英文版的,详细讲解jsr184的开发,有demo,虽然是英文版但也比较易懂,是我转3D java时看的第一篇文章,得益十分多,建议初学者看看.
上传时间： 2015-11-28
上传用户：chenbhdt
非线性生成学习模型源码 MATLAB有DEMO，通俗易懂，移植性较好
上传时间： 2015-11-30
上传用户：古谷仁美
This user’s manual describes SAMSUNG s S3C2440A 16/32-bit RISC microprocessor. SAMSUNG’s S3C2440A is designed to provide hand-held devices and general applications with low-power, and high-performance microcontroller solution in small die size. To reduce total system cost, the S3C2440A includes the following components.
标签： S3C2440A SAMSUNG microprocessor describes
上传时间： 2013-12-19
上传用户：nanxia
This user’s manual describes SAMSUNG s S3C2440A 16/32-bit RISC microprocessor. SAMSUNG’s S3C2440A is designed to provide hand-held devices and general applications with low-power, and high-performance microcontroller solution in small die size. To reduce total system cost, the S3C2440A includes the following components.
标签： S3C2440A SAMSUNG microprocessor describes
上传时间： 2013-12-25
上传用户：weixiao99
SAMSUNG’s S3C2440A is designed to provide hand-held devices and general applications with low-power, and high-performance microcontroller solution in small die size. To reduce total system cost, the S3C2440A includes the following components.
标签： applications hand-held low-power S3C2440A
上传时间： 2013-12-18
上传用户：zhenyushaw
This a simple bootloader for AT91SAM7{S,X}{64,128,256} processors. It permits you to download new code to the device over USB. This bootrom is installed at address 0x00000000 in the ARM, which means that it is the first piece of code to execute after reset. At startup, it waits for a few seconds to see if the downloader is trying to connect. If not, then the bootloader gives up control and jumps to your program. If the downloader is trying to connect, then the bootloader receives the new program over USB and writes it into flash.
标签： bootloader processors download permits
上传时间： 2015-11-30
上传用户：shus521
bp network,you can s
上传时间： 2015-12-01
上传用户：阳光少年2016
ANSI/ISO C++ Professional Programmer s Handbook
标签： Professional Programmer Handbook ANSI
上传时间： 2015-12-01
上传用户：liansi
Hey. This some pid code for the atmega88 that I once used to control a heater. It s purpose is pretty specific, and I only wrote it to work on the mega88, so the code itself won t be too useful. It is a good place to start if you re trying to use or figure out pid though.
标签： control purpose atmega heater
上传时间： 2013-12-19
上传用户：天诚24
Audio demo，开发于J2ME， 可以在支持MIDP2.0 and CLDC 1.1 的手机或其他移动设备上使用。
上传时间： 2015-12-02
上传用户：zhangzhenyu
