CC386 is a general-purpose 32-bit C compiler. It is not an optimizing compiler but given that the code generation is fairly good. There are two versions one is for MSDOS/DPMI and one is for Win32. The Win32 version has a full-blown IDE capable of editing, building, and debugging windows programs included with it. However at this time debugging support for MSDOS is rudimentary at best and there is no IDE for DOS. the newest version, support windows.
标签： compiler general-purpose optimizing given
上传时间： 2015-04-12
上传用户：gtzj
这是一个，51单片机的脉冲采集器的程序，可以用KEIL C环境下编译，也可以使用WAVE软件，运行非常稳定
标签：
上传时间： 2013-12-11
上传用户：dongqiangqiang
用LPC213X系列的PWM来产生语音。语音数据来源于PC机转换后得到的。最大可以是16位的。 由于是PWM所以输出端口需要低通滤波才能够得到比较干净的声音。 可以经过修改使用LPC2132以上的ARM的D/A来产生。 This project outputs audio on PWM0 using wave samples that are stored in the on-chip Flash ROM.
上传时间： 2014-11-07
上传用户：zhanditian
The following Philips LPC2k CAN examples in this directory were provided by ESAcademy. LPC2_CANAll_V110: Receives all CAN messages in a receive queue. LPC2_CANFull_V110: Uses Full-CAN-like reception filtering. LPC2_CANBlinky_V130: Minimal example of MicroCANopen, uses Full-CAN-like reception filtering and implements both Rx and Tx Interrupt Service Routines.
标签： ESAcademy following directory examples
上传时间： 2015-04-25
上传用户：hasan2015
The following Philips LPC2k CAN examples in this directory were provided by ESAcademy. LPC2_CANAll_V110: Receives all CAN messages in a receive queue. LPC2_CANFull_V110: Uses Full-CAN-like reception filtering. LPC2_CANBlinky_V130: Minimal example of MicroCANopen, uses Full-CAN-like reception filtering and implements both Rx and Tx Interrupt Service Routines.
标签： ESAcademy following directory examples
上传时间： 2013-12-13
上传用户：牛津鞋
The following Philips LPC2k CAN examples in this directory were provided by ESAcademy. LPC2_CANAll_V110: Receives all CAN messages in a receive queue. LPC2_CANFull_V110: Uses Full-CAN-like reception filtering. LPC2_CANBlinky_V130: Minimal example of MicroCANopen, uses Full-CAN-like reception filtering and implements both Rx and Tx Interrupt Service Routines.
标签： ESAcademy following directory examples
上传时间： 2014-01-06
上传用户：zukfu
He was the first one (I noticed of) who coded a decrypter for yC 1.2 :)...good job. Also if it hasn t full support yet >:-) So as I promised...here s the source code. I hope it helps someone.
标签： decrypter noticed first coded
上传时间： 2015-05-03
上传用户：498732662
并口的EPP协议，与外部的FIFO的empty,full信号共同控制数据传输
上传时间： 2014-01-12
上传用户：xiaoyunyun
This example program shows how to configure and use the A/D Converter of the following microcontroller: STMicroelectronics ST10F166 After configuring the A/D, the program reads the A/D result and outputs the converted value using the serial port. To run this program... Build the project (Project Menu, Build Target) Start the debugger (Debug Menu, Start/Stop Debug Session) View the Serial Window (View Menu, Serial Window #1) View the A/D converter peripheral (Peripheral Menu, A/D Converter) Run the program (Debug Menu, Go) A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change. Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µ Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals graphically.
标签： microcontroll Converter configure following
上传时间： 2014-12-01
上传用户：独孤求源
光纤测试程序，在wave环境下仿真，已经过测试。
上传时间： 2015-05-13
上传用户：yyq123456789
