ex_touch.c

TI公司的CCS一些常用的函数库

/////////////////////////////////////////////////////////////////////////
////                             EX_TOUCH.C                          ////
////                                                                 ////
////  This program interfaces a Dallas DS1991 touch memory device.   ////
////  It will display the family code and ID of any device that      ////
////  "touch"es pin B0.                                              ////
////                                                                 ////
////  Configure the CCS prototype card as follows:                   ////
////     Connect pin B0 (47) through a 4.7K resistor to 5V (28)      ////
////     Connect the touch device to ground and then "Touch" to B0   ////
////     See additional connections below.                           ////
////                                                                 ////
////  This example will work with the PCB, PCM and PCH compilers.    ////
////  The following conditional compilation lines are used to        ////
////  include a valid device for each compiler.  Change the device,  ////
////  clock and RS232 pins for your hardware if needed.              ////
/////////////////////////////////////////////////////////////////////////
////        (C) Copyright 1996,2003 Custom Computer Services         ////
//// This source code may only be used by licensed users of the CCS  ////
//// C compiler.  This source code may only be distributed to other  ////
//// licensed users of the CCS C compiler.  No other use,            ////
//// reproduction or distribution is permitted without written       ////
//// permission.  Derivative programs created using this software    ////
//// in object code form are not restricted in any way.              ////
/////////////////////////////////////////////////////////////////////////


#if defined(__PCB__)
#include <16c56.h>
#fuses HS,NOWDT,NOPROTECT
#use delay(clock=20000000)
#use rs232(baud=9600, xmit=PIN_A3, rcv=PIN_A2)  // Jumpers: 11 to 17, 12 to 18

#elif defined(__PCM__)
#include <16F877.h>
#fuses HS,NOWDT,NOPROTECT,NOLVP
#use delay(clock=20000000)
#use rs232(baud=9600, xmit=PIN_C6, rcv=PIN_C7)  // Jumpers: 8 to 11, 7 to 12

#elif defined(__PCH__)
#include <18F452.h>
#fuses HS,NOWDT,NOPROTECT,NOLVP
#use delay(clock=20000000)
#use rs232(baud=9600, xmit=PIN_C6, rcv=PIN_C7)  // Jumpers: 8 to 11, 7 to 12
#endif

#include <touch.c>


void main() {
   BYTE buffer[8];
   BYTE i;

   printf("\r\nWaiting for a touch device...\r\n");
   while (TRUE) {
     while(!touch_present()) ;
     delay_ms(200);
     if(touch_present()) {
        touch_write_byte(0x33);
        for(i=0;i<8;++i)
           buffer[i]=touch_read_byte();
        printf("Family: %2X  ID: ",buffer[0]);
        for(i=6;i!=0;--i)
          printf("%2X",buffer[i]);
        printf("\r\n");
        delay_ms(1000);
     }
  }
}