The PW2302A uses advanced trench technology to provide excellent RDS(ON), low gate charge andoperation with gate voltages as low as 2.5V. This device is suitable for use as a Battery protection orin other Switching application
标签： pw2302a
上传时间： 2022-02-11
上传用户：
The PW2300S3 uses advanced trench technology to provide excellent RDS(ON), low gate charge andoperation with gate voltages as low as 2.5V. This device is suitable for use as a Battery protection orin other Switching application
标签： pw2300s3
上传时间： 2022-02-11
上传用户：canderile
PW2205 develops a high efficiency synchronous step-down DC-DC converter capable of delivering5A output current. PW2205 operates over a wide input voltage range from 4.5V to 30V andintegrates main switch and synchronous switch with very low RDS(ON) to minimize the conductionloss.PW2205 adopts the instant PWM architecture to achieve fast transient responses for high step downapplications and high efficiency at light loads. In addition, it operates at pseudo-constant frequencyof 500kHz under continuous conduction mode to minimize the size of inductor and capacitor
标签： pw2205
上传时间： 2022-02-11
上传用户：
The PW2163 is a high efficiency 500 kHz synchronous step-down DC-DC converter capable ofdelivering 3A current. The PW2163 operates over a wide input voltage range from 4.5V to 18V andintegrates main switch and synchronous switch with very low RDS(ON) to minimize the conductionloss. Low output voltage ripple and small external inductor and capacitor sizes are achieved with 500kHz switching frequency. It adopts the instant PWM architecture to achieve fast transient responsesfor high step down applications
标签： pw2163
上传时间： 2022-02-11
上传用户：
The PW2053 is a high-efficiency monolithic synchronous buck regulator using a constantfrequency, current mode architecture. The device is available in an adjustable version. Supply currentwith no load is 40uA and drops to <1uA in shutdown. The 2.5V to 5.5V input voltage range makesthe PW2053 ideally suited for single Li-Ion battery powered applications. 100% duty cycle provideslow dropout operation, extending battery life in portable systems. PWM/PFM mode operationprovides very low output ripple voltage for noise sensitive applications. Switching frequency isinternally set at 1.2MHz, allowing the use of small surface mount inductors and capacitors. Lowoutput voltages are easily supported with the 0.6V feedback reference voltage
标签： pw2053
上传时间： 2022-02-14
上传用户：jason_vip1
PW1555 is a programmable current limit switch with input voltage range selection and outputvoltage clamping. Extremely low RDS(ON) of the integrated protection N-channel FET helps toreduce power loss during the normal operation. Programmable soft-start time controls the slew rateof the output voltage during the start-up time. Independent enable control allows the complicatedsystem sequencing control. It integrates the over-temperature protection shutdown andautorecovery with hystersis
标签： pw1555
上传时间： 2022-02-14
上传用户：
The PW8205A6S uses advanced trench technology to provide excellent RDS(ON), low gate chargeand operation with gate voltages as low as 2.5V. This device is suitable for use as a Battery protectionor in other Switching application.
标签： 8205a6
上传时间： 2022-02-14
上传用户：
基于FPGA设计的相关论文资料大全 84篇用FPGA实现FFT的研究 刘朝晖 韩月秋 摘 要 目的 针对高速数字信号处理的要求，给出了用现场可编程门阵列(FPGA)实现的 快速傅里叶变换(FFT)方案.方法 算法为按时间抽取的基4算法，采用递归结构的块浮点运 算方案，蝶算过程只扩展两个符号位以适应雷达信号处理的特点，乘法器由阵列乘法器实 现.结果 采用流水方式保证系统的速度，使取数据、计算旋转因子、复乘、DFT等操作协 调一致，在计算、通信和存储间取得平衡，避免了瓶颈的出现.结论 实验表明，用FPGA 实现高速数字信号处理的算法是一个可行的方案. 关键词 离散傅里叶变换； 快速傅里叶变换； 块浮点运算； 可编程门阵列 分类号 TP39； TN957.511 Implementation of FFT with FPGA Technology Liu Zhaohui Han Yueqiu (Department of Electronics Engineering, Beijing Institute of Technology, Beijing 100081) Abstract Aim To propose a scheme for implementing FFT with FPGA in accor-dance with the requirement for high speed digital signal processing. Methods The structure of FPGA and requirement of system were considered in the experiment, radix-4 algorithm of DIT and recursive structure were adopted. The group float point arithmetic operation was used in the butterfly and the array multiplier was used to realize multiplication. Results The pipeline pattern was used to ensure the system speed, it made fetching data, calculating twiddle factor, complex multiplication and D
标签： fpga
上传时间： 2022-03-23
上传用户：
对某四轮独立驱动电动汽车轮毂电机进行研究,设计一种永磁无刷直流电机控制器.以STM32F103RBT6芯片为基础,对电机驱动电路、采样电路和保护电路分别进行硬件设计与分析;同时,采用模块化软件设计方案,对该控制器的软件系统进行升级.实验验证表明:所设计的电机控制器能使电机响应迅速、转速稳定、无超调,且电动车动力输出性能良好.A permanent magnet brushless direct current motor controller was designed by studying the hub motor of a four-wheel independent drive electric vehicle.Based on STM32 F103RBT6 chip,the hardware design and analysis of motor drive circuit,sampling circuit and protection circuit were carried out respectively.At the same time,modular software design scheme was adopted to upgrade the software system of the controller.Experimental results show that the designed motor controller can ensure the motor fast response,stable speed,no overshoot,and good power output performances.
上传时间： 2022-03-26
上传用户：qingfengchizhu
随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
