lcd_controller.v

基于SOPC的LCD编码

module LCD_Controller (	//	Host Side
						iDATA,iRS,
						iStart,oDone,
						iCLK,iRST_N,
						//	LCD Interface
						LCD_DATA,
						LCD_RW,
						LCD_EN,
						LCD_RS	);
//	CLK
parameter	CLK_Divide	=	16;

//	Host Side
input	[7:0]	iDATA;
input	iRS,iStart;
input	iCLK,iRST_N;
output	reg		oDone;
//	LCD Interface


output	[7:0]	LCD_DATA;
output	reg		LCD_EN;
output			LCD_RW;				//
output			LCD_RS;
//	Internal Register
reg		[4:0]	Cont;				//frequency division counter  variable   
reg		[1:0]	ST;					//state register
reg		preStart,					//save the pre-state of iStart
		mStart;						//a flag decides whether the state machine execute or not 
									//
/////////////////////////////////////////////
//	Only write to LCD, bypass iRS to LCD_RS
assign	LCD_DATA	=	iDATA; 
assign	LCD_RW		=	1'b0;		
assign	LCD_RS		=	iRS;
/////////////////////////////////////////////

always@(posedge iCLK or negedge iRST_N)	
begin
	if(!iRST_N)//?????? 
	begin
		oDone	<=	1'b0;
		LCD_EN	<=	1'b0;
		preStart<=	1'b0;
		mStart	<=	1'b0;
		Cont	<=	0;
		ST		<=	0;
	end
	else
	begin
		//////	Input Start Detect ///////
		preStart<=	iStart;
		if({preStart,iStart}==2'b01)
		begin
			mStart	<=	1'b1;
			oDone		<=	1'b0;
		end
		//////////////////////////////////
		if(mStart)
		begin
			case(ST)			//state machine for create the signal LCD_EN
			0:	ST	<=	1;	//	Wait Setup
			1:	begin
					LCD_EN	<=	1'b1;
					ST		<=	2;
				end
			2:	begin					
					if(Cont<CLK_Divide)		//	16 frequency division
												//the  Enable pulse width (high level)=230ns
					Cont	<=	Cont+1;
					else
					ST		<=	3;
				end
			3:	begin
					LCD_EN	<=	1'b0;
					mStart	<=	1'b0;
					oDone	<=	1'b1;
					Cont	<=	0;
					ST		<=	0;
				end
			endcase
		end
	end
end

endmodule