搜索结果

This program accesses a SPI EEPROM using polled mode access. The F12x MCU is configured in 4-wire Single Master Mode, and the EEPROM is the only slave device connected to the SPI bus. The read/write operations are tailored to access a Microchip 4 kB EEPROM

// This program accesses a SPI EEPROM using polled mode access. The F06x MCU // is configured in 4-wire Single Master Mode, and the EEPROM is the only // slave device connected to the SPI bus. The read/write operations are // tailored to access a Microchip 4 kB EEPROM 25LC320. The relevant hardware ...

// This program accesses a SPI EEPROM using polled mode access. The F06x MCU // is configured in 4-wire Single Master Mode, and the EEPROM is the only // slave device connected to the SPI bus. The read/write operations are // tailored to access a Microchip 4 kB EEPROM 25LC320. The relevant hardware ...

练习并掌握多任务实时操作系统下Task 调度、Task 间主要通信手段（信号量、消息队列等）、RISC 处理器 I/O 端口控制等内容，并形成嵌入式实时应用软件的良好编程习惯。创建多Task，为每个Task 创建私有的Message Queue，每个Task 只通过自己的私有Message Queue 接收消息；Task 间消息通信通过向对方私有MessageQueue 发送 ...

C8051程序， writes text to the serial port of the 8052，用keil编译

This manual describes Freescale’s IEEE&#8482 802.15.4 Standard compliant MAC/PHY software. The Freescale 802.15.4 MAC/PHY software is designed for use with the Freescale MC1319x and MC1320x, family of short range, low power, 2.4 GHz Industrial, Scientific, and Medical (ISM) band transceivers, desig ...

This little Program allows you to send commands to the CardReader (CT-BCS) or to the Card itself. First you will be ask to what Port the Reader is connected (0=COM1, 1=COM2). Then the Class-Byte (CLA), Instruction-Byte (INS), Parameter 1 (P1), Parameter 2 (P2). If wou don愒 want to send Parameter 3 ...

This will sample all 8 A/D-channels by the continous mode. Each end of conversion will call an interrupt routine, where the AD-channel is put to Port4[2..0] and the upper nibble of the result is put to Port4[7..4]. Port 4 is connected to the user LEDs of the FlashCan100P Evaluation-Board

富士通单片机MB902420系列 CAN Project: CAN0 will work as a simple Repeater. Received data will appear at Port P47..P40 (UserLEDs of FlashCan100P) and will send out again as byte-packages to ID#2 Receive-Buffer #1 : basic can Transmit-Buffer #6 : full-can ID #2

The neuro-fuzzy software for identification and data analysis has been implemented in the MATLAB language ver. 4.2. The software trains a fuzzy architecture, inspired to Takagi-Sugeno approach, on the basis of a training set of N (single) output-(multi) input samples. The returned model has the fo ...