drops. When implementing a scan design and converting to a scan FF, the scan may not be executed properl not be executed properly, so such descriptions , so such descriptions are not are not recommended. recommended.[1] As in the lower part of Example 2-21, be sure to construct a synchronous type of circuit and ensure that the clock signal is input to the clock pin of the FF. Other than the sample shown in Example 2-21, there are situations where for certain control signals, those that had been switched due to the conditions of an external input will no longer need to be switched, leaving only a FF. If logic exists in a lower level and a fixed value is input from an upper level, the input value of the FF may also end up being fixed as the result of optimization with logic synthesis tools. In a situation like this, while perhaps difficult to completely eliminate, the problem should be avoided as much as possible.
标签： RTL verilog hdl
上传时间： 2022-03-21
上传用户：canderile
近距电能传输——高效安全近距电能传输一般基于电磁感应原理进行。在此技术基础上，当接收器邻近发射器时才会进行电能传输。电磁感应技术的历史长达百年，多年米一直应用于各类电子产品中—如此普及全因其简单、高效以及安全技术概览以下将为你简要介绍无线电能传输技术。System Overview(Communication)Receiver sends messagesTo provide control information to the transmitterBy load modulation on the power signaTransmitter receives messagesTo receive control information frorn the recelverBy de-modulation of the reflected loadPower Pick Up( Receiver)Secondary coil (L Serial resonance capacitor (C) for efficient power transfer Parallel resonance capacitor(C, )for detection purposes Rectifier: full bridge(diode, or switched)+ capacitor Output switch for(dis)connecting the loadReceiver modulates load by Switching modulation resistor(R,n),or Switching modulation capacitor(Ca)Transmitter de-modulates reflected load by Sensing pnmary coil curent (p)and/o Sensing primary coil voltage (V,
上传时间： 2022-03-31
上传用户：13692533910
