read.me

汇编源代码大全

                                 PLAYMIX

This program demonstrates two main things:
  1.  How to mix two voc files in real time and play them.
  2.  How to control a Sound Blaster using low-level commands.
This program also shows one method of pitch shifting a sound up in frequency,
though there is much room for improvement.  (Other methods to try would be
modifying a Bresenham line drawing algorithm, and possibly additionally
altering the sample rate.)

The executable included with this was compiled in auto-init mode.  If you
re-compile this program without the #define AUTOINIT, the sound playback will
click slightly.  You'll hear a click every time the board finishes playing one
buffer and switches to the other.  It's caused by the lack of sound output
during the time that the DMAC and DSP are being re-programmed.   Most existing
programs do not use auto-init mode.

One thing to keep in mind is that when you combine signals to play them
simultaneously, you lose sound quality.  The reason is that when two signals
are added, you have to divide the results by two to prevent the new signal from
getting too large.  That's the same as cutting the resolution of the original
signals in half before adding them.  If you use a Sound Blaster 16 (16-bit
audio) instead of an older 8-bit sound card, the resolution will be high enough
that it probably won't matter if you do cut the resolution in half.  (But this
program was written for 8-bit sound.)

This program was compiled with this board configuration hard coded into it:
   port address:  220H
   IRQ number:    5
   DMA channel:   1
If your board doesn't match this configuration, change the program and
recompile it.