Radio frequency identification (RFID) is gaining in popularity, especially as we find ourselves in this communications age and headed towards a ubiquitous computing world. Automatic identification systems become an important aspect not just in today’s technology but also as part of our daily life. We need RFID in our cars, transportation systems, access points, and even simple transactions; we also acknowledge the need for RFID in our logistics systems, healthcare, and tracking and locating applications.
标签： RFID-Enabled Appications Design Sensor and
上传时间： 2020-06-08
上传用户：shancjb
首先下载软件，解压软件，安装在程序中找到SEGGER,选里面的J-FLASH，进入界面，刚开始的那个界面可以忽略，不用建project也可以；单击菜单栏的“Options---Project settings”打开设置，进行jlink配置;正在General选项，选择“USB”，一般都是默认配置，确认一下即可;然后在CPU选项，选择芯片型号，先选择“Device”才能选择芯片型号，芯片型号，要根据你使用的芯片进行选择;在Target interface选项 里面选择SWD模式;首先Target里面选“Connection”连接目标芯片，然后 Target--Auto进行程序烧写;首先Target里面选择“Connection”连接目标芯片，然后 Target--Auto进行程序烧写.SEGGER J-Links are the most widely used line of debug probes available today. They've proven their value for more than 10 years in embedded development. This popularity stems from the unparalleled performance, extensive feature set, large number of supported CPUs, and compatibility with all popular development environments.
标签： JLINK
上传时间： 2022-03-22
上传用户：
随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
