abstract.txt

来自「基于lm3s6965的SMTP_demo示例代码,对初学者特别有帮助。」· 文本 代码 · 共 40 行

This program is an SMTP Client example. It shows you how to send 
a dynamic email to an email address. This example will configure 
the LAN network parameters for the evaluation board automatically
if a DHCP Server is available in your LAN.

If you do not have a DHCP server, you need to configure
the IP address, net mask and default gateway and Primary DNS
and Secondary DNS Server manually in the Net_Config.c configuration
file. You have to disable also 'Dynamic Host Configuration' under 
the 'Ethernet Network Interface' section.

WARNING!!!

You need to modify SMTP_uif.c user interface module and enter:
 - sender email address,
 - recipient email address 
 - email subject

Modify also the SMTP_demo.c and enter:
 - SMTP server IP address

Sent email will have about 180 kBytes.

The SMTP_demo example is available for several targets:


LM3S6965:       Standalone application for Luminary LM3S6965 Board.
                Program code is loaded into on-chip flash.

LM3S6965 Debug: Standalone Debug application. Debug level configured
                in Net_Debug.c debug configuration file.
                System messages printed to COM# virtual serial port.

                Use HyperTerminal to view output messages and select
                the COM# Windows has assigned to the Virtual COM port on
                the LM3S6965 evaluation board. Set the serial connection 
                to 115200 baud, 8-bits, no parity, 1 stop bit and no flow
                control.