wireless nodes scrit describing energy utilization
标签： utilization describing wireless energy
上传时间： 2014-01-09
上传用户：671145514
new properties to wsn nodes
标签： properties nodes new wsn
上传时间： 2017-04-24
上传用户：colinal
WSNs being energy constrained systems, one major problem is to employ the sensor nodes in such a manner so as to ensure maximum coverage and connectivity with minimal or optimal number of nodes and furthermore elongate network lifetime with maximum energy utilization. The problem addressed has been tackled for 1-D linear array and further extended to 2-Dimensions as stated in the next slides.
标签： constrained systems problem energy
上传时间： 2017-04-28
上传用户：evil
VLSi KL partitioning Algorithm based programme for 100 nodes. It s dynamic progremme so by changing the MAX value we can change the number of nodes in the network.
标签： partitioning Algorithm programme progremme
上传时间： 2013-12-05
上传用户：wweqas
Selection of target node and reference nodes
标签： Selection reference target nodes
上传时间： 2013-11-25
上传用户：JasonC
program for astar algoritham to find cheapest path between two nodes
标签： algoritham cheapest program between
上传时间： 2017-06-01
上传用户：虫虫虫虫虫虫
AODV protocol with two nodes (example)
标签： protocol example nodes AODV
上传时间： 2013-12-20
上传用户：xmsmh
its a tcl using to perform different activities over nodes in ns-2.
标签： activities different perform nodes
上传时间： 2017-09-08
上传用户：爺的气质
基于幅移键控技术ASK（Amplitude-Shift Keying），以C8051F340单片机作为监测终端控制器，C8051F330D单片机作为探测节点控制器，采用半双工的通信方式，通过监控终端和探测节点的无线收发电路，实现数据的双向无线传输。收发电路采用直径为0.8 mm的漆包线自行绕制成圆形空心线圈天线，天线直径为（3.4±0.3）cm。试验表明，探测节点与监测终端的通信距离为24 cm，通过桥接方式，节点收发功率为102 mW时，节点间的通信距离可达20 cm。与传统无线收发模块相比，该无线收发电路在受体积、功耗、成本限制的场合有广阔的应用前景。 Abstract: Based on ASK technology and with the C8051F340 and C8051F330D MCU as the controller， using half-duplex communication mode， this paper achieves bi-directional data transfer. Transceiver circuit constituted by enameled wire which diameter is 0.8mm and wound into a diameter （3.4±0.3） cm circular hollow coil antenna. Tests show that the communication distance between detection and monitoring of the terminal is 24cm，the distance is up to 20cm between two nodes when using the manner of bridging and the node transceiver power is 102mW. Compared with the conventional wireless transceiver modules， the circuit has wide application prospect in small size， low cost and low power consumption and other characteristics.
上传时间： 2013-10-19
上传用户：xz85592677
The PCA82C250 and PCA82C251 are advanced transceiver products for use in automotive and general industrialapplications with transfer rates up to 1 Mbit/s. They support the differential bus signal representation beingdescribed in the international standard for in-vehicle CAN high-speed applications (ISO 11898). Controller AreaNetwork (CAN) is a serial bus protocol being primarily intended for transmission of control related data between anumber of bus nodes.
上传时间： 2013-11-24
上传用户：Alick
