The Tri-Mode Ethernet MAC (TEMAC) UltraController-II Module is a minimal footprint,embedded network processing engine based on the PowerPC™ 405 (PPC405) processor coreand the TEMAC core embedded within a Virtex™-4 FX Platform FPGA. The TEMACUltraController-II Module connects to an external PHY through Gigabit Media IndependentInterface (GMII) and Management Data Input/Output (MDIO) interfaces and supports tri-mode(10/100/1000 Mb/s) Ethernet. Software running from the processor cache reads and writesthrough an On-Chip Memory (OCM) interface to two FIFOs that act as buffers between thedifferent clock domains of the PPC405 OCM and the TEMAC.
上传时间： 2013-10-26
上传用户：yuzsu
zigbee Module ,arm cortex m3 ,soc
上传时间： 2013-10-13
上传用户：hsfei8
LVDS和TTL板的接口定义及连接原理图： TTL板与LVDS 相同 一、接口定义： １、 LCD Module与驱动板之间的信号线接口定义如下：VDS接口又称RS-644总线接口，是20世纪90年代才出现的一种数据传输和接口技术。LVDS即低电压差分信号，这种技术的核心是采用极低的电压摆幅高速差动传输数据，可以实现点对点或一点对多点的连接，具有低功耗、低误码率、低串扰和低辐射等特点，其传输介质可以是铜质的PCB连线，也可以是平衡电缆。LVDS在对信号完整性、低抖动及共模特性要求较高的系统中得到了越来越广泛的应用。目前，流行的LVDS技术规范有两个标准：一个是TIA/EIA（电讯工业联盟/电子工业联盟）的ANSI/TIA/EIA－644标准，另一个是IEEE 1596.3标准。
上传时间： 2013-10-14
上传用户：wangchong
A Computer-On-Module, or COM, is a Module with all components necessary for a bootable host computer, packaged as a super component. A COM requires a Carrier Board to bring out I/O and to power up. COMs are used to build single board computer solutions and offer OEMs fast time-to-market with reduced development cost. Like integrated circuits, they provide OEMs with significant freedom in meeting form-fit-function requirements. For all these reasons the COM methodology has gained much popularity with OEMs in the embedded industry. COM Express® is an open industry standard for Computer-On-Modules. It is designed to be future proof and to provide a smooth transition path from legacy parallel interfaces to LVDS (Low Voltage Differential Signaling) interfaces. These include the PCI bus and parallel ATA on the one hand and PCI Express and Serial ATA on the other hand.
上传时间： 2013-11-05
上传用户：Wwill
STM8S105xx_中文资料：这本数据手册描述了STM8S105xx基础型系列单片机的特点、引脚分配、电气特性、机械特性和订购信息。 如果需要关于STM8S单片机存储器、寄存器和外设等的详细信息，请参考STM8S系列单片机参考手册(RM0016) 。 如果需要关于内部Flash存储器的编程、擦除和保护的信息，请参考STM8S闪存编程手册(PM0051) 。 如果需要关于调试和SWIM(single wire interface Module单线接口模块)，请参考STM8SWIM 通信协议和调试模块用户手册(UM0470) 。 如果需要关于STM8 内核的信息，请参考STM8 CPU编程手册(PM0044) 。
上传时间： 2013-11-03
上传用户：JasonC
LVDS、xECL、CML（低电压差分信号传输、发射级耦合逻辑、电流模式逻辑）………4多点式低电压差分信号传输(M-LVDS) ……………………………………………………8数字隔离器 ………………………………………………………………………………10RS-485/422 …………………………………………………………………………………11RS-232………………………………………………………………………………………13UART（通用异步收发机）…………………………………………………………………16CAN（控制器局域网）……………………………………………………………………18FlatLinkTM 3G ………………………………………………………………………………19SerDes（串行G 比特收发机及LVDS）……………………………………………………20DVI（数字视频接口）/PanelBusTM ………………………………………………………22TMDS（最小化传输差分信号） …………………………………………………………24USB 集线器控制器及外设器件 …………………………………………………………25USB 接口保护 ……………………………………………………………………………26USB 电源管理 ……………………………………………………………………………27PCI Express® ………………………………………………………………………………29PCI 桥接器 …………………………………………………………………………………33卡总线 (CardBus) 电源开关 ………………………………………………………………341394 (FireWire®, 火线®) ……………………………………………………………………36GTLP (Gunning Transceiver Logic Plus，体效应收发机逻辑+) ………………………………39VME（Versa Module Eurocard）总线 ………………………………………………………41时钟分配电路 ……………………………………………………………………………42交叉参考指南 ……………………………………………………………………………43器件索引 …………………………………………………………………………………47技术支持 …………………………………………………………………………………48 德州仪器（TI）为您提供了完备的接口解决方案，使得您的产品别具一格，并加速了产品面市。凭借着在高速、复合信号电路、系统级芯片 (system-on-a-chip ) 集成以及先进的产品开发工艺方面的技术专长，我们将能为您提供硅芯片、支持工具、软件和技术文档，使您能够按时的完成并将最佳的产品推向市场，同时占据一个具有竞争力的价格。本选择指南为您提供与下列器件系列有关的设计考虑因素、技术概述、产品组合图示、参数表以及资源信息：
