搜索结果
找到约 7 项符合
JUMPER 的查询结果
DSP编程 lf2407 ADC源码TMS320C24x Evaluation Board Jumper Settings for all programs in this directory.
lf2407 ADC源码TMS320C24x Evaluation Board Jumper Settings for all programs in this
directory.
微处理器开发 Flex chip implementation File: UP2FLEX JTAG jumper settings: down, down, up, up Input: Reset -
Flex chip implementation
File: UP2FLEX
JTAG jumper settings: down, down, up, up
Input:
Reset - FLEX_PB1
Input n - FLEX_SW switches 1 to 8
Output:
Countdown - two 7-segment LEDs.
Done light - decimal point on Digit1.
Operation:
Setup the binary input n number.
Press the Reset switch.
See the count ...
其他书籍 PMAC STD BOTTOM BOARD JUMPER DESCRIPTIONS
PMAC STD BOTTOM BOARD JUMPER DESCRIPTIONS
单片机编程 PCB可测性设计布线规则之建议―从源头改善可测率
P C B 可测性设计布线规则之建议― ― 从源头改善可测率PCB 设计除需考虑功能性与安全性等要求外，亦需考虑可生产与可测试。这里提供可测性设计建议供设计布线工程师参考。1. 每一个铜箔电路支点，至少需要一个可测试点。如无对应的测试点，将可导致与之相关的开短路不可检出，并且与之相连的零件会因无测试点而不可测。2. ...
DSP编程 Welcome to the software files for the ADS8361 to TMS320F2812! There are two project files in each
Welcome to the software files for the ADS8361 to TMS320F2812!
There are two project files in each of the folders McBSP, SPI and Both. Mode II and IV are explored using the McBSP port alone, as well as the SPI port. These projects are located in the SPI and McBSP folders.
Modes I and III are explo ...
驱动编程 16 relay output channels and 16 isolated digital input channels LED indicators to show activated
16 relay output channels and 16 isolated digital input channels
LED indicators to show activated relays
Jumper selectable Form A/Form B-type relay output channel
Output status read-back
Keep relay output values when hot system reset
High-voltage isolation on input channels(2,500 VDC)
Hi ESD pr ...
技术资料 DAC8568驱动程序
This example shows how you can use signal functions in the Visiondebugger to simulate a signal that is coming into one of the analog inputs of the LPC21xx.The Measure example is described in detail in the Getting StartedUser's Guide.The MEASURE  example program is available for several targ ...