随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
近距电能传输——高效安全近距电能传输一般基于电磁感应原理进行。在此技术基础上，当接收器邻近发射器时才会进行电能传输。电磁感应技术的历史长达百年，多年米一直应用于各类电子产品中—如此普及全因其简单、高效以及安全技术概览以下将为你简要介绍无线电能传输技术。System Overview(Communication)Receiver sends messagesTo provide control information to the transmitterBy load modulation on the power signaTransmitter receives messagesTo receive control information frorn the recelverBy de-modulation of the reflected loadPower Pick Up( Receiver)Secondary coil (L Serial resonance capacitor (C) for efficient power transfer Parallel resonance capacitor(C, )for detection purposes Rectifier: full bridge(diode, or switched)+ capacitor Output switch for(dis)connecting the loadReceiver modulates load by Switching modulation resistor(R,n),or Switching modulation capacitor(Ca)Transmitter de-modulates reflected load by Sensing pnmary coil curent (p)and/o Sensing primary coil voltage (V,
上传时间： 2022-03-31
上传用户：
ICN6201/02 is a bridge chip which receives MIPI® DSI inputs and sends LVDS outputs. MIPI® DSI supports up to 4 lanes and each lane operates at 1Gbps maximum; the totally maximum input bandwidth is 4Gbps; and the MIPI defined ULPS(ultra-low-power state) is also supported. ICN6201 decodes MIPI® DSI 18bepp RGB666 and 24bpp RGB888 packets.The LVDS output 18 or 24 bits pixel with 25MHz to 154MHz, by VESA or JEIDA format.ICN6201/02 support video resolution up to FHD (1920x1080) and WUXGA (1920x1200).ICN6201 adopts QFN48 package and ICN6202 adopts QFN40 package
标签： icn6202
上传时间： 2022-06-10
上传用户：kingwide
VIP专区-嵌入式/单片机编程源码精选合集系列（13）资源包含以下内容：1. CPMinterrupt 860中断管理.2. 菲利普LPC900系列写Flash源码.3. 前段时间做了一个AT91M55800的芯片测试.4. tms320c5402 bootloader.5. tms320c54x realtime os.6. tms320 c5416 boot code.7. MGLS-240128TA液晶点阵显示驱动程序.8. 嵌入式WINDOWSCE的书.9. 嵌入式TCP/IP包.10. sl811hs的host源程序.11. 嵌入式产品中的osip的源代码..12. msp430的FLASH自编程子程序.13. IGNITE开发板说明书.14. 嵌入式实时系统中的优先级反转问题.15. 仅供参考.16. 仅供参考.17. LCD driver 程序.18. 一个能跨页面读写的I2C源码.19. 一个2051控制两个步进电机的源码.20. 1330液晶源码（可直接调用汉字）.21. pcf8583 常用时钟芯片的使用.22. 1815 LCD drive IC 类驱动测试程序.23. 内存检测程序源代码.24. 嵌入式系统词汇表.25. demonstrate how to use the bulk endpoint pairing feature of the EZ-USB chip.26. A Simple isochronous transfer. Reads 8051 ports A,B and C, and continuously sends a five byte packet.27. 44b0x bootloader.28. 键盘只有一个键 b.29. tornado安装说明及KEY.30. 6711a板程序的傅立叶变换.31. 6711开发的源程序.32. 6711开发程序例子.33. 6711开发板源程序.34. 6711开发板源程序.35. 智能楼宇自动控制系统.36. YAFFS的升级版本YAFFS2.37. 嵌入开发笔记 用ps阅读器打开.38. 嵌入式系统的重要概念.39. 嵌入式系统的调试方法.40. 一个在mck2407板上控制无刷电机恒速运行的程序.
上传时间： 2013-07-21
上传用户：eeworm