上传时间： 2013-10-21
上传用户：Jerry_Chow
433MHZ无线射频模块方案。另外有315MHZ 470MHZ 2.4GHZ方案资料 更多资料联系董工18610108650 电话联系的免费送
上传时间： 2013-10-31
上传用户：穿着衣服的大卫
在研究传统家用燃气报警器的基础上，以ZigBee协议为平台，构建mesh网状网络实现网络化的智能语音报警系统。由于传感器本身的温度和实际环境温度的影响，传感器标定后采用软件补偿方法。为了减少系统费用，前端节点采用半功能节点设备，路由器和协调器采用全功能节点设备，构建mesh网络所形成的家庭内部报警系统，通过通用的电话接口连接到外部的公用电话网络，启动语音模块进行报警。实验结果表明，在2.4 GHz频率下传输，有墙等障碍物的情况下，节点的传输距离大约为35 m，能够满足家庭需要，且系统工作稳定，但在功耗方面仍需进一步改善。 Abstract: On the basis of studying traditional household gas alarm system, this paper proposed the platform for the ZigBee protocol，and constructed mesh network to achieve network-based intelligent voice alarm system. Because of the sensor temperature and the actual environment temperature, this system design used software compensation after calibrating sensor. In order to reduce system cost, semi-functional node devices were used as front-end node, however, full-function devices were used as routers and coordinator，constructed alarm system within the family by building mesh network，connected to the external public telephone network through the common telephone interface, started the voice alarm Module. The results indicate that nodes transmit about 35m in the distance in case of walls and other obstacles by 2.4GHz frequency transmission, this is able to meet family needs and work steadily, but still needs further improvement in power consumption.
上传时间： 2013-10-30
上传用户：swaylong
通过比较各种隔离数字通信的特点和应用范围，指出塑料光纤在隔离数字通信中的优势。使用已经标准化的TOSLINK接口，有利于节省硬件开发成本和简化设计难度。给出了塑料光纤的硬件驱动电路，说明设计过程中的注意事项，对光收发模块的电压特性和频率特性进行全面试验，并给出SPI口使用塑料光纤隔离通信的典型应用电路图。试验结果表明，该设计可为电力现场、电力电子及仪器仪表的设计提供参考。 Abstract: y comparing characteristics and applications area of various isolated digital communications， this article indicates advantages of plastic optical fiber in isolated digital communications. Using the standardized TOSLINK interface， it helps to control costs and difficulty in hardware development and design. Then it gives the hardware driver circuit of plastic optical fiber Module， explains the noticed details in design process， gives results on the basis of the optical transceiver Module voltage characteristics and frequency characteristics tests. Finally，it gives typical application circuit of the SPI communication port by using plastic optical fiber isolation .The results show that this design can be referenced for the power field， power electronics and instrumentation design.
上传时间： 2014-01-10
上传用户：gundan
提出了一种以ARM微处理器为控制核心的远程无线视频监控终端的设计方案，其监控终端的硬件设计包括视频采集处理、中央管理控制、无线传输3个模块。并给出了监控终端的软件开发平台和开发模式的系统启动代码、嵌入式Linux系统移植以及驱动程序和应用程序。测试结果表明，该监控终端设计方案合理、有效，基本满足监控需求。 Abstract: A remote wireless video monitoring terminal design， which uses ARM microprocessor as its core control， is proposed in this paper.The hardware design of monitoring terminal system is composed of the video acquisition and processing Module， the central management and control Module， wireless transmission Module.Meanwhile the monitoring terminal-s software development platform and development patterns are designed. Also the design of the system-s start codes， embedded Linux system-s transplantation process， driver and the corresponding applications are given. The results showed that the monitoring terminal design is reasonable， effective， basically meet monitoring requirements.
上传时间： 2013-11-13
上传用户：wanqunsheng
