搜索结果

A Celsius-Fahrenheit-Kelvin -converter using NetBeans IDE.An application that converts between Celsius, Fahrenheit, and Kelvin degrees. For each unit, there is a text field showing the temperature, and a button that activates the conversion from that unit to the other units. Show 2 decimal places.

Implement the following integer methods: a) Method celsius returns the Celsius equivalent of a Fahrenheit calculation celsius = 5.0 / 9.0 * ( fahrenheit - 32 ) b) Method fahrenheit returns the Fahrenheit equivalent of a Celsius the calculation fahrenheit = 9.0 / 5.0 * celsius + 32 c) Use the metho ...

FEATURES
Unique 1-Wire interface requires only one port pin for communication
Multidrop capability simplifies distributed temperature sensing applications
Requires no external components
Can be powered from data line. Power supply range is 3.0V to 5.5V
Zero standby power required
Measur ...

Abstract: This article discusses application circuits for Maxim force/sense digital-to-analog converters (DACs). Applications include:selectable fixed-gain DAC, programmable gain DAC, photodiode bias control, amperometric sensor control, digitally programmablecurrent source, Kelvin load sensing, t ...

Differential Nonlinearity: Ideally, any two adjacent digitalcodes correspond to output analog voltages that are exactlyone LSB apart. Differential non-linearity is a measure of theworst case deviation from the ideal 1 LSB step. For example,a DAC with a 1.5 LSB output change for a 1 LSB digital codec ...

Digitemp Junior – An RS-232 Port-Powered Digital Thermometer Digitemp Jr. is a device that is designed to measure and report ambient temperature. When connected to an RS-232 port on any PC, it will periodically measure and report in ASCII form the ambient temperature in degrees Celsius ...

Digitemp Jr. is a device that is designed to measure and report ambient temperature. When connected to an RS-232 port on any PC, it will periodically measure and report in ASCII form the ambient temperature in degrees Celsius. These temperature readings can be monitored with any terminal program. If ...

This program demonstrates operation of ADC0 in polled mode. The ADC0 is // configured to use writes to AD0BUSY as its start of conversion source and // to measure the output of the on-chip temperature sensor. The temperature // sensor output is converted to degrees Celsius and is transmitted out UAR ...

This program demonstrates operation of ADC0 in polled mode. The ADC0 is // configured to use writes to AD0BUSY as its start of conversion source and // to measure the output of the on-chip temperature sensor. The temperature // sensor output is converted to degrees Celsius and is transmitted out UAR ...

This program is used to measure the temperature sensor on an F330 device. It uses 1-point calibration and stores the offset value in FLASH memory. The program outputs temperature values in 100ths of a degree Celsius with UART.