提出一种基于FPGA的实时视频信号处理平台的设计方法，该系统接收低帧率数字YCbCr 视频信号，对接收的视频信号进行格式和彩色空间转换、像素和，利用片外SDRAM存储器作为帧缓存且通过时序控制器进行帧率提高，最后通过VGA控制模块对图像信号进行像素放大并在VGA显示器上实时显示。整个设计使用Verilog HDL语言实现，采用Altera公司的EP2S60F1020C3N芯片作为核心器件并对功能进行了验证。
上传时间： 2015-01-01
上传用户：shizhanincc
MIG生成的DDR2相关的代码
上传时间： 2013-10-12
上传用户：z1191176801
收文单位：左列各单位 发文字号： MT-8-2-0037
上传时间： 2013-10-28
上传用户：ming529
基于FPGA、PCI9054、SDRAM和DDS设计了用于某遥测信号模拟源的专用板卡。PCI9054实现与上位机的数据交互,FPGA实现PCI本地接口转换、数据接收发送控制及DDS芯片的配置。通过WDM驱动程序设计及MFC交互界面设计,最终实现了10~200 Mbit·s-1的LVDS数据接收及10~50 Mbit·s-1任意速率的LVDS数据发送。
上传时间： 2013-12-24
上传用户：zhangchu0807
The Virtex-4 features, such as the programmable IDELAY and built-in FIFO support, simplifythe bridging of a high-speed, PCI-X core to large amounts of DDR-SDRAM memory. Onechallenge is meeting the PCI-X target initial latency specification. PCI-X Protocol Addendum tothe PCI Local Bus Specification Revision 2.0a ([Ref 6]) dictates that when a target signals adata transfer, "the target must do so within 16 clocks of the assertion of FRAME#." PCItermination transactions, such as Split Response/Complete, are commonly used to meet thelatency specifications. This method adds complexity to the design, as well as additional systemlatency. Another solution is to increase the ratio of the memory frequency to the PCI-X busfrequency. However, this solution increases the required power and clock resource usage.
上传时间： 2013-11-24
上传用户：18707733937
This application note covers the design considerations of a system using the performance features of the LogiCORE™ IP Advanced eXtensible Interface (AXI) Interconnect core. The design focuses on high system throughput through the AXI Interconnect core with F MAX and area optimizations in certain portions of the design. The design uses five AXI video direct memory access (VDMA) engines to simultaneously move 10 streams (five transmit video streams and five receive video streams), each in 1920 x 1080p format, 60 Hz refresh rate, and up to 32 data bits per pixel. Each VDMA is driven from a video test pattern generator (TPG) with a video timing controller (VTC) block to set up the necessary video timing signals. Data read by each AXI VDMA is sent to a common on-screen display (OSD) core capable of multiplexing or overlaying multiple video streams to a single output video stream. The output of the OSD core drives the DVI video display interface on the board. Performance monitor blocks are added to capture performance data. All 10 video streams moved by the AXI VDMA blocks are buffered through a shared DDR3 SDRAM memory and are controlled by a MicroBlaze™ processor. The reference system is targeted for the Virtex-6 XC6VLX240TFF1156-1 FPGA on the Xilinx® ML605 Rev D evaluation board
上传时间： 2013-11-23
上传用户：shen_dafa
第二部分：DRAM 内存模块的设计技术..............................................................143第一章 SDR 和DDR 内存的比较..........................................................................143第二章 内存模块的叠层设计.............................................................................145第三章 内存模块的时序要求.............................................................................1493.1 无缓冲（Unbuffered）内存模块的时序分析.......................................1493.2 带寄存器（Registered）的内存模块时序分析...................................154第四章 内存模块信号设计.................................................................................1594.1 时钟信号的设计.......................................................................................1594.2 CS 及CKE 信号的设计..............................................................................1624.3 地址和控制线的设计...............................................................................1634.4 数据信号线的设计...................................................................................1664.5 电源，参考电压Vref 及去耦电容.........................................................169第五章 内存模块的功耗计算.............................................................................172第六章 实际设计案例分析.................................................................................178 目前比较流行的内存模块主要是这三种：SDR，DDR，RAMBUS。其中，RAMBUS内存采用阻抗受控制的串行连接技术,在这里我们将不做进一步探讨，本文所总结的内存设计技术就是针对SDRAM 而言(包括SDR 和DDR)。现在我们来简单地比较一下SDR 和DDR，它们都被称为同步动态内存，其核心技术是一样的。只是DDR 在某些功能上进行了改进，所以DDR 有时也被称为SDRAM II。DDR 的全称是Double Data Rate，也就是双倍的数据传输率，但是其时钟频率没有增加，只是在时钟的上升和下降沿都可以用来进行数据的读写操作。对于SDR 来说,市面上常见的模块主要有PC100/PC133/PC166,而相应的DDR内存则为DDR200(PC1600)/DDR266(PC2100)/DDR333(PC2700)。
上传时间： 2013-10-18
上传用户：宋桃子
电机驱动
上传时间： 2013-10-07
上传用户：euroford
上传时间： 2013-11-06
上传用户：windgate
介绍关于内存的内部结构，与内存知识。主要讲解了SDRAM方面
标签： 内存技术
上传时间： 2013-11-20
上传用户：hehuaiyu
