f02x_blinky.asm

芯科原厂所有c8051fxx程序的例子。

$NOMOD51
;-----------------------------------------------------------------------------
;  Copyright (C) 2007 Silicon Laboratories, Inc.
;  All rights reserved.
;
;
;
;  FILE NAME   :  F02x_BLINKY.ASM 
;  TARGET MCU  :  C8051F020 
;  DESCRIPTION :  This program illustrates how to disable the watchdog timer,
;                 configure the Crossbar, configure a port and write to a port
;                 I/O pin.
;
; 	NOTES: 
;
;-----------------------------------------------------------------------------

$include (c8051f020.inc)               ; Include register definition file.

;-----------------------------------------------------------------------------
; EQUATES
;-----------------------------------------------------------------------------

GREEN_LED      equ   P1.6              ; Port I/O pin connected to Green LED.	

;-----------------------------------------------------------------------------
; RESET and INTERRUPT VECTORS
;-----------------------------------------------------------------------------

               ; Reset Vector
               cseg AT 0
               ljmp Main               ; Locate a jump to the start of code at 
                                       ; the reset vector.

;-----------------------------------------------------------------------------
; CODE SEGMENT
;-----------------------------------------------------------------------------


Blink          segment  CODE

               rseg     Blink          ; Switch to this code segment.
               using    0              ; Specify register bank for the following
                                       ; program code.

Main:          ; Disable the WDT. (IRQs not enabled at this point.)
               ; If interrupts were enabled, we would need to explicitly disable
               ; them so that the 2nd move to WDTCN occurs no more than four clock 
               ; cycles after the first move to WDTCN.

               mov   WDTCN, #0DEh
               mov   WDTCN, #0ADh

               ; Enable the Port I/O Crossbar
               mov   XBR2, #40h

               ; Set P1.6 (LED) as digital output in push-pull mode.  
               orl   P1MDIN, #40h	 
               orl   P1MDOUT,#40h 

               ; Initialize LED to OFF
               clr   GREEN_LED

               ; Simple delay loop.
Loop2:         mov   R7, #03h			
Loop1:         mov   R6, #00h
Loop0:         mov   R5, #00h
               djnz  R5, $
               djnz  R6, Loop0
               djnz  R7, Loop1
               cpl   GREEN_LED         ; Toggle LED.
               jmp   Loop2


;-----------------------------------------------------------------------------
; End of file.

END