Cypress Semiconductor makes a variety of PLL-based clock generators. This application note provides a set of recommendations to optimize usage of Cypress clock devices in a system. The application note begins with recommended termination techniques for clock generators. Subsequently, power supply filtering and bypassing is discussed. Finally, the application note provides some recommendations on board layout.
标签： Semiconductor application generators PLL-based
上传时间： 2013-12-20
上传用户：水中浮云
AN FPGA-BASED IMPLEMENTATION FOR MEDIAN FILTER MEETING THE REAL-TIME REQUIREMENTS OF AUTOMATED VISUAL INSPECTION SYSTEMS
标签： IMPLEMENTATION REQUIREMENTS FPGA-BASED AUTOMATED
上传时间： 2013-12-13
上传用户：litianchu
本分布式小区智能网络模型采用符合现场总线(Fieldbus)要求 的CAN技术，以带CAN总线端口的主控机和单元控制器CAN端接口构成的 CAN网络层，下层为由带RS485端口的住户采集器和单元控制器RS485端 接口构成了RS485网络层，向上则利用PC机连接CAN网络层，作为智能 化小区管理中心，从而基本实现智能小区管理、控制、报警、信息采 集和自我检测的功能。 本文从智能小区、现场总线、CAN技术到“CAN+RS485”双底层网 络模型的软、硬件研究，较为详细的介绍了其设计、调试运行和期间 各种问题的解决。
上传时间： 2015-12-05
上传用户：Altman
Fractal Explorer GUI-based program for exploring and studying the most common form of fractals, chaotic systems and fractional dimension systems
标签： GUI-based exploring Explorer fractals
上传时间： 2013-11-25
上传用户：ljmwh2000
Generates Rayleigh fading processes based on autoregressive models.
标签： autoregressive Generates processes Rayleigh
上传时间： 2015-12-06
上传用户：无聊来刷下
The development of a data acquisition card based on USB bus is introduced in this article.It first describes the configuration and principle of this card in the part of hardware design,and then the application program and device driver in the part of software design.Data acquisition program in firmware is also discussed.Finally,this data acquisition card is tested and evaluated in a program developed by Lab Windows CVI,which shows that this car is stable and reliable
标签： development acquisition introduced article
上传时间： 2015-12-07
上传用户：lijianyu172
IPCAM Design document based on TI DaVinci
标签： document DaVinci Design IPCAM
上传时间： 2013-12-26
上传用户：songrui
In a preemptive priority based RTOS, priority inversion problem is among the major sources of deadline violations. Priority inheritance protocol is one of the approaches to reduce priority inversion. Unfortunately, RTOS like uC/OS can’t support priority inheritance protocol since it does not allow kernel to have multiple tasks at the same priority. Although it has different ways to avoid priority inversion such as priority ceiling protocol, developers still have some difficulties in programming real time applications with it. In this paper, we redesign the uC/OS kernel to provide the ability to support round robin scheduling and implement priority inheritance semaphore on the modified kernel. As result, we port new kernel with priority inheritance semaphore to evaluation board, and evaluate the execution time of each of the kernel service as well as verify the operations of our implementation.
标签： priority preemptive inversion problem
上传时间： 2015-12-14
上传用户：气温达上千万的
基于DDS的信号发生器的设计与开发 The Design and Development of Function Generator Based on DDS
标签： Development DDS Generator Function
上传时间： 2014-01-03
上传用户：stewart·
一般使用PC Based Controller 都是当作现场设备的一种，也就是要接受 主系统的命令，做一些操作控制。以Modbus 来看属于Slave 的角色，随 时等待接收Modbus Master 的Query Message，然后依据内容做控制，最后 将控制结果以Response Message 回传。本章将以ICP 7524 及ICP 7188E5 等 两种设备分别设计Modbus RTU、ASCII 及Modbus/TCP 的Slave 应用程序， 读者可以将此两种程序的架构再延伸设计至各种实际应用程序。
标签： Controller Based 现场设备
上传时间： 2015-12-16
上传用户：nanxia
