虫虫首页|资源下载|资源专辑|精品软件
登录|注册

接入以太网

  • 运营商级的eoc单芯片接入解决方案

    新一代运营商级的EOC单芯片接入解决方案。

    标签: eoc 单芯片 方案

    上传时间: 2014-12-28

    上传用户:qazxsw

  • 串口转以太网IP210T/IP210S

    串口转以太网单晶片解决方案。

    标签: 210 IP 串口转以太网

    上传时间: 2013-11-23

    上传用户:dyctj

  • CDMA通信系统中的接入信道部分进行仿真与分析

    CDMA通信系统中的接入信道部分进行仿真与分析

    标签: CDMA 通信系统 接入信道

    上传时间: 2013-10-07

    上传用户:段璇琮*

  • 宽带无线接入技术

    宽带无线接入技术概述 无线, 宽带, 局域网, 城域网, 广域网 宽带无线接入技术代表了宽带接入技术一种新的发展趋势,不但建网开通快、维护简单、用户较密时成本低,而且改变了本地电信业务的传统观念,最适于新的电信竞争者开展有效的竞争。宽带无线接入技术一般包含无线个人域网(WPAN)、无线局域网(WLAN)、无线城域网(WMAN)、无线广域网(WWAN)四个大类,它们共同组成宽带无线接入的网络架构。

    标签: 宽带无线 接入技术

    上传时间: 2013-10-28

    上传用户:邶刖

  • 基于SOPC的以太网远程数据采集系统设计

    针对测控系统中设备分散,检测环境恶劣的情况,设计了一种基于SOPC的以太网远程数据采集系统。系统采样基于NiosⅡ软核的SOPC架构,以μC/OS-Ⅱ嵌入式实时操作系统为软件运行平台,以LWIP为以太网通信协议,实现了远程数据采集和以太网传输及控制。整个系统在CycloneⅡEP2C35开发板上实现并通过验证,实验结果满足设计要求并具有较好的应用前景。

    标签: SOPC 以太网 远程数据采集 系统设计

    上传时间: 2014-12-29

    上传用户:liansi

  • PM554-T-ETH组态,配置及以太网通讯

    组态,以太网通讯

    标签: T-ETH 554 PM 组态

    上传时间: 2014-03-21

    上传用户:glxcl

  • ACNET以太网CANbus接口卡配置函数库应用手册

    ACNET-600/622为工业级产品,可以工作在-25℃~+75℃的温度范围内。它具有10M/100M自适应以太网接口,CAN口通信最高波特率为1Mbps,完善的支持TCP Server、TCP Client和UDP等多种工作模式,每个CAN口可支持2个TCP连接或多达2×254个UDP“连接”,通过配置软件用户可以灵活的设定相关配置参数。

    标签: CANbus ACNET 以太网 接口卡

    上传时间: 2013-10-20

    上传用户:pzw421125

  • 基于以太网分布式的数据采集控制系统

    针对飞行模拟器座舱数据采集的复杂性,设计了一种基于以太网分布式的数据采集控制系统,该系统是RCM5700微处理器模块上的以太网应用。在系统的基础上具体讨论了PoE技术的应用,在传输数据的网线上同时提供电流,提出并实现了一种包括辅助电源在内的完整可靠的PoE供电方案。设计采用美国国家半导体的LM5073和LM5576并根据不同的负载情况,进行稳定可靠的电压转换,以满足数据采集电路的要求。实验结果表明:该设计稳定可靠,满足低于13 W的采集节点供电要求,提高了模拟器信号采集系统的通用性和标准化程度,避免了以往数据采集节点单独繁琐的电源设计。 Abstract:  Aiming at the complexity of large avion simulation and controlling,the simulator cabin distribute data collecting and control system was designed. This system is the application of RCM5700 on Ethernet. Based on this system,PoE technique that makes Ethernet can also provide power were expounded with emphasis and included FAUX design the PoE resolution was realized. To achieve the requirement of this system,LM5073 and LM5576 were used to DC-DC switch. From the data of experiment,the design filled the requirement of power-need of node whose power was lower than 13W. The application of the technique can advance the degree of simulation data collections currency and standardization and avoid designing additional power system.

    标签: 以太网 分布式 数据采集 控制系统

    上传时间: 2013-11-09

    上传用户:xyipie

  • 基于以太网的虚拟示波器设计

    为提升虚拟仪器传输速率与实时性能,扩展监测范围,在VC的软件平台上设计了一种全功能虚拟示波器。与传统虚拟示波器相比,该系统采用嵌入式系统完成信号采集,采用工业以太网为传输介质,通过线性插值算法和多线程编程思想,实现波形显示、参数计算、频谱分析以及波形存储及回放功能。实验结果表明,该虚拟示波器可以实现20 kHz采样频率下的波形精确显示,达到预期的各项指标。 Abstract:  o enhance the transfer rate and real-time of virtual instrument performance, expand scope of monitoring, this paper uses the VCs software platform to design a fully functional virtual oscilloscope. Compared with traditional virtual oscilloscope, this system adopts the embedded system to complete the data acquisition, industrial Ethernet as the transmission medium used by the linear interpolation algorithm and multi-threaded programming ideas, namely to achieve waveform display, parameter calculation, spectrum analysis and waveform storage and playback. Experimental results show that the virtual oscilloscope can accurately display the waveform with 20kHz sampling frequency, and achieve the desired targets.

    标签: 以太网 虚拟 波器设计

    上传时间: 2013-11-24

    上传用户:wbwyl

  • CAN总线与以太网络互连解决方案

    提出了一种基于双处理器的CAN现场总线与以太网络互连解决方案,详细介绍了该通信接口卡的软硬件设计,实现了生产管理层和智能装置之间基于IEC60870-5-101/104通信规约的数据通信。

    标签: CAN 总线 以太网络 互连

    上传时间: 2014-12-29

    上传用户:PresidentHuang