24c512.hpl

schematic interface orange for eeprom programming

; Orange programmer module v2.0
; (c) 1999 Alex Plusov
; CHIP=24C32(4096),24C65(8192,24C128(16384),24C256(32768),24C512(65536)

SOCKET=1 ;"I2C"

PINO=SCL,0
PINO=SDA,1
PINO=WP, 2
PINO=A0, 3
PINO=A1, 4
PINO=A2, 5
PINI=SDA,1

CDELAY=2 ; one cycle time

[INIT]
A0=0,A1=0,A2=0


[READ]
SDA=1,SCL=1,SDA=0,SCL=0               ; start

R0=0xA0
LOOP=(7,0) {SDA=R0[I],SCL=1,SCL=0} ; out 8 bits
SDA=1,SCL=1,SDA?0              ; ack check
SCL=0,SDA=0

LOOP=(15,8) {SDA=ADR[I],SCL=1,SCL=0}  ; out 8 bits adr Hi
SDA=1,SCL=1,SDA?0              ; ack check
SCL=0,SDA=0

LOOP=(7,0)  {SDA=ADR[I],SCL=1,SCL=0} ; out 8 bits adr Lo
SDA=1,SCL=1,SDA?0              ; ack check
SCL=0,SDA=0

SDA=1,SCL=1,SDA=0,SCL=0 ;start
R0=0xA1
LOOP=(7,0) {SDA=R0[I],SCL=1,SCL=0} ; out 8 bits
SDA=1,SCL=1,SDA?0              ; ack check
SCL=0,SDA=1

LOOP=(7,0){SCL=1,DATA[I]=SDA,SCL=0} ;read byte
SDA=1,SCL=1,SCL=0,SDA=0        ;programmer no ack
SDA=0,SCL=1,SDA=1,SCL=0        ;stop


[WRITE]
WP=0
SDA=1,SCL=1,SDA=0,SCL=0 ;start

R0=0xA0
LOOP=(7,0) {SDA=R0[I],SCL=1,SCL=0} ; out 8 bits
SDA=1,SCL=1,SDA?0              ; ack check
SCL=0,SDA=0

LOOP=(15,8) {SDA=ADR[I],SCL=1,SCL=0} ; out 8 bits adr Hi
SDA=1,SCL=1,SDA?0             ; ack check
SCL=0,SDA=0

LOOP=(7,0)   {SDA=ADR[I],SCL=1,SCL=0} ; out 8 bits adr Lo
SDA=1,SCL=1,SDA?0             ; ack check
SCL=0,SDA=0

LOOP=(7,0){SDA=DATA[I],SCL=1,SCL=0}   ; write byte
SDA=1,SCL=1,SDA?0             ; ack check
SCL=0,SDA=0
SCL=0,SCL=1,SDA=1 ;stop
P=5000                        ; write delay