lpc2xxx_jtagkey.cfg

来自「LPC2294 example code」· CFG 代码 · 共 40 行

#daemon configuration
telnet_port 4444
gdb_port 3333

# tell gdb our flash memory map
# and enable flash programming
gdb_memory_map enable
gdb_flash_program enable

#interface
interface ft2232
ft2232_device_desc "Amontec JTAGkey A"
ft2232_layout jtagkey
ft2232_vid_pid 0x0403 0xcff8
jtag_speed 3

#use combined on interfaces or targets that can't set TRST/SRST separately
reset_config trst_and_srst srst_pulls_trst

#jtag scan chain
#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
jtag_device 4 0x1 0xf 0xe

#target configuration
daemon_startup reset

#target <type> <startup mode>
#target arm7tdmi <reset mode> <chainpos> <endianness> <variant>
target arm7tdmi little run_and_halt 0 arm7tdmi-s_r4
run_and_halt_time 0 30

working_area 0 0x40000000 0x4000 nobackup

#flash configuration
#flash bank lpc2000 <base> <size> 0 0 <target#> <variant>
flash bank lpc2000 0x0 0x40000 0 0 0 lpc2000_v1 14765 calc_checksum

# For more information about the configuration files, take a 
# look at the "Open On-Chip Debugger (openocd)" documentation.