虫虫首页|资源下载|资源专辑|精品软件
登录|注册

单模光纤

单模光纤(SingleModeFiber):中心玻璃芯很细(芯径一般为9或10μm),只存在一种传输模式的光纤。单模光纤的传输损耗、传输色散都比较小。传输损耗小可以使得信号在光纤中传输的距离更远一些,传输色散小有利于高速大容量的数据的传输,因此在通信系统中,特别是大容量的通信系统中,多数使用单模光纤
  • 光纤传输技术在雷达信号记录重演系统中的应用

    文中分析了光纤传输的优点以及技术实现的可能性,着重阐述了光纤传输系统的结构组成及具体应用,并给出了主要芯片的型号。经验证,该光纤传输技术性能稳定。

    标签: 光纤 传输技术 中的应用 雷达信号

    上传时间: 2013-10-13

    上传用户:1417818867

  • DRZ和MD-RZ码光纤传输性能分析

    介绍了光双二进制归零码DRZ和改进的双二进制归零码MD-RZ 的产生原理和特点,通过光通信仿真软件产生了这两种信号,并给出了光谱图。重点设计了一个40Gb/ s 的单信道光纤传输系统,对两种码型进行了模拟,通过对Q值的结果来分析其非线性容限和传输距离,并与CSRZ 码的传输性能进行对比。

    标签: MD-RZ DRZ 光纤传输 性能分析

    上传时间: 2013-11-04

    上传用户:亚亚娟娟123

  • 基于仿真软件的DPSK光纤传输性能研究

    介绍了DPSK码型的产生原理,通过仿真软件模拟级联调制器产生各种DPSK光调制码型,给出了频谱,并基于仿真软件建立了DPSK光纤传输模型,重点考虑了光放大器的自发辐射(ASE) 噪声对DPSK系统的性能影响。实际仿真结果表明了ASE噪声是限制级联DPSK传输系统传输距离的最主要因素。

    标签: DPSK 仿真软件 光纤传输 性能

    上传时间: 2014-12-30

    上传用户:chongchongsunnan

  • 光纤陀螺受辐照影响机理分析

    采用60 Co 作为辐射源模拟空间辐射环境, 对光纤陀螺及其光电器件进行了大量的试验, 并对光纤陀螺及其光电器件受空间辐射影响的机理进行了研究, 得出光纤陀螺光电器件中保偏光纤环受辐射影响最严 重, 从而重点分析了光纤陀螺敏感器件保偏光纤环的辐射影响机理, 从原理上探讨了保偏光纤环在辐射条件下损耗的增加对光纤陀螺的影响, 为光纤陀螺抗辐射加固技术提供了理论基础。

    标签: 光纤陀螺 辐照 机理分析

    上传时间: 2013-10-08

    上传用户:pei5

  • 基于塑料光纤的高压隔离通信接口设计

     通过比较各种隔离数字通信的特点和应用范围,指出塑料光纤在隔离数字通信中的优势。使用已经标准化的TOSLINK接口,有利于节省硬件开发成本和简化设计难度。给出了塑料光纤的硬件驱动电路,说明设计过程中的注意事项,对光收发模块的电压特性和频率特性进行全面试验,并给出SPI口使用塑料光纤隔离通信的典型应用电路图。试验结果表明,该设计可为电力现场、电力电子及仪器仪表的设计提供参考。 Abstract:  y comparing characteristics and applications area of various isolated digital communications, this article indicates advantages of plastic optical fiber in isolated digital communications. Using the standardized TOSLINK interface, it helps to control costs and difficulty in hardware development and design. Then it gives the hardware driver circuit of plastic optical fiber module, explains the noticed details in design process, gives results on the basis of the optical transceiver module voltage characteristics and frequency characteristics tests. Finally,it gives typical application circuit of the SPI communication port by using plastic optical fiber isolation .The results show that this design can be referenced for the power field, power electronics and instrumentation design.

    标签: 塑料光纤 高压隔离 通信 接口设计

    上传时间: 2014-01-10

    上传用户:gundan

  • 支持PCI Express的4Gbps光纤通道控制器

    PCIe规范,光纤通道控制器

    标签: Express 4Gbps PCI 光纤通道

    上传时间: 2013-10-21

    上传用户:ppeyou

  • 基于FPGA的光纤光栅解调系统的研究

     波长信号的解调是实现光纤光栅传感网络的关键,基于现有的光纤光栅传感器解调方法,提出一种基于FPGA的双匹配光纤光栅解调方法,此系统是一种高速率、高精度、低成本的解调系统,并且通过引入双匹配光栅有效地克服了双值问题同时扩大了检测范围。分析了光纤光栅的测温原理并给出了该方案软硬件设计,综合考虑系统的解调精度和FPGA的处理速度给出了基于拉格朗日的曲线拟合算法。 Abstract:  Sensor is one of the most important application of the fiber grating. Wavelength signal demodulating is the key techniques to carry out fiber grating sensing network, based on several existing methods of fiber grating sensor demodulation inadequate, a two-match fiber grating demodulation method was presented. This system is a high-speed, high precision, low-cost demodulation system. And by introducing a two-match grating effectively overcomes the problem of double value while expands the scope of testing. This paper analyzes the principle of fiber Bragg grating temperature and gives the software and hardware design of the program. Considering the system of demodulation accuracy and processing speed of FPGA,this paper gives the curve fitting algorithm based on Lagrange.

    标签: FPGA 光纤光栅 解调系统

    上传时间: 2013-10-10

    上传用户:zxc23456789

  • 高速信号采集存储及光纤传输系统的设计与实现

    高速信号采集存储与光纤传输系统

    标签: 高速信号 采集 存储 光纤传输系统

    上传时间: 2013-10-13

    上传用户:15501536189

  • 野战光纤光功率精密测量装置研究

    针对野战光纤光路损耗介绍一种精密光功率测量方法,分析了+,-光电接收元件的+%,(光功率%光电流)特性,并建立了实际模型&设计的装置测量范围为%#)!)./(光功率的相对衰减值),经实践检验具有较好 的精度.

    标签: 光纤 光功率 精密测量 装置

    上传时间: 2013-11-20

    上传用户:yy_cn

  • 多路三轴光纤陀螺自动化测试系统设计与实现

    叙述了测试系统的硬件设计思想并给出了完成自动化测试、软件设计方法及组建方案。测试结果表明,该系统能够实现三轴光纤陀螺测试全程自动化,节约了成本,提高了测试效率。

    标签: 多路 光纤陀螺 自动化测试 系统设计

    上传时间: 2013-11-09

    上传用户:blacklee