Digital cameras have become increasingly popular over the last few years. Digital imagingtechnology has grown to new markets including cellular phones and PDA DEVICES. With thediverse marketplace, a variety of imaging technology must be available. Imaging technologyhas expanded to include both charge-coupled device (CCD) and CMOS image sensors.
标签： CoolRunner-II XAPP CPLD 390
上传时间： 2013-10-16
上传用户：18710733152
Consumer display applications commonly use high-speed LVDS interfaces to transfer videodata. Spread-spectrum clocking can be used to address electromagnetic compatibility (EMC)issues within these consumer DEVICES. This application note uses Spartan®-6 FPGAs togenerate spread-spectrum clocks using the DCM_CLKGEN primitive.
上传时间： 2013-11-01
上传用户：hjkhjk
Xilinx Next Generation 28 nm FPGA Technology Overview Xilinx has chosen 28 nm high-κ metal gate (HKMG) highperformance,low-power process technology and combined it with a new unified ASMBL™ architecture to create a new generation of FPGAs that offer lower power and higher performance. These DEVICES enable unprecedented levels of integration and bandwidth and provide system architects and designers a fully programmable alternative to ASSPs and ASICs.
上传时间： 2013-12-07
上传用户：bruce
SRAM-based FPGAs are non-volatile DEVICES. Upon powerup, They are required to be programmed from an external source. This procedure allows anyone to easily monitor the bit-stream, and clone the device. The problem then becomes how can you effectively protect your intellectual property from others in an architecture where the part is externally programmed?
上传时间： 2013-10-20
上传用户：磊子226
Xilinx is disclosing this user guide, manual, release note, and/or specification (the “Documentation”) to you solely for use in the development of designs to operate with Xilinx hardware DEVICES. You may not reproduce, distribute, republish, download, display, post, or transmit the Documentation in any form or by any means including, but not limited to, electronic, mechanical, photocopying, recording, or otherwise, without the prior written consent of Xilinx. Xilinx expressly disclaims any liability arising out of your use of the Documentation. Xilinx reserves the right, at its sole discretion, to change the Documentation without notice at any time. Xilinx assumes no obligation to correct any errors contained in the Documentation, or to advise you of any corrections or updates. Xilinx expressly disclaims any liability in connection with technical support or assistance that may be provided to you in connection with the Information.
标签： CPLD
上传时间： 2014-12-05
上传用户：qazxsw
The LogiCORE™ GTP Wizard automates the task of creating HDL wrappers to configure the high-speed serial GTP transceivers in Virtex™-5 LXT and SXT DEVICES. The menu-driven interface allows one or more GTP transceivers to be configured using pre-definedtemplates for popular industry standards, or from scratch, to support a wide variety of custom protocols.The Wizard produces a wrapper, an example design, and a testbench for rapid integration and verification of the serial interface with your custom function Features• Creates customized HDL wrappers to configureVirtex-5 RocketIO™ GTP transceivers• Users can configure Virtex-5 GTP transceivers toconform to industry standard protocols usingpredefined templates, or tailor the templates forcustom protocols• Included protocol templates provide support for thefollowing specifications: Aurora, CPRI, FibreChannel 1x, Gigabit Ethernet, HD-SDI, OBSAI,OC3, OC12, OC48, PCI Express® (PCIe®), SATA,SATA II, and XAUI• Automatically configures analog settings• Each custom wrapper includes example design, testbench; and both implementation and simulation scripts
标签： Transceiver Virtex Wizar GTP
上传时间： 2013-10-20
上传用户：dave520l
ref-sdr-sdram-vhdl代码 SDR SDRAM Controller v1.1 readme.txt This readme file for the SDR SDRAM Controller includes information that was not incorporated into the SDR SDRAM Controller White Paper v1.1. The PLL is targeted at APEX(TM) DEVICES. Please regenerate for your chosen architecture. Last updated September, 2002 Copyright ?2002 Altera Corporation. All rights reserved.
