fet140_uart11_02400.c

msp430 149 的c程序 模版程序

//******************************************************************************
//  MSP-FET430P140 Demo - USART1 UART 2400 Ultra-low Power Echo ISR, 32kHz ACLK
//
//  Description; Echo a received character, RX ISR used. In the Mainloop UART1
//  is made ready to receive one character with interrupt active. The Mainloop
//  waits in LPM3. The UART1 ISR forces the Mainloop to exit LPM3 after 
//  receiving one character which echo's back the received character.
//  ACLK = UCLK1 = LFXT1 = 32768, MCLK = SMCLK = DCO ~ 800k  
//  Baud rate divider with 32768hz XTAL @2400 = 32768Hz/2400 = 13.65 (000Dh)
//  //*An external watch crystal is required on XIN XOUT for ACLK*//	  
//             
//                MSP430F149
//            -----------------
//        /|\|              XIN|-  
//         | |                 | 32kHz  
//         --|RST          XOUT|-
//           |                 |
//           |             P3.6|-----------> 
//           |                 | 2400 - 8N1
//           |             P3.7|<-----------
//
//       
//  M. Buccini
//  Texas Instruments, Inc
//  February 2002
//  Built with IAR Embedded Workbench Version: 1.25A
//******************************************************************************

#include <msp430x14x.h>

void main(void)
{
  WDTCTL = WDTPW + WDTHOLD;             // Stop WDT
  UCTL1 = CHAR;                         // 8-bit character
  UTCTL1 = SSEL0;                       // UCLK = ACLK
  UBR01 = 0x0D;                         // 32k/2400 - 13.65
  UBR11 = 0x00;                         
  UMCTL1 = 0x6B;                        // Modulation
  ME2 |= UTXE1 + URXE1;                 // Enable USART1 TXD/RXD
  IE2 |= URXIE1;                        // Enable USART1 RX interrupt
  P3SEL |= 0xC0;                        // P3.6,7 = USART1 option select
  P3DIR |= 0x20;                        // P3.6 = output direction
  _EINT();                              // Enable interrupts
  
// Mainloop
  for (;;)                              
  {
  _BIS_SR(LPM3_bits);                   // Enter LPM3
  while ((IFG2 & UTXIFG1) == 0);        // USART1 TX buffer ready?
  TXBUF1 = RXBUF1;                      // RXBUF1 to TXBUF1
  }
}

// UART1 RX ISR will for exit from LPM3 in Mainloop
interrupt[UART1RX_VECTOR] void usart1_rx (void)
{
  _BIC_SR_IRQ(LPM3_bits);               // Clear LPM3 bits from 0(SR)
}