Digital Down Converter Design based on FPGA.
标签： Converter Digital Design based
上传时间： 2013-08-13
上传用户：CSUSheep
fpga based jpge 压缩算法，性能不错，
上传时间： 2013-08-14
上传用户：a471778
FPGA-based link layer chip S19202 configuration
标签： configuration FPGA-based S19202 layer
上传时间： 2013-08-18
上传用户：xsnjzljj
Run Pac-man Game Based on 8086/8088 FPGA IP Core
上传时间： 2013-08-23
上传用户：JamesB
一篇关于CORDIC的文章A survey of CORDIC algorithms for FPGA based computers
标签： CORDIC algorithms computers survey
上传时间： 2013-08-31
上传用户：lliuhhui
something useful for communication,source code based on FPGA
标签： communication something useful source
上传时间： 2013-08-31
上传用户：maizezhen
On the design of an FPGA-Based OFDM modulator for IEEE 802.11a
标签： FPGA-Based modulator 802.11 design
上传时间： 2013-09-02
上传用户：zjwangyichao
在汽车发动机起动时，若发动机起动后起动机不能及时断电，将会烧毁起动机或损坏飞轮齿环；若变速器不在空档位置起动，则起动机的瞬间动力将使汽车位移，还可能引起交通事故和人身安全。为此介绍一种利用NXP P89LPC901单片机控制的汽车起动保护控制器，通过检测汽车起动开关、变速箱档位、发动机转速，实现对汽车发动机起动过程检测和保护。起动保护控制器在发动机起动过程中通过采用逐个关闭打开负载系统，解决汽车发动机过程中因起动电流大而对汽车电源的冲击影响,延长了电瓶寿命。 Abstract: When the automotive engine is started, the engine start motor and flywheel gear may be damaged， even traffic accidents and personal safeties may be caused by wrong operation or other factors.In order to ensure the automotive engine can be started normally and safely,it is necessary that the protecting measures and methods are considered in the automotive electrical control system.This paper introduces a kind of the automotive engine starting protect controller based on NXP P89LPC901 MCU.The controller can protect the engine starting process by detecting the starter key switch,transmission stall and engine speed.Through the use of close and open load system,the controller can solve the impact on automotive power because of the high-current load in the process of the automobile engine starting, and extend battery life.
上传时间： 2013-10-15
上传用户：mikesering
The C500 microcontroller family usually provides only one on-chip synchronous serialchannel (SSC). If a second SSC is required, an emulation of the missing interface mayhelp to avoid an external hardware solution with additional electronic components.The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using optimized SW routines with a performance up to 25KBaud in Slave Mode with half duplex transmission and an overhead less than 60% atSAB C513 with 12 MHz. Due to the implementation in C this performance is not the limitof the chip. A pure implementation in assembler will result in a strong reduction of theCPU load and therefore increase the maximum speed of the interface. In addition,microcontrollers like the SAB C505 will speed up the interface by a factor of two becauseof an optimized architecture compared with the SAB C513.Moreover, this solution lays stress on using as few on-chip hardware resources aspossible. A more excessive consumption of those resources will result in a highermaximum speed of the emulated interface.Due to the restricted performance of an 8 bit microcontroller a pin compatible solution isprovided only; the internal register based programming interface is replaced by a set ofsubroutine calls.The attached source files also contain a test shell, which demonstrates how to exchangeinformation between an on-chip HW-SSC and the emulated SW-SSC via 5 external wiresin different operation modes. It is based on the SAB C513 (Siemens 8 bit microcontroller).A table with load measurements is presented to give an indication for the fraction of CPUperformance required by software for emulating the SSC.
标签： synchronous Emulating serial
上传时间： 2014-01-31
上传用户：z1191176801
TheTool is highy customizable map editor(based on QT) which can be extended via LUA scripts. A first implentation is ready and can be published to the public. The editor is the perfect tool who wants to design some 3d games but don t have time to write
标签： customizable extended TheTool scripts
上传时间： 2013-12-12
上传用户：lanwei
