AVR单片机控制nokia3510i nokia6100液晶显示屏的库文件及例程
上传时间： 2013-12-22
上传用户：x4587
AVR单片机做的两轮自平衡机器人，这个系统是基于AvrX做的
上传时间： 2013-12-19
上传用户：dragonhaixm
AVR单片机的miRtos及完整演示程序
上传时间： 2013-12-28
上传用户：朗朗乾坤
针对avr单片机编的精确延时程序，可达1微妙
上传时间： 2014-01-13
上传用户：lht618
这是一个pc与avr通过D12进行USB通讯的简单实例，功能就是控制PORTC口.
上传时间： 2015-07-24
上传用户：changeboy
Ship version 1.7--utility to encode, split, and mail binary data and reconstruct the data at the other end (ship will unship).
标签： data reconstruct and the
上传时间： 2015-07-24
上传用户：rocketrevenge
利用AVR单片机实现的慢速USB设备协议
上传时间： 2014-01-18
上传用户：jackgao
avr,单片机开发资料，usb1。1接口资料
上传时间： 2013-12-26
上传用户：BOBOniu
UCOS在AVR单片机上的移植工程,开发环境为ICC.
上传时间： 2013-12-22
上传用户：225588
his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (<=32kHz/4) to be able to program it while it is running on that!
标签： the 20060125 project WinAVR
上传时间： 2014-10-10
上传用户：yan2267246