上传时间： 2013-10-23
上传用户：半熟1994
This document provides practical, common guidelines for incorporating PCI Express interconnect layouts onto Printed Circuit Boards (PCB) ranging from 4-layer desktop baseboard designs to 10- layer or more server baseboard designs. Guidelines and constraints in this document are intended for use on both baseboard and add-in card PCB designs. This includes interconnects between PCI Express DEVICES located on the same baseboard (chip-to-chip routing) and interconnects between a PCI Express device located “down” on the baseboard and a device located “up” on an add-in card attached through a connector. This document is intended to cover all major components of the physical interconnect including design guidelines for the PCB traces, vias and AC coupling capacitors, as well as add-in card edge-finger and connector considerations. The intent of the guidelines and examples is to help ensure that good high-speed signal design practices are used and that the timing/jitter and loss/attenuation budgets can also be met from end-to-end across the PCI Express interconnect. However, while general physical guidelines and suggestions are given, they may not necessarily guarantee adequate performance of the interconnect for all layouts and implementations. Therefore, designers should consider modeling and simulation of the interconnect in order to ensure compliance to all applicable specifications. The document is composed of two main sections. The first section provides an overview of general topology and interconnect guidelines. The second section concentrates on physical layout constraints where bulleted items at the beginning of a topic highlight important constraints, while the narrative that follows offers additional insight.
上传时间： 2014-01-24
上传用户：s363994250
The power of programmability gives industrial automation designers a highly efficient， cost-effective alternative to traditional motor control units （MCUs）。 The parallel-processing power， fast computational speeds， and connectivity versatility of Xilinx® FPGAs can accelerate the implementation of advanced motor control algorithms such as Field Oriented Control （FOC）。 Additionally， Xilinx DEVICES lower costs with greater on-chip integration of system components and shorten latencies with high-performance digital signal processing （DSP） that can tackle compute-intensive functions such as PID Controller， Clark/Park transforms， and Space Vector PWM. The Xilinx Spartan®-6 FPGA Motor Control Development Kit gives designers an ideal starting point for evaluating time-saving， proven， motor-control reference designs. The kit also shortens the process of developing custom control capabilities， with integrated peripheral functions （Ethernet， PowerLink， and PCI® Express）， a motor-control FPGA mezzanine card （FMC） with built-in Texas Instruments motor drivers and high-precision Delta-Sigma modulators， and prototyping support for evaluating alternative front-end circuitry.
上传时间： 2013-10-28
上传用户：wujijunshi
西门子建筑电器-电气安装技术部发行的各类产品样本：小型断路器、剩余电流保护断路器和模数化产品(中/ 英文)Miniature Circuit-Breakers, Residual Current Operated Circuit-Breakers and Modular DEVICES (Chinese/English)低压熔断器系统(中/ 英文)Fuse System (Chinese/English)雷击，过电压－不再是问题(中文)Thunderstorms - no problem (Chinese)西门子建筑电器目录(中文)Electrical Installation Technology Catalog (Chinese)终端配电保护产品(中文)5 IN 1 (Chinese)SIKUS 和 STAB UNIVERSAL 目录(中文)SIKUS and STAB UNIVERSAL Catalogue (Chinese)SIKUS HC 目录(中文)SIKUS HC Catalogue (Chinese)SentronTM 母线槽 (中文)SentronTM Busway System (Chinese)SentronTM 母线槽系统快速选型 (准备中) (中文)SentronTM Busway System quick selection (in preparing) (Chinese)建筑低压配电一体化解决方案－住宅小区应用(中文)Building LV PD Solution (Chinese)西门子 DELTA vista“远景”系列开关和插座价目表(中文)Delta vista Switch and Socket Pricelist (Chinese)instabus EIB 面向未来的楼宇智能控制系统(中文)instabus EIB (Chinese)instabus EIB 面向未来的楼宇智能控制系统技术手册 (准备中) (中文)instabus EIB technical handbook (in preparing) (Chinese)西门子电气安装技术业绩卓越(中/ 英文)ET Reference Manual (Chinese/English)
上传时间： 2013-11-23
上传用户：瓦力瓦力hong
